Question about 1996 Toyota Camry
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: alarm remote
Look under the driver side seat for a small black box. This is the control for the remote/alarm system. Check to see that it is not wet. Open it up & inspect the circuit board. Are any of the circuits corroded/greenish powder on them? If so, you need to replace this box. Quite a common failure. But, there IS hope. You CAN start the car without the aid of the remote since you lost it. Put the key in the ignition, and, if the lights start flashing, CYCLE the key on-off 5 times. This action will defeat the alarm, and the car will start. This is provided in case the battery in the remote goes dead on you.
Posted on Sep 11, 2008
factory security does not have toggle switches as far as I know so it is probably an aftermarket system. Try one of two things, turn the toggle switch the oposite direction with battery disconnected. Reconnect the battery and try again, the horn will beep a few times when you reconnect. try starting. If that doesn't work, disconnect the battery and turn the key to the on position and reconnect the battery and the horn will sound but will go off get in the car and try to start. It should start and run normally. shut car off, then you should be able to return the toggle switch to the previous position If this happens again turn the toggle switch to the opposite position with the batterry disconnected and turn the key switch to the on position and reconnect the battery and start when started go see a service that installs aftermarket systems and they should be able to reset it security system Hope this helps
Posted on Sep 21, 2012
SOURCE: 1990 toyota camry won't start
Usually if you hear the starter solenoid click but the starter doesn't crank, its the starter. And since it was after a trip that is usually when starters are bad when they get hot.
Posted on Apr 25, 2009
hello gwolfson...from your explanation it sounds like the starter motor is turning but the bendix is not engaged. This happens over time and is caused by normal wear. A click or clicking noise would point to the starter solenoid. Don't wait until you hear a grinding noise to replace it, thats hard on the ring gear and flywheel. A NEW starter is recommended if you plan on keeping the car. If not, you can go with a rebuilt starter for around 65 dollars. Of course make sure the battery terminals are clean and secure as well as the solenoid terminals.
Good luck...i hope this helps and will fixya up.
Posted on May 29, 2009
lock your doors and close it wait till alarm resets and then unlock door with key and this should take care of you problem
Posted on Jan 05, 2010
Tips for a great answer:
Sep 27, 2012 | 1998 Nissan Altima
Sep 19, 2012 | 1994 Toyota Camry
Jan 24, 2011 | 1994 Toyota Camry
Aug 10, 2010 | 1997 Toyota Camry
Jan 29, 2010 | 1998 Toyota Camry
Aug 17, 2009 | 1998 Mercury Sable
Jul 22, 2009 | Honda Accord Cars & Trucks
Jul 18, 2009 | 1996 Mercedes-Benz E-Class
Nov 04, 2008 | 1995 Toyota Camry
204 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: