Question about 2004 Kia Sedona

1 Answer

Is the power steering and the brakes served by the same fluid

Hit the brakes on a lock now have problems with the power steering and the brakes

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 60 Answers

Not the same fluid.

Posted on Apr 10, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changing pump and bleeding power stearing on a 1983 buick riviera


1. Replace any hydraulic line showing external damage. Rubber hoses more than 4 years old should be replaced. Install new seals for all disconnected fittings (as required) and install an in-line power steering filter. Tighten all hose fittings to OE specifications. 2. Flush the entire power steering system using the vehicle manufacturers recommended fluid. Fill pump reservoir to the proper level.
3. Disable engine to allow cranking without starting. This can be done by unplugging the main power wire (large red one) from your Delco HEI Distributor unit. Block wheels, put transmission in neutral or park and set parking brake, then crank engine 5 to 10 seconds (avoid overheating starter motor).
4. Refill pump reservoir as necessary. Repeat step 3 until level is correct.
5. Enable the engine to allow starting. Start engine and let idle. Slowly turn steering wheel from lock to lock a number of times.
6. Turn engine off and inspect fluid level and condition. Add or remove fluid as necessary. If fluid is foaming, wait one hour then recheck level. Repeat step 5 and 6 until fluid level is correct and shows no sign of air. If the problem persists recheck installation and connections.
1. With engine off, apply and release brake pedal 5 to 10 applications to deplete accumulator reserve pressure. With foot slightly pressing brake pedal, start engine. Pedal should drop and then push back against your foot.
2. With engine running, turn steering wheel until lightly against steering stop. After 5 seconds return wheels to the straight ahead position and turn engine off. Apply and release brake pedal. There should be at least one power assisted brake application. Start engine and allow accumulator to recharge before moving vehicle. 3. Test drive vehicle.
NEVER operate any vehicle until brake and booster systems are functioning properly. Remember, your vehicle is only as good as it's braking system. Brakes are the singlemost important component on any motorized vehicle.

Nov 06, 2016 | Buick Cars & Trucks

3 Answers

Can i put brake fluid in my power steering 94 plymouth grand voyager?


Never brake fluid and nothing else goes in brake master cylinder.

Put power steering fluid or automatic transmission fluid (dextron)

May 04, 2014 | 1998 Plymouth Grand Voyager

1 Answer

I changed my front pads and rooters on my 2002 suburban and now the power steering is out?


Phil: you probably got air into the power steering fluid assist piston. Try driving your car. The air should bubble up, keep adding the correct power steering fluid.

Mar 30, 2014 | Chevrolet Suburban Cars & Trucks

1 Answer

My 94 mercury grand marquis makes a very loud squeaking noise when i turn the steering wheel or hit a bump, it sounds like its coming from the passenger front.


There are several possibilities that could be causing your problem.
  • Low on power steering fluid
  • Bad steering box
  • Bad tie rod end
  • Bad ball joints
Assuming the power steering fluid is full, bring the car to any brake shop or repair shop that does front end alignments to diagnose the problem further. I hope you find this points you in the right direction. Thank you for using Fixya! Greg

Feb 17, 2011 | Mercury Grand Marquis Cars & Trucks

1 Answer

My front brakes locked up and won't release all the way


check and see if someone has mistakenly put power steering fluid in the master cylinder. if so the rubber components will swell up and be really spongy.this occurs fairly often at quick oil change locations as most of the guys are inexperianced,many brands of brake fluid and power steering fluid are in nearly identicaly labeled bottles.if this is not he problem check to make sure nothing is keeping the brake peddle from returning to its stop.other possible causes of this problem are rusted and siezed brake caliper mounts. these need to slide freely

Jan 30, 2011 | 1985 Chrysler Fifth Avenue

1 Answer

I replaced the power steering pipe line,and now there is no power steering on low rpm and there is a problem with the brakes/the car is a 1997 gmc savana 6.5 l diesel


SOUND LIKE LOW POWER STEERING FLUID.CHECK POWER STEERING FLUID.AND FOR THE BRAKE PROBLEM.CHECK BRAKE FLUID.MAKE SURE IT NOT LOW.IF SO CHECK BRAKE HOSES LINES AND CALIPERS + SEALS CHECK WHEEL CYLINDERS + SEALS.IF ALL IS GOOD.MASTERCYLINDER COULD BE DEFECTIVE

Jun 01, 2010 | 2006 GMC Savana

3 Answers

My Power Steering fluid is low, I want to add power steering fluid. I can't find the cap to add fluid in my 2006 Chevy Malibu LTZ.


how do you know its low then? it's there in the engine compartment, its usually set in a small black plastic box towards the front off most engines because its run by the serpentine belt, so follow the belt on your car it rolls right over the power steering unit. it"ll have a circular knob with small half moon cuts on the outside to make it easier to grip, and right on the top, in yellow writing, it'll say power steering fluid only! Hydraulic fluid or transmission fluid, dont put brake fluid in there..always in a pinch you can pour transmission fluid in. Now if its leaking i highly recommend "Lucas" stop leak power steering fluid, but only to top it off dont poor in the whole bottle at once because this stuff works too good! and could lock up your steering. Everytime its low just top it off again.
can you rate my answer.thank you.

May 10, 2010 | 2006 Chevrolet Malibu

1 Answer

What is the 90,000 mile service for a 2001 Isuzu Vehicross?


Change front/rear axle oil
Change transfer case oil
Air filter
Engine coolant
Rotate tires
Fluid level on battery/radiator/brakes
Change oil and filter
Inspect for fluid leaks
Inspect coolant and heater hoses
Check exhaust system
Check drive belts/tires/wheels/brake lines
Check steering operation/disc brakes/brake pedal play
Check parking brake
Check and lube accelerator linkage
Check suspension/steering/power steering fluid
Lube body and chassis
Check TOD system fluid
Check cruise control linkage and hoses
Check starter safety switch
Lube key lock cylinder

Jan 15, 2010 | 2001 Isuzu VehiCROSS

2 Answers

2002 chevy silverado 2500HD (automatic)


the power brakes are a hydrolic system ran off of the power steering pump. therefore if you have a busted power steering hose the power brakes will not work.

Feb 28, 2009 | 2002 Chevrolet Silverado 2500HD

3 Answers

Power steering & power brakes


Sounds to me like your power steering pump has gone bad. Being a vehicle with a hydro-boost brake system that would explain the power brake failure. Hydro-boost brake systems utilize pressurized power steering fluid to provide brake assist. In most lighter GVWR vehicles this function is performed by engine vacuum. There is a recall on certain Silverados and Sierras that addresses a faulty check ball in the booster, but your vehicle is affected by a steering issue as well. This would indicate to me that it is the pump. You can however check online to verify if your vehicle is affected by the recall. Hope this helps.

Nov 04, 2008 | 2002 Chevrolet Silverado

Not finding what you are looking for?
2004 Kia Sedona Logo

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...