Question about 2009 Ford Transit Connect

Open Question

Find ford transit asm manual

Vj transit drops to neutral after about a meter of driving when taking off forward and reverse

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: awd 97 ford explorer grinding noise going forward

I ran into this problem, and discovered that i had a faulty front shaft speed sensor. The grinding I had was that the transfer case clutch packs were trying to lock up and engage the front wheel drive. Replacesment of the sensor has not fully rectified the situation though, as it still does it intermittently. It seems to do it at low speed turns and on acceleration. Not sure if this is your problem or not, but it could be. A scan of the computer can tell you if it is the issue though.

Posted on Apr 26, 2009

  • 68 Answers

SOURCE: Driving a 2003 Ford windstar. Went to pass and

Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.

Posted on Mar 01, 2010

  • 7 Answers

SOURCE: My 1999 ford explorer will not go into park;all other gears work

DIsconnext and reconnect the linkage at the transmission. You may want top replace the linkage cable all together. Make sure you set the parking break and block the tires

Posted on Apr 14, 2010

csmock132
  • 4669 Answers

SOURCE: my 2002 ford explorer transmission shifts hard

Check engine light on? Sounds like a bad pressure control solenoid. If it is a bad PCS. You have to replace the solenoid block in the 5R55W transmission.

Posted on Jul 13, 2010

  • 1 Answer

SOURCE: Transmission stopped working suddenly

Yeah, same thing happened to a lot of folks. The transmission has a flaw that causes the 'stuck in neutral' syndrome. Ford will do nothing for you and will not even acknowledge that there is a problem. Check it out for yourself, there are hundreds of complaints posted on the internet and it's about a $2500 repair. Should have been a recall or at least a TSB. Ford has no desire to stand behind their product and repair/replace the faulty transmissions. Way to go and the thanks we get for 'buying American'.

Posted on Jul 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vs auto have forward gears even in reverse any ideas please


A4LD stuck in forward, even while in neutral and reverse. - Ford ...

https://www.explorerforum.com/forums/showthread.php?t=216567

May 27, 2008 - 19 posts - ‎5 authors
I did find a thread that referred to an "always in a forward gear" A4LD problem, ... Eventhough band adjustment should not have anything to do with the .... in the transmission and then it auto shifts through the gears normally.

700r4 forward in all gears, even neutral, no reverse - Third ...

www.thirdgen.org/forums/.../631383-700r4-forward-all-gears.html
Oct 21, 2011 - 700r4 forward in all gears, even neutral, no reverse ... It has no reversebut when I put it in reverse it tries to pull the motor down like the rearend ...

my car is not moving forward or backwards even with gea


Dec 27, 2015 | Cars & Trucks

1 Answer

Ford transit gearbox diagrams


Have the fault codes read. Replace faulty items. Use only genuine items as non-genuine replacement are not always compatible with the OEM fitted CPU units. I suspect servo solenoid faults. Have a pressure test done on the gear box

Jun 11, 2013 | Cars & Trucks

1 Answer

My car goes forward in reverse why?


adjust shifter to correct

Apr 20, 2013 | 2002 Ford ZX2

1 Answer

How difficult is it to replace the fuel pump on a 1998 ford explorer


it is in the fuel tank. you have to disconnect the fuel inlet hose at the tank, 2 tank strap bolts while supporting the tank with a jack. then use the jack to lower it enough to reach up and remove the "quick disconnect" fuel lines from the sending unit/pump asm. (special tool required) Then drop it down, remove the retaining ring from the top of the tank and pull the entire sending unit/fuel pump asm. straight up and out...reverse procedure to install the new asm.

Jun 26, 2010 | 1998 Ford Explorer

2 Answers

I have a code po705 my car goes reverse neutral


p0705 is the transmission range sensor which tells the ECM what gear the transmission is in neutral/reverse. Which was probably happened when you lost Drive gear

Jun 02, 2010 | 1999 Ford Windstar

1 Answer

Transmission fluid leaking back, 1988 Ford Bronco


your output seal on the tranny or input seal on your transfer case is bad. you have to pull your transfer case to tell. this is a pretty straight forward job. block wheels. put transfer case in neutral. drop front and rear drive lines.diconnect transfer case shift linkage. there is a short commponent connecting the trans to the transfer case. the bolt on either end face each other. remove the bolts to the transmission. the transfer case is heavier than it looks, i suggest getting help. pull back on the transfer case until it will drop down. it will pull out a bit because of the trans output shaft. replace what will probibly turn out to be the tranny output shaft seal and reassemble in reverse order.

Nov 06, 2009 | 1988 Ford Bronco II

1 Answer

Have lost reverse and third gear on 2004 expedition


????? manual or auto tranny if its an auto check the tranny

Dec 05, 2008 | 2004 Ford Expedition

Not finding what you are looking for?
2009 Ford Transit Connect Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...