Question about 1995 Ford Mustang

1 Answer

95 6CYL MUSTANG IDLES AT 3K rpm

CAR IDLES AT 3,000 rpmS IN ALL GEARS

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 47 Answers

Use a multi volt meter and check the reading on your tpi throttle position sensor it could be out of adjustment and also check your idle air solenoid and check the egr valve to make sure its not sticking.most likely one of the 3.you can find the volt setting for the throttle position sensor on you tube as well.hope this helps

Posted on Apr 25, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 95 Answers

SOURCE: 1994 mustang gt cuts out

have you been tuning it? look for the vacuum hose you knocked off.

Posted on Mar 20, 2009

chuck943
  • 783 Answers

SOURCE: 2007 crown vic 4.6 l idles high on startup

This sounds like a normal condition.What happens is the cold start emission reduction component monitor(software program in the computer) is running.
Cold Start Emission Reduction Component Monitor
The Cold Start Emission Reduction Component Monitor was introduced for the 2006 MY on vehicles that meet the
LEV-II emission standards. The monitor works by validating the operation of the components of the system
required to achieve the cold start emission reduction strategy, namely retarded spark timing and elevated idle
airflow.
When the CSER strategy is enabled, the idle air control system will request a higher idle rpm, elevating engine
airflow. While this CSER elevated airflow is requested, the low airflow test compares the measured idle airflow from
the MAF sensor to the commanded idle airflow from the idle air control strategy.


Posted on Apr 02, 2009

keemo68
  • 1263 Answers

SOURCE: I have an 89 sc that idles between 2,500 and 3,000

look for a vaccum leak in the intake manifold most likely there is either a dry rotted rubber hose that has a hole in it or a hose came off generally it will be somewhere near the firewall.

Posted on Apr 18, 2009

SOURCE: 95 mustang 3.8 has high idle about 3,000 rpm when

Best take it to a repair shop. If your removing air intake ducting and starting the vehicle,you don't understand the technology.

Posted on Sep 28, 2010

canwoodjc
  • 3301 Answers

SOURCE: loud rattle noise under truck between 2,000 and

if you have a protection pan on the bottom of the vehicle, check that to be sure its tight, if you have rear wheel drive, make sure the drive shaft and u joints are ok,, if all those check out to be fine, check your motor mounts. under carriage rattles can be a real pain to locate,

Posted on Sep 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1995 Subaru Legacy (high miles, over 200,000) lurches forward and back when I try to accelerate from ~65 mph to a higher speed. This appears to coincide with going above 3,000 rpm. The tach also goes up...


You will need a computer to accurately read the signals you are getting from the sensors in the engine bay, but my guess is that the MAF sensor may be acting up.

Sep 22, 2013 | Subaru Legacy Cars & Trucks

1 Answer

2003 Mitsubishi lancer 2.0 ralliart. Complete loss of power under wide open throttle between 2,000 - 3,000 rpm. Car idles fine and continues accelerating after 3,000 rpm under wide open throttle just fine....


oxygen sensors buddy, and there is two of them. one above the engine and under. you have to cut it enough to where you can splice and re wire another sensor on.

Feb 23, 2013 | Cars & Trucks

2 Answers

2000 Suzuki esteem wagon, rpms race when car is rolling


check the throttle position sensor. that should be whats wrong.

Jul 22, 2009 | 2000 Suzuki Esteem

1 Answer

Throttle body reinstalled, firebird idles at 3k rpms?


You have a vacuum leak for sure. Look and listen carefully for anything left off, maybe an egr valve or pcv hose, brake booster line?

Apr 14, 2009 | 1988 Pontiac Firebird

1 Answer

1994 mustang gt cuts out


have you been tuning it? look for the vacuum hose you knocked off.

Mar 01, 2009 | 1994 Ford Mustang

1 Answer

1999 Ford SVT Mustang Cobra and a rattling sound


as for the rattling sound have you checked the heat shield on the catalytic converter, mine was loose and was causing a rattling sound when it was at idle, and would go away as the rpm's increased.

Dec 30, 2008 | 1999 Ford Mustang Cobra

3 Answers

My camaro is idling at 3k rpm in park


Listen for a hissing sound you could have a vacum leak . spray carb cleaner around the thodle body and the intake to see if you have a bad gasket or just needs to be tighting.also check the choke and throdle pationing sensor it could be stuck open!

Nov 13, 2008 | 1994 Chevrolet Camaro

2 Answers

Car idles hi at start up and while driving it keeps using hi rpm's


hello it sounds like your throttle position sensor (tps) is out of range this controls your idle threw the computer what you have explained is a pattern to bad tps goodluck

Sep 18, 2008 | 1988 Honda Accord 4 Door

Not finding what you are looking for?
1995 Ford Mustang Logo

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...