Question about 2002 Kia Sedona

1 Answer

Missing while running

Need to know what would cause a miss in engine

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

CHECK THE HIGH VOLTAGE IGNITION COILS!

Posted on Mar 26, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My van turns over but will not crank


HUH??? I assume you mean to say that it "cranks, but will not start".
There are MANY things that can cause this. The first thing that SHOULD be done is to scan the engine control module for possible fault codes. This can greatly speed up the diagnosis process.

Other than that, the only thing I can tell you is that an internal combution piston engine needs four basic things (components) to make it run:
(1) Air-fuel ratio
(2) Volumetric efficiency
(3) Compression
(4) Ignition

If your engine will not start and run, it is because one of these components of basic engine operation is missing.

To get the engine running again, you must:
(A) Determine which of the basic components is/are missing
(B) Perform diagnosis relative to the missing component(s) to identify the CAUSE of it/them being missing
(C) Perform repairs necessary to correct the CAUSE of the problem.

Apr 19, 2012 | 2001 Dodge Caravan

1 Answer

My 1989 corvette runs great but when it is just setting at a stop light it has a little miss to it i have put new injectors in new plugs wires an it still wants to miss at an idle.


you may need the fuel and or the top end(carboned valves) system serviced(cleaned) the fuel filter changed.the miss must be minor as the check engine light has not come on or you didn`t mention it.it could also be a valve sticking just enough to cause the miss.while changing the plugs you may have closed the gap on a plug without knowing it.

Apr 19, 2011 | Chevrolet Corvette Cars & Trucks

1 Answer

Idling #5 and #7 miss fire. holding it at 2000 rpms makes all 8 miss fire. its running really rich and the only code its showing is P0300 which is engine miss fire. have replaced plugs wires cap and...


When there is an engine misfire it could be gas or spark related. Or, the oxygen sensor may not be operating correctly, which controls fuel supply.

If there is a 'random misfire' then it could be an oxygen sensor causing the problem, as well, causing a rich mixture.

Good luck on this repair.

Jan 30, 2011 | GMC K1500 Cars & Trucks

2 Answers

Check engine light is on and it reads Misfire on #2 cylinder. Also oxygen sensor bank2 sensor 1 and Bank 1 sensor 3 behind the converter. Engine running rough.


the engine miss fire can cause the other codes to set. you need to repair the miss fire and clear all codes after the miss is repaired then see if the 02 sensor codes return. the miss fire is probably a bad spark plug wire a good tune-up should take care of it ........HAVE A GREAT DAY

Jan 27, 2011 | 1996 Oldsmobile Bravada

1 Answer

Engine misses/hesitates on low speeds. Runs fine


is the check engine light on? have you ever serviced the injectors? if not try that first because there are many things that give the symptoms you spoke of. but this is the cheapest.
vbninja E.A.P

Jul 23, 2010 | 2005 Cadillac CTS

1 Answer

1998 corvette c5 has miss at idle. I've changed plugs and put in a new throttle positioning sensor. Put products in gas for water. Still misses.


Try cleaning your Mass air flow sensor. When the MAF sensor gets dirty, it can cause your engine to run slightly lean and make sure your engine is running at normal operating temperature with a good thermostat.
At idle, if the MAF is slightly dirty and giving the wrong signal to the PCM. There is a good chance that your engine have a lean condition enough to cause it to have a miss. It's may just be in the perimeters that it will not set a check "service engine light" on, but will cause it to miss.
Start with that and post us back, be glad to help and thank you for using fixya.

Jul 19, 2010 | 1998 Chevrolet Corvette

1 Answer

97 k1500 5.7 liter vortec misses on cylinders 3 and 5 while idling. about 1500 rpm only cylinder 3 and 4 miss then at 2000 rpm only cylinder 4 and 8 miss. what could cause this?


I have had continuous missing issues on my 1997 Silverado after i had a new engine installed 30,000 miles ago. Today I purchased a new gasket for the EGR Valve and removed it. The mechanic had re-used the old gasket when he replaced the engine and cut corners to save $2.00. I found he had installed the EGR bass-ackwards causing my check engine light to stay on and the engine always to miss. Engine runs GREAT now

Oct 14, 2009 | 1997 Chevrolet K1500

1 Answer

Engine misses, new plugs in it today, still misses


sounds like you could have a leaky valve..

i unpluge 1 plug wire at a time and see if 1 doesnt seem to change the sound of the engin to much. then you will know what plug is doing it and check those valves "exhaust/intake"..

or even check to see if that plug may have oil on it for that could be valve seals or oil ring on piston that would cause a miss..

Jul 08, 2009 | 1993 Chevrolet C1500

2 Answers

ENGINE MISSING


You need to see what is going on, have it put on an engine analyzer to see cause of miss, igntion or low cylinder compression, there is no other way.

Sep 06, 2008 | 1999 Ford Crown Victoria

Not finding what you are looking for?
2002 Kia Sedona Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...