Question about 2000 Dodge Ram 1500 Truck

1 Answer

Need to know what the rpm settings are on a 5.9 2000 dodge ram 1500

I had a new tranny put in and I wanted to know what the rpm settings should be. Thanks!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Dodge Master
  • 513 Answers

The rpm settings are controled by the ecm. no adjiustment needed

Posted on Dec 04, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: brake pad replacment on 2004 Dodge Ram 1500

Remove two bolts holding caliper on and pull up as hard as you can on the caliper. Wiggling back and forth at the same time helps.

Posted on Aug 02, 2008

awcforever
  • 359 Answers

SOURCE: I need a serpentine belt diagram for a 2004 dodge ram 1500

By chance, have you looked on the underside of your hood, most, if not all vehicles have the diagram there, it should be a white sticker with the pulleys and everything.

Posted on Feb 15, 2009

  • 14 Answers

SOURCE: thermostat in 2001 dodge ram 1500

the thermostat is located where the upper radator hose comes off the engine there are two bolts or nuts remove hose and remove housing you will see the thermostat when you do clean old gasket material off block and reverse removal procedure

Posted on Apr 07, 2009

  • 151 Answers

SOURCE: check engine light on code

This trouble code is Evap Purge System Performance fault. 1) Check for a loose or missing fuel cap. 2) Check for a damaged or missing fuel cap seal. Recheck for other trouble codes. This fault wont cause the stumblering problem. It turns on the MIL lamp to say there leak in the EVAP system.

Posted on May 10, 2009

greg_margo
  • 1959 Answers

SOURCE: firing order for dodge 2001 ram van 1500,

Here you go:
5.2L and 5.9L engines Firing order: 1–8–4–3–6–5–7–2 Distributor rotation: Clockwise

Diagram link below:

http://www.chiltonlibrary.com/content/images/7924/images/79243g14.gif

Best of luck!
Greg

Posted on Jun 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 dodge ram 1500 it has a hard time shifting up when my.transmission gets hot and I have to some time kick up very high in rpm and something it don't help


I would recommend a new filter. When replacing fluid make sure you use dodge tranny fluid. I thought the trans was completely out on my dodge. I flushed the trans and put in a new filter and fluid. Could tell it didn't have as much power, but was still able to pull my boat.

Jul 29, 2014 | Cars & Trucks

1 Answer

2001 Dodge Ram 1500 3.9 V6 Seems not to go into low gear anymore - also, won't kick down into low even at low rpm. Anyone got a fix?


You may have a leak in the vacuum line which tells the tranny to switch gears, or it may have an electrical sensor instead of a vacuum line, Most new trannys are controled by electrical signals from sensors

Nov 01, 2013 | 1999 Dodge Ram

1 Answer

01 ram 1500, 3 rd trans. warranty. still rpm jump at highway speed. just got it back from a repitable tranny shop. 46re tranny.


faulty sensor or the light sensor on the gearbox/auto side of engine is dirty bring it back and demand satisfaction or you will bring in trading standerts.adrian.

Mar 15, 2011 | 1999 Dodge Ram

1 Answer

So i have a 97 dodge 1500. 168,000 with no problems, when one day the overdrive off light turned on and i lost od. then it wouldnt shift at all til i hit 4,000 rpm. shop said to replace tranny. I put in a...


Make sure the fluid level is correct on the dipstick as the clutch packs will often take a while to fill with fluid and you may need to add more fluid

Mar 30, 2017 | 1997 Dodge Ram 1500 Club Cab

1 Answer

2001 dodge ram1500 /accelerates slow even w/peddle to the floor


How many miles on that rig? The 4.7 motor is a great motor.

Sounds like a fuel starvation issue. Might also be a trans issue. Does the trans seem to be shifting properly?? Could it be starting in 2nd gear which is the "limp mode" for Chrysler trannies?

Apr 21, 2010 | 2000 Dodge Ram 1500 Truck

1 Answer

Ram 1500 5.2l auto starts but after a few seconds


swap the asd relay with the fuel pump relay and see what it does then

Jan 22, 2010 | 1996 Dodge Ram 1500 Club Cab

2 Answers

No reverse 2001 ram 1500 4x4 5.9


sounds like just bad luck
Its like the reverse band needs adjusting so make sure tranny fluid is clean no bunt smell
if its discolored or smells burnt then its clutches & bands!

Jul 18, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

I have been told that you can not put any engine in the 2004 Dodge Ram 1500, expect the stock engine. Is this true? The cost I was quoted to replace the engine was $5000.00, for a rebuilt engine to be put...


You can replaced it with another enigne but stock. The 2005 Ram 1500 engine will fit right in. If you are trying to get a totally different manufacture engine then you will need to make sure that the mounting bolts, tranny and everything else lines up. Technically speaking, you can put any engine the is rear wheel drive in your vehicle. You might just have to move the munting brackets, replace the tranny, open up the fender wells things like that. But the 2005 1500 will fit directly into your vehicle

Apr 13, 2009 | 2004 Dodge Ram 1500

4 Answers

Dodge Ram Transmission


You need to get your tranny rebuilt. The motor that is already in your truck is set up for that Tranny so i wouldnt change it at all as it would cost alot more then you need to spend to do it. . I also would go to Mr.Transmission as they do great work on trannys.

Apr 04, 2009 | 1996 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...