Question about 2004 Dodge Durango

Open Question

2004 dodge durango valet switch location?

Cant find the valet security override switch?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 245 Answers

SOURCE: location of speed sensor for a 2003 dodge durango

the speed sensor for this vehicle is actually in the rear differential of the vehicle. this is the sensor that runs the speedometer also known as the vehicle speed sensor. there are also two speed sensors in the front one on each wheel known as wheel speed sensors these are for the abs system only

Posted on May 17, 2009

  • 13 Answers

SOURCE: Fuel filter location 1999 dodge durango

the fuel filter is located on the iner driver or pasenger side frame railing inbetween the front and rear doors. yes it has filter in the tank which is more comely know as the sock or straner. the filter will look like a metal canister .

Posted on Jul 29, 2009

shinehutt
  • 254 Answers

SOURCE: Where is the oil sending

Oil Pressure Sensor

On the 3.7L and 4.7L engines, the oil pressure switch is located at right front of engine just above the oil filter. On the 5.7L engine, the oil pressure switch is located at right front of engine.


hope this helps you

Posted on Jan 15, 2011

mabpest
  • 1152 Answers

SOURCE: where are the o2 sensors

I believe you may have three (3) O2 sensor, (2) of the sensor is on ether side of the exhaust down pipe and some times called up stream O2 sensor, the third O2 sensor know to some as the down stream O2 and is after the Catalytic converter.
The up stream O2 monitors the left and right side banks and sends signals to the ECM to make the adjustments to the injectors to keep the proper air/fuel ratio.
The down stream O2 monitors the catalytic converter and sends signal to the ECM if the catalytic converter has gone bad.
Good luck and hope this helps. If you get it scanned at Auto Zone, they should be able to let you know which O2 has gone bad so as to not change all three. You could always check the wire harness to the down stream O2 for corrosion.

Posted on Jan 29, 2011

nicole99wu
  • 1049 Answers

SOURCE: transmission shift solenoid location

fault code stored in your car, you can go to garage repair it, or get a code scan tool clear it by yourself, Autel MaxiDiag US703 can do your car. hope help.

Posted on Jun 28, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Durango. Where is the valet switch located?


there is none,you get a key and fob,if you cant start it,then use your fob to unlock the doors and try again

Jul 20, 2015 | Dodge Cars & Trucks

1 Answer

How can a security system be reprogramed in a 2004 Durango with a 5.7 hemi


Try this Instructions
    • 1Press the "Unlock" button on the remote keyless entry device.
    • 2 Insert the key into the ignition. Turn the ignition switch to "ON" without starting the engine.
    • Sponsored Links
    • 3 Press and hold the valet/override button below the steering column within five seconds of turning the ignition on.
    • 4 Release the valet/override button when the security light on the instrument panel stops blinking. The alarm is reset and disabled.


Read more

Jan 11, 2015 | 2004 Dodge Durango

1 Answer

Where is the valet button override button in 2004 dodge durango


the
valet/overide button, found under the
dash area

Mar 25, 2014 | 2004 Dodge Durango

1 Answer

Car starter in valet mode


  1. 1 Insert the key into the ignition.
  2. 2 Turn the ignition switch to "ON." Do not start the engine.
  3. 3 Press and hold the valet/override button within five seconds of turning the ignition on. The valet button is located beneath the steering column.
  4. 4 Release the valet/override button after the security indicator light turns off.
  5. 5 Turn the ignition switch off.

Dec 07, 2013 | Dodge Cars & Trucks

1 Answer

I have a 2000 dodge intrepid. The alarm never worked on it. We bought it used and all of a sudden when we go to unlock the door it turns on. Now the car won't start. I've looked online for answers and...


The 2000 Dodge Intrepid is equipped with an alarm system that is triggered when unauthorized entry is attempted. In some situations, such as having the Intrepid valet parked or when it is being serviced by a mechanic, the alarm system needs to be disarmed so it doesn't go off. Disarming the alarm will prevent it from being activated until it is armed again.
Difficulty: Moderate Instructions

  1. 1 Insert the key into the ignition.
  2. 2 Turn the ignition switch to "ON." Do not start the engine.
  3. 3 Press and hold the valet/override button within five seconds of turning the ignition on. The valet button is located beneath the steering column.
  4. 4 Release the valet/override button after the security indicator light turns off.
  5. 5 Turn the ignition switch off.


have to do it in this order

Dec 10, 2010 | 2000 Dodge Intrepid

1 Answer

My glove box valet lock is on, how do I override


Your black ended driver key should open the glove box. The valet key is not made to open it, thats the safty feature in it. There is no overide for the Valet settings, you have to unlock the glove box with Driver (master or black) key and turn the Valet switch off. Also the Valet switch does not engage the glove box lock so over riding the Valet security wouldnt open it even if you could over ride. If the Valet key would unlock it or was easy to overide then it wouldnt be a very good safety feature. Best of luck, hope you can get it opened.

Jul 28, 2010 | 2001 Oldsmobile Aurora

1 Answer

Valet switch location


I own a 1998 dodge durango and Keyless entry does not work all the time and sets my alarm off. There is a valet switch which will perminately disarm the alarm, but I a unsure of it;s location under the dash. Can you help me with this.

Jul 02, 2010 | 2000 Dodge Durango

Not finding what you are looking for?
2004 Dodge Durango Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...