Question about 1997 Jeep Grand Cherokee
It has a new relay "flasher" that's the name n autozone , but the noise still and is the flasher what make the noise, I'm wondering if they sale that relay flasher silence
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Id look at the headlight switch and do some voltage tests to see whats coming out of there. Pay close attention to any wires which look like someone was in there already.People can mess stuff up faster and better than the vehicle can by itself!
Posted on Jan 05, 2009
More than likely you have a bad ground. Under the rear of the vehicle, behind the rear bumper there will be a few wires running to a bolt in the frame (left side i think) Check that no wires are loose or boken. Also if you have a trailer wiring harness, check to see if it has not been damaged. Let me know if this helps :)
Posted on Apr 30, 2009
I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING
Posted on Apr 01, 2010
You have problem with the FLASHER; the flasher is located in the
Junction Block (under the dash, left of steering wheel. See diagram on this page). Check the following repair tip:
Look at the end of the flasher relay with the prongs sticking out. There will be 2 plastic tabs holding it together. Break or bend these back. Pull out the insides. On one side will be all the components. On the other side will be solder joints. Get a magnifying glass and inspect these joints. One or two will probably have stress cracks. Just dab a little flux on this joint and heat it with a soldering iron until it melts back together.
You may need to add just a little solder. Be sure to get the pins hot and not just the solder. They need a lot of heat. Slide the relay back into its cover, dab a little super glue or tape it back together, and you're ready to go.
WJ Junction Block (under dash, left of steering wheel)
Check the Fuse 4, 15AMP for Flasher, hazard switch (see Junction Block diagram above for location of turn signal Flasher relay - Mopar p/n 4686094).
Hope this solve it (remember comment and rated this).
Posted on Apr 20, 2010
Testimonial: "Quick with the answer and good info. Thanks much for the help! :)"
Tips for a great answer:
Dec 01, 2012 | 1994 Jeep Grand Cherokee
Oct 23, 2012 | 1998 Jeep Grand Cherokee
Mar 25, 2017 | 1997 Jeep Grand Cherokee
May 21, 2010 | 1997 Jeep Grand Cherokee
Apr 18, 2010 | 1997 Jeep Grand Cherokee
Oct 18, 2009 | 1997 Jeep Grand Cherokee
Jul 13, 2009 | 1997 Jeep Grand Cherokee
Apr 18, 2009 | 1997 Jeep Grand Cherokee
Jan 10, 2009 | 1998 Jeep Grand Cherokee
122 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: