Question about 2006 Saturn ION

1 Answer

Knocking nosie from left side of 06 saturn ion? hear it all the time but mainly after 2nd gear when it shifts is the worst part?

Knocking noise from left side mainly when it shifts into gear

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Have your motor supports checked. Also the drive shaft could be causing the problem if that knocking is not coming from inside the motor.

Posted on Mar 25, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 1997 sL1 Saturn manual transmission hard to change gears

The dipstick is behind the battery, below the master brake cylinder and is not the clutch reservoir. It has a red flip top handle instead of a ring like most dipsticks. It was hard for me to find due to engine grease. I had the same problem and was able to see that I was low on fluid (only a little) and adding fluid helped the problem. Questions? kurt1431 at comcast dot net.

Posted on Jun 29, 2009

onyxvu
  • 74 Answers

SOURCE: 06 SATURN ION

not necessary

Posted on May 27, 2009

ewashmidas
  • 362 Answers

SOURCE: Are my struts out on my 04 Saturn ION?

I agree. I see sway bar links go bad and make nosie much more often than struts on Ion's. Take it to a service center you trust.

Posted on Jan 25, 2009

  • 1 Answer

SOURCE: 06 saturn ion has key

Make sure it's in Park (if automatic). If so, or if it is a manual, turn the steering wheel (even if it's locked in) and the key will release.

Posted on Jul 24, 2009

  • 1 Answer

SOURCE: 2001 Saturn SL Manual Transmission stuck in 2nd Gear

I had this same problem with my 1998 SL2 after about 170,000 miles. There is a plastic bushing at the end of the shifter cable that holds the cable to the shifter - it probably broke. Remove the center console inside the car to access the bottom of the shifter. I checked my local Saturn dealer to find the replacement cables (come as a set) are more than $200. So I went to Lowes and bought a beam clamp and a large washer to hold the cable to the shifter. It has been working fine for more than 28,000 miles and cost less than $3

Posted on Sep 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Saturn ion will not shift from second to third.its a 4 speed automatic transmission.4t45-e.do we have to pull the pan to put a soleid in there.


2004 saturn ion shifting problems - SaturnFans.com Forums

www.saturnfans.com > ... > Models > Saturn Ion > Ion Tech

Oct 23, 2010 - 6 posts - ‎4 authors
hi my gf has a saturn ion automatic with just over 95000 miles on it. ... drove it today and the car initailly shift into first gear but would not shift into second or ... Third, catalytic converters have plugged up in less than 95k miles on many cars. ... A bad transmission will send it into limo home mode, and display a ... 2001 L200 transmission - won't shift out of 2nd ...
9 posts
Jan 3, 2012
It's that time again - 1999 Saturn SL2 automatic shifting ...
16 posts
Nov 7, 2011
Will not shift out of first - SaturnFans.com Forums
20 posts
Dec 4, 2010
Won't Go Into Gear!!???? - SaturnFans.com Forums
3 posts
Feb 19, 2006
More results from www.saturnfans.com

Transmission Shift Solenoid - YouTube

? 3:46
https://www.youtube.com/watch?v=24gkmDDV0C8
Jan 26, 2008 - Uploaded by ADPTraining
Modern transmission use a specific combination of shift solenoid ... hi everyone i just purchase a 2001 L200 ...

Nov 15, 2015 | Saturn Cars & Trucks

2 Answers

2007 mustang gt have engine knock problem when going from 1st to 2nd gear at 5000 rpms?


5.000rpm's high revs and you run into problems with valve bounce ( hitting pistons) ,ring slap, gudgeon pin knock, big end noise and possible main bearing noise . You may also be getting a hydraulic lock in the hydraulic followers that is holding the valves open too long. Unless the engine has been specifically built for these rpm's any loose ,worn on unsuitable part will cause problems I am thinking that you have around 100.000 miles on the clock after 7 years and the motor is not young Ford V8 engines specifically built for a 500 klm race are limited to 5.500 rpms because they destroy the timing chain if driven over that speed .

Jun 03, 2014 | 2007 Ford Mustang GT

1 Answer

Engine revving up when shifting gears and jerking hard


Really !!!

You have no idea after all those issues that the
transmission is completely worn out?

If it had any chance of repair, you rode it to it's
grave knowing you could hear & feel things

Nov 19, 2012 | 2007 Volkswagen Jetta 2.5 Sedan

1 Answer

I turn ignition on wont turn over,everything else works. Wats the problem ? 06 Saturn Ion 3


Seams that your starter has failed.
You can check it if you have a volt meter.
1. Fist check for 12v at the main large post on your starter solenoid.
2.Then place your meter on the 2nd large post its the one with the braided wire that enters the starter.. Then turn the ignition on as you would to start it.If you have 12v there then your starter motor has failed and you need to replace it.
hope this helps FixYa

Feb 17, 2011 | 2006 Saturn ION

2 Answers

Knocking noise from motor when starting car and accelerating


Without hearing the noise myself, it is hard to give you any really good advice.
I will say, however, that most of the Saturn Engines that I have worked on are chain-driven engines (as opposed to having a timing belt) and I have seen a few with broken timing chain guides.
Knocking noises can also come from several other places including the serpentine belt tensioner, main bearings, rod bearings, and even cracked flex plates, to name a few.
I would recommend getting a professional "trained ear" to listen to it and give you an opinion.

Oct 18, 2009 | 1999 Saturn SL

1 Answer

Are my struts out on my 04 Saturn ION?


I agree. I see sway bar links go bad and make nosie much more often than struts on Ion's. Take it to a service center you trust.

Jan 13, 2009 | 2003 Saturn ION

1 Answer

The engine in my 96 saturn wagon shakes when it is put into gear, reverse or drive.


remove the belt and spin all of the pulleys by hand to make sure they all spin freely. the knocking noise is probebly a pulley locked up.

Nov 08, 2008 | 1996 Saturn SW

Not finding what you are looking for?
2006 Saturn ION Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...