Question about 2003 GMC Sonoma Extended Cab

1 Answer

The driver side window will not work on my 03 gmc sonoma cannot find the seperate fuse for the window all other windows work

I dont think the motor is blown because i do not hear a clicking or humming sound when i push the button. The window has shown no problems with going up and down, it seems to be at a good speed when doing either. It all of a sudden just will not move.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • GMC Master
  • 513 Answers

THERE IS NO FUSE FOR THAT WINDOW ONLY .IF YOU HEAR MOTOR RUNNING YOU ARE GETTING POWER. YOU HAVE A BAD GEAR SET OR REGULATER

Posted on Nov 20, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

AUTOSOUNDINS
  • 232 Answers

SOURCE: 2001 gmc sierra power window

YES THE SWITCH IS BAD SINCE IT RECEIVES THE MOST USE DURNING OPERATION ESPECIALLY THE DRIVERS DOOR REPLACE THE SWITCH AND IT SHOULD WORK FINE

Posted on Aug 11, 2008

  • 1 Answer

SOURCE: 2000 GMC Jimmy SLE driver's power window

I had the same problem...it was the window gear that got stuck when the window was all the way up. (that's the clicking) I took my panel off and banged on the inside of the door with a rubber mallet. The window works again. Since then I make sure when I role the window all the way up to stop that I just barely tap the down button to release the pressure on the gear inside. When your using the hammer...hold the switch in the down mode...ignition on of course.

Posted on Sep 06, 2008

  • 1 Answer

SOURCE: 2000 GMC Jimmy SLE driver's power window

The same thing happened to my 1999 JMC Jimmy recently. I believe the problem is that your power window motor has most likely gone out or is starting to go out. The motor will need replaced. They are pretty expensive new. I went to a junkyard and got one for around 15 dollars. When mine went bad, I had rolled my window down about three or four inches and it stuck there. I took my door panel off and tapped on the motor while holding up on the window switch and got it to go up after a few minutes. I am replacing my motor today, I'll leave an update here about the outcome when I finish the job. I hope this information helps you.

Posted on Oct 11, 2008

  • 2 Answers

SOURCE: HAVE A 03 GMC SIERRA

I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.

Posted on Dec 21, 2008

fphandyworks
  • 56 Answers

SOURCE: 2001 GMC Sierra Power Window problem

you should check the wire harness that goes from the door to the truck there must be a bad conection near by there somewhere in the harness hope this could help you.

Posted on Jan 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver's side window will not open or close automaticaly. Has to be pulled up and down by hand


Check the wiring and connectors supplying the driver-side window motor and also the fuses in case each window is fused seperately. The electric motor may have failed. When you operate the switch do you hear the motor working?

Jun 24, 2009 | 2003 Subaru Forester

1 Answer

Driver side electrical window


the windows are controlled through a central electronic module called a GEM (Generic electronic module), there is no seperate fuse for the window, if only one window works then either the window switch is defective or the window motor is defective, the motor is the most common problem.

Apr 13, 2009 | 1999 Ford Windstar

1 Answer

GMC sonoma fuse block - where are all the fuses? My turn signals dont work.


your fuse block is on drivers side, open door look on side of console about half way down you will see a small panel door. that is your fuses

Apr 11, 2009 | 1996 GMC Sonoma

1 Answer

Power windows on drivers side work passenger side dont


its probably either the window motor or the regulator or some cars have seperate fuses for each window

Apr 08, 2009 | 2003 GMC Yukon Denali

2 Answers

Window on drivers side wont go up or down but passenger side works on 2002 gmc sonoma


A couple of things that can happen. The switch is bad or the motor regulator is bad. Either way the best way to check is to open the door up and disconnect the motor and ground one terminal and supply battery voltage to the other. You might want to use a fused wire to do this just in case the window motor is shorted out. You can reverse the ground and positive and the window will operate in the other direction. if the window moves the porblem is either the switch or you have no power to the switch.

Mar 21, 2009 | 2002 GMC Sonoma Extended Cab

1 Answer

The driver's side powerwindow stopped working.


their is no fuse their is one relay that controls all the windows you prob have a bad motor or bad switch

Feb 22, 2009 | 2001 GMC Sonoma Extended Cab

Not finding what you are looking for?
2003 GMC Sonoma Extended Cab Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...