Question about GMC Sierra 1500

1 Answer

2009 gmc sierra heater control stays in same position

Airbag light is also on

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 948 Answers

Robert: This may be caused by the power control module.

Posted on Nov 25, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 GMC Sierra heater Blower wont shut off

My 2003 Sierra's blower came on by itself in the garage while I was sleeping and ran the battery completely down. I had to replace the blower switch located under the glove box next to the blower at the bottom of the right corner of the dash. The switch is in front of the blower and held in by two screws. Disconnect the two wire connections. This is a "dealer only" part and cost me 65.00. Also check the wire harness with seven wires connected to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order.

Posted on Jan 17, 2009

  • 117 Answers

SOURCE: 2001 GMC SIERRA . ABS LIGHT STAYS ON

Wheel speed sensors misadjusted, damaged , or metal shavings and other debree, since they are magnetic can give false readings from one of the wheel circuits. Over sized tires can give of false speed readings as well. there are many other causes including bad relay, control module, e.t.c. It is best to have the proper scan tool to diagnose an ABS problem

Posted on Jul 09, 2009

  • 6 Answers

SOURCE: 2000 gmc sierra 1500 5.3 v8. a/c heater control problem

your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps

Posted on Sep 09, 2009

Testimonial: "Very good information. THANKS!"

  • 101 Answers

SOURCE: I have a 2002 GMC sierra 1500. Instrument Lights Not Working

When dash lights don't work odds are the tail lights don't work either.Sounds like Dimmer switch may be a problem.

Posted on Oct 02, 2009

  • 153 Answers

SOURCE: my cruise control is not working but the light

The multi purpose wand the includes the cruise control, wipers, high beams and turn signal, might have a short in it. Since the light comes on at first and immediately goes off makes me think the fuses are fine and it just a capacitor inside that wand. GM wants almost 500 for the part on my 01 Sierra, but you can easily find them online for around $90

Posted on Dec 18, 2009

Testimonial: "this was the best help ive gotten fron anyone thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to reset heater controle


There is NO reset (For air bag lamp ether) Scanned ?? Codes ??

Mar 24, 2014 | 2009 GMC Sierra 1500

2 Answers

Heater control valve 97 GMC Sierra


Temperature is controlled by an air mix door inside the HVAC compartment. This door is either electrically actuated if you have an electronic climate control system, or a cable for manual control. Most probable cause is a failed electric actuator (air mix door control module).

Apr 17, 2017 | 1997 GMC Sierra

1 Answer

After changing the battery on my 2008 GMC Sierra the air bag light is on.


check airbag fuse.could have blowed fuse if fuse okay.turn on ignition switch on position the airbag light should glow 8 seconds then go out if not you have airbag fault need let dealership do a diagnostic check.

Feb 03, 2013 | 2008 GMC Sierra 1500

1 Answer

Homelink 2009 gmc sierra will not program garage opener


THE ONE I USE IS TO TRAIN THE HOMELINK YOU WILL HAVE TO DELETE THE EXITING THE FIND THE BUTTON ON THE GARAGE MOTOR PRESS AND HOLD FOR A FEW MINUTE UNTIL THE LIGHT STAYS ON THEN PRESS THE HOMELINK ON THE TRUCK THAT SHOULD WORK

Sep 22, 2012 | 2009 GMC Sierra 2500HD

1 Answer

2003 gmc sierra 2500 service airbag light is on


When AIRBAG light it comes back on and stays on, it is telling you that there is a fault in the air bag system and that the system has been disabled because it is now working properly. To determine what is wrong with the system you will need to count the amount of flashes that the light does right before it stays on permanently and that will tell you what tests need to be done to determine why the system is down.

The most common thing that happens is the clock spring in the steering column goes bad (if this occurs, notice that the speed control and the horn no longer works as well).

Hope this helps, and I'll appreciate your time and consideration if you leave some testimonial comment. Have a nice weekend and thanks for using FixYa.
Jose.

Oct 15, 2011 | 2003 GMC Sierra 2500HD

2 Answers

My gmc sierra says engine hot ac turned off


My truck just did the exact same thing -- and it was a Sensor -- cost me $40.00 to get repaired at a local auto repair shop.

Sep 27, 2010 | 2008 GMC Sierra 1500

1 Answer

I have a 1996 GMC K2500 power staying on to my heater fan


Hardly seems worth changing the lock cylinder, since it is not that easy.
Just be more careful turning the ignition off.
Put in an ignition indicator light on the dash if you have to.

Jul 26, 2009 | 1997 GMC Sierra K2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...