Question about 1980 Toyota Cressida 2.2

1 Answer

1980 toyota cressida transmission

Trans slipping in reverse. Common problem? any fix besides rebuilding or replacing tranny?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 70 Answers

Assuming fluid is in the hot marks and you have changed it often. reverse failure used to be the first sign that the trans is toast. " reverse is the first to go" was the motto back in the day. is it original trans? what is that 34 years old? its time for a rebuild.... even if its the second rebuild, its time

Posted on Apr 01, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1992 Prado SX Toyota Landcruiser auto transmission rebuild diagram

how do i get my toyota landcruiser prado sx into four wheel drive

Posted on Feb 07, 2009

  • 1 Answer

SOURCE: 1990 Toyota Cressida Engine Swap

what is required to put a 6mge engine in a 1986 cressida?

Posted on Mar 20, 2009

  • 191 Answers

SOURCE: '00 Toyota 4Runner manual transmission slipping out of first gear

The problem is most likely internal. Sounds like it could be the synchronizer or maybe the gear itself. Hard to say until you take it apart and look at it. I guess a price range of around $1000-$1500 to rebuild, repair costs depend on what parts needed, cost of parts, labor/time involved.

Posted on Apr 25, 2009

  • 161 Answers

SOURCE: Overdrive light is flashing and tranny is slipping in drive and 2nd

my overdrive light is flashing due to a shattered speedo cable tip. check your fluid level. you may have to change the tranny filer and redo all the fluid.

Posted on Jun 11, 2009

  • 12 Answers

SOURCE: 88 toyota supra auto trans slips. won't up shift to 2nd gear

yep, sounds like your transmissions on its last leg, mabye you can get by, by starting in 2nd, if you have the option lol, but auto tran's are pretty cheap on ebay or try www.supraforums.com seen one for 300$

Posted on Jul 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont go in to reverse and sometimes wont go in to drive


ewprotest.org: SECOND TRANSMISSION ISSUE

newprotest.org/details.pl?1457
Dec 27, 2009 - This time around, the check-engine light came on, and while driving on the ..... my dodge caravan wont go in reverse and only a few feet forward tranny shot i will go ... I have a 1992 Dodge Grand Caravan 3.3L 4-speed xmission. ..... having shifting issues sometimes shifts fine other times I have to cut van off ...

No Reverse - The Chrysler Minivan Fan Club Forums

forum.chryslerminivan.net/showthread.php/19184-No-Reverse

Nov 21, 2010 - 10 posts - ‎1 author
BTW, I have driven it all summer, over 7k miles with no reverse; I just park up hill or in a drive-thru spot! ... 1992 S-10/4.3L V6/249K mi/original 4L60E ... I had a '90 Grand Caravan w/3.3 and same trans. rebuilt at 120k by AAMCO ... I've decided to drive it until the forward gears go out before I pay for a rebuild ...

10 Most Common Transmission Problems

www.transmissionrepaircostguide.com/10-common-transmission-proble...
Ever notice that while driving that the car hesitates or refuses to go into gear? ... that needs to be replaced, but may sometimes point to a more severe problem. ... If the carwill not shift after engaging the clutch and trying to move the stick, take a .... This is a problem because in park a dodge dose not run the the transmission ...

Transmission May Fail Causing Slipping in First or Reverse ...

repairpal.com > Problems > Dodge > Caravan

Jan 27, 2016 | 1992 Dodge Caravan

1 Answer

I have a 91 honda accord with an automatic trans. & when i shift into reverse it refuses to engage & makes a high pitch gear slipping grinding sound ! NOT GOOD ! ,I just replaced the transmission con


Definitely not good. The transmission is slipping internally due to worn gears and clutch packs. It will have to come out for rebuilding, IMO. Have a transmission shop check it out.
Good luck.

Dec 23, 2011 | 1991 Honda Accord

1 Answer

Near the end of the breakdown of auto trans in 89 cressida,i could only start out in 1st then 2nd and so on. then it quit going forward altogether.is it a solenoid,torque conv. maybe or does it need a...


You have not indicated the mileage the transmission has done so I will guess it is over 130,000 miles.

At anything over about 110000 miles you can expect the transmission to die and require replacement. From the symptoms you have described, and assuming the transmission fluid was at the minimum operating level, the auto transmission unit will need to be replaced.

Dec 03, 2010 | 1989 Toyota Cressida

1 Answer

Reverse is rough, with intermittent grabbing, not slippage. I have replaced both s1 and s2 solenoids but dash light arrow still flashes. Prior to replacing the solenoids the transmission was in limp mode...


It sounds as if the seals are bad in your transmission and they are allowing fluid to slip past them. This results in the transmission not completely engaging in gear and being extremely slow to shift into gear.

You can try a few capfuls of break fluid in the tranny. This will swell the seals and allow them to seal better. This is not a permanant fix however, this will only temporarily get your tranny working for an undertermined amount of time. I used this fix on a turbo trans 350 and I got about a year of life out of it.

Beyond that I believe you may be looking at a tranny rebuild or replacement.

Apr 09, 2010 | 1996 Volvo 850

2 Answers

Can get all forward gears but can not put it into reverse gear unless the car has been warmed up for ten minutes


The seals inside your transmission are bad and leaking by and they don't start to seal until the tranny fluid warms up and swells the seals. To temporarily fix this problem you can pour some brake fluid into your transmission fluid. This will swell the seal in the transmission and it should start working again. This is only a temporary fix however, eventually you will ned to replace or rebuild your tranny. I used this method on a turbo trans 350 and got a year of service out of it that way before I had to replace the tranny. Just do not put too much brake fluid into the tranny, I would recommend one or two capfuls to start with.

Apr 07, 2010 | 2000 Alfa Romeo 145

1 Answer

Transmission for a 1997 Toyota Camry V6XLE 148,000 miles


Your tranny has died.

More likely the pump in the tranny is bad, but it will take a rebuild to fix the problem sorry to say.

Nov 09, 2009 | 1995 Chevrolet Lumina

2 Answers

TRANNY WONT WORK


yes you blew the front pump seal you prob need too replace or rebuild the tranny!!!!!!1

May 25, 2009 | 1992 Ford F250

1 Answer

1991 toyota transmission


change your tranny oil. sounds like it is shot. i don't know which tranny is in there, you could look it up pretty easy. but before you replace it, replace the tranny oil and see if that helps.

Apr 28, 2009 | 1991 Toyota Cressida

1 Answer

Honda civic 1994 automatic trans slipping when reaccelerate


I would take this tranny in for a total rebuild. this tranny may be headed for a major breakdown and, slippage usually is a great sign for massive transmission failure to come, considering that, you are burning transmission fluid.

Feb 06, 2009 | 2007 Chevrolet TrailBlazer SS

1 Answer

1991 Acura Integra will not drive in reverse


I have the same problem in my 1991 Integra LS Sedan Automatic, when i put it in reverse it makes a grinding noise and won't engage...i've been told the "reverse fork" or something is probably bent which can be common from rocking a car from "D" to "R" to get unstuck from mud or snow and to fix this the tranny needs to be taken apart and fixed, or if any cheaper then replace the transmission. Could also do an auto to manual trans conversion, but those are the only options. Fixing the specific reverse problem would be cheaper than rebuilding the whole trans which a lot of ppl say is the solution

Oct 19, 2008 | 1992 Acura Integra Hatchback

Not finding what you are looking for?
1980 Toyota Cressida 2.2 Logo

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...