Question about 2009 GMC Sierra 1500

1 Answer

How to reset heater controle

Air bag light also on

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • GMC Expert
  • 207 Answers

There is NO reset (For air bag lamp ether) Scanned ?? Codes ??

Posted on Dec 11, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 fusion reset air bag light in cluster


Light on idicates a problem with the air bag system , there is a DTC - diagnostic trouble code stored in SRS control module . To reset the light , code has to be diagnosed and fixed for the light to go out . If you don't know that your best bet would be to take it to a qualified repair shop . Special tools are needed to diagnose and repair SRS systems . People not knowing what they were doing have been killed .

Dec 29, 2016 | Cars & Trucks

1 Answer

Cruise control and horn stopped working


Check your fuses first, then a vacuum leek second. To reset the air bag light unplug the battery for 30 seconds then reconnect. If the light comes back on take it to a garage as the air bag can be very dangerous.

Apr 14, 2014 | 2002 Chrysler Sebring

1 Answer

Turn off airbag light


Air bag lights self reset you still have a existing problem during the self test it has detected a open/shorted circuit disabling the system. watch your air bag light then turn key on do not start engine lamp comes on then goes out and then comes back on again. this is the start up initialization of the system and sensor or wiring does not pass the system goes fail safe. with a scanner the air bag code can be read thru the OBDii connector if having hyundai body control software.

Mar 21, 2014 | 2003 Hyundai Santa Fe

1 Answer

SRS Airbag light 2004 honda accord


the pcm has very little to do with the air bag. the light is on meaning there is a problem with air bag control module

Dec 27, 2012 | Cars & Trucks

1 Answer

1997 honda civic 1.6L DX SRS Air Bag light stuck on after drove throo heavy rain!


A code reader may not access the body computer, but a professional scanner should. You may be able to research the air bag system online and find a way to make the light flash the codes.
I would guess after reading your description one of the front crash sensors got water in the connector and the sensor has failed.

Sep 27, 2012 | Honda Cars & Trucks

2 Answers

94 saab 900 s air bag light stay's on ?


Most likely a problem with one of the air bag sensors or an air bag system control computer. Most air bag codes are only able to be read and reset by a dealer service center. I would start there. Good luck!

May 24, 2012 | 1994 Saab 900

1 Answer

How do i reset an airbag code 19?


I assume you are counting the air bag light flash, If so light flash 19 is for an drivers side air bag circuit,problem which could be low resistance,circuit open ,short to voltage short to ground. and cannot be cleared or reset until the concern is corrected.ford motor vehicles air bag light will go out when concern is no longer present but will remain in memory, I would start by inspecting wiring under dash going up to steering wheel ,the air bag connector is located just to right of steering column when sitting in the drivers seat after removing the trim panel below the steering column and is a yellow connector, Please use caution when connecting or disconnecting any connectors to air bag system ,battery should be disconnected for min of ten min's prior to attempting any work on air bag curcuits. I have seen many problems in the past with the air bag itself also with the clock spring ,question does the horn,cruise control and steering wheel controls for audio system (IF SO EQuIPPED) work properly? if not there is very possibly a clock spring problem

Dec 28, 2010 | 2004 Ford Expedition

2 Answers

Heater not blowing,air bag light on,abs light on


These faults wont be related.

No hot air will be the thermostat very common on these cars and not an nice job to do either.

Abs light will most likely be a sensor to the brakes they have 4, you can clean these up and it sometimes resets the light, but not always, these are attached to the callipers and easy to remove.

Air bag lights are very random, you will have to get it turned off by a garage, they just come on for no reason it seems. you can check the air bag sensors but to be honest it's not worth the hassle as like I say they just randomly come on.

Hope this helps
Regards
Dan

Feb 11, 2010 | 2000 Chrysler Town & Country

2 Answers

Replaced air bag and cannot get air bag lights off dash


it could be a number of things from the sensor under the front bumper to the control module or it just might need to be reset at the dealer

Oct 14, 2009 | 2008 Honda Accord

Not finding what you are looking for?
2009 GMC Sierra 1500 Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...