Question about 2012 Toyota Prius Plug-in Base 4dr Hatchback 1.8L 4-cyl. Hybrid CVT Automatic

1 Answer

How to install a radio

Install a BOSS BV9386NV

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Toyota Master
  • 906 Answers

Most auto parts stores can get you a kit for installing just about any radio.

Posted on Dec 30, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I can not find an adaptor for my radio to work with my steering wheel control. How can I hard wire the new radio to the existing SWC without the adaptor ?

mostly likely no, you will need an adapter to send the right signals from radio to steering wheel controls. there mostly universal adapters

Jul 09, 2016 | 2001 Dodge Ram Pickup 1500

1 Answer

Hogar - No sound from Boss Radio after initial installation test.

If you are hooked up to the factory wiring harness i would think there may be a factory amplifier that is not getting power or is bad.

Test the stereo by hooking a speaker up to the speaker out wires from head unit. if it has sound try to find out if there is a factory amplifier.

Good Luck

May 24, 2016 | Cars & Trucks

1 Answer

How do i fix the problem? when i start my car the radio will not turn on. but i can hear the fan running its an aftermarket radio. but if i unplug the radio and plug it back in then the radio works

If you just installed it, I would say the radio is bad. Hooked up right because it does come on. The reason it doesn't come on all the time would be bad solder joints in the radio. When you plug it in, you move the pins, which make contact to the board. After setting they loose contact.

Dec 25, 2015 | 2000 Lincoln LS

1 Answer

Como puedo obtener manual de radio boss BV9962

Request the manual directly from Boss.

Jan 14, 2015 | Cars & Trucks

1 Answer

I installed a Boss Bv9976b in my 1995 Honda accord,have no sound out speakers?

if you are sure the speakers are good and the wiring to the speaker is correct then you need to look at the Boss.. a volt meter on the output either at the speakers or the harness should tell you, as it fluctuates with the volume of the unit, hopefully you do have power to the Boss...

Dec 30, 2014 | Honda Cars & Trucks

1 Answer

How to install a boss bv9982 7 inch single din?

You will need a GM dash kit designed for 2004 Impala (see picture below)...Lower steering...Remove radio...Unplug harness and antenna...Boss wiring matches colors wire for wire in factory plug...Splice one wire at a time to matching color...Plug in antenna...However it is much easier to buy a plug-n-play harness ($25) designed for your vehicle eliminating the need to splice...The Brown wire goes to ground via switch...saailer
4c37a5a7-0e7a-40b3-86da-e0f7039aac1f.jpgCost $15

May 05, 2014 | 2004 Chevrolet Impala

1 Answer

How do I fix the light in the heater control?

The heater control will have to be removed and possibly disassembled to get at the bulb.

1995-98 Models
  1. Disconnect the negative battery cable.
  2. Remove the radio/HVAC controller cover by depressing the center pins inward to release the push pin fasteners. Be careful not to push the center pins all the way through the fasteners.
  3. Remove the push pin fasteners and pull the radio/HVAC controller cover rearward.
  4. If equipped, disengage the traction control/fog lamps/rear defogger electrical connector.
  5. Remove the radio. Refer to the Radio removal and installation procedure, later in this section.
  6. Disengage the electrical connectors behind the controller face. Remove the wiring harness clip from the module boss.
  7. Disengage the temperature and mode cables from the controller assembly by squeezing the lock tabs together while pulling the cable housing straight up. Pull the cables straight up to disengage them from the control lever pins.
  8. Remove the HVAC control panel screws, then carefully pull the panel forward and remove it from the vehicle. To install:
  9. Position the HVAC control panel to the dashboard and install the retaining screws. Tighten the retaining screws to 22 inch lbs. (2.5 Nm).
  10. Install the white temperature and black mode cables over the pins.
  11. Install the cable housings into the clip grooves, then push down to lock them into position.
  12. Reattach the electrical connectors to the back of the control panel face. Install the wiring harness clip to the module boss. Be sure that the wiring harness does not bind with control lever movement.
  13. Install the radio.
  14. If equipped, reattach the traction control/fog lamps/rear defogger electrical connectors.
  15. Install the radio/HVAC controller cover by pushing in at the clip locations.
  16. Install and lock the push pin fasteners.
  17. Connect the negative battery cable.
prev.gif next.gif

Oct 26, 2010 | 1998 Saturn SL

2 Answers

Boss performance chip installation

sometimes the air temp sensor is in the mass air too.

Jul 10, 2009 | 2005 Chevrolet Avalanche

1 Answer


need to get serial number off of radio 1st which is above bar code on label on top of radio (remove from car or remove trim to read) then can obtain, need to know what radio brand also, philips, sanyo or boss

Jun 07, 2009 | 2001 Daewoo Lanos

Not finding what you are looking for?
2012 Toyota Prius Plug-in Base 4dr Hatchback 1.8L 4-cyl. Hybrid CVT Automatic Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides