Question about Audi 100

1 Answer

Valve setting cold setting of a audi 100L zz engine

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 206 Answers

No cold settings.
0.15 mm inlet
0.40 mm exhaust
when warm

Posted on Apr 12, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Audi a6 2 ltr petrol timing marks and torque


ally head 75lbs ,timing marks i honestly cannot remember ,do it old fashioned way time it to no1 with valves closed on no1 then you can see where or what the pmarks should be ,do not use starter motor ,always crank engine by hand 360? to ensure valves clear

Dec 21, 2010 | 1995 Audi A6

1 Answer

SAme as the person above, at random the right hand side vents start blowing hot air (VERY HOT) irrespective of the temp setting. this lasts for about 5 minutes and then ti returns to normal function


This is a known fault with new shape A6's. The heater control valve (located within the bulkhead within the engine compartment) sticks thus causing hot air to vent out of one side whilst the other side stays cold. Audi have issued a Technical Service Bulletin (TSB) regarding this problem and if your car is within its warranty period they will repair free of charge - if not you are looking at a cost of £250 for a new valve. In true Audi honoured tradition they don't admit to the problem being a design fault despite new valves being modified to prevent it happening in future!! A temporary solution is to turn the climate control dial to max (Hi) then to min (Lo) which should free the valve off until it sticks again. Details and a picture of the valve can be found on the audiworld forum

Oct 30, 2010 | 2005 Audi A6

1 Answer

1996 Audi A4 2.6 V6 engine code ABC - need advice on how to do the valve timing settings with No.3 at TDC; both heads returned from the machine shop after being skimmed incorrectly set up. When stripped...


If you plan on doing more than light tuneup work, I highly recommend purchasing a manual for your car. We have for each of three vehicles a Haynes manual and it contains all the details on maintenance possible for the shade-tree mechanic. All are based on a complete rebuild.
Audi A4
Even if not doing a particular job, one can somewhat estimate what it will cost to have done.

May 17, 2010 | 1996 Audi A4

1 Answer

My audi a4 is blowing out cold air even when the


heater core clogged or heater valve

Jan 07, 2010 | 1998 Audi A4

1 Answer

We have a warm start problem with Audi 5000S Turbo 1985. Apparently gas is not available to car if engine is hot and turned off. Fuel pump seems to be ok. Was told it might be a valve in the fuel...


If the car is ok when cold then it is a heat related fault. The first thing to look at would be the coolant sensor for the ECU (this is like the auto choke) it is maybe giving an incorrect reading.

Nov 18, 2009 | 1985 Audi 5000 S

3 Answers

Hard to start on cold mornings but starts fine when warm


The cold start valve is not operating correctly. Either the engine coolant temperature sensor is bad or the cold start valve itself is bad. You can check the engine coolant temperature sensor by going to radio shack or any electronic store and purchase a 15k ohm or higher resistor. Disconnect the engine coolant temperature sensor (ECTS) harness. Bridge the 2 female spade connections in the harness with the resistor. Start the engine. If the engine starts you need to replace the ECTS. If the engine is still hard to start, you need to remove the cold start valve, (wear safety goggles, and whatever you do don't smoke) place the cold start valve in a glass and have someone crank the engine. You should see gas coming out from the cold start valve. If not take a ohm meter and measure the terminal at the cold start valve after disconnecting the wire harness. The meter should read 25 ohms. If it doesn't replace the cold start valve.

May 25, 2009 | 1992 Audi 80

3 Answers

96 audi a4 blowing cold air


yes, very possible. but first check your fluid level, thermostat.

Dec 06, 2008 | 1997 Audi A4

1 Answer

Audi A4 1998 1.8T


Sounds like a sticky valve or lifter, and the oil just isnt getting up there so quickly

Nov 05, 2008 | 1998 Audi A4

1 Answer

Audi 80e 1991 hard starting when cold


I've owned the same car. Check that the fuel relay 'primes' the system before you start the car. When you turn the key to the on position (all you dash lights, ready to start) you should hear the fuel pump run for a second or two. If it doesn't run you can replace the relay for about $30. If the relay is not the problem, it may be a check valve within the fuel line to the engine. This valve keeps fuel from draining back to the tank when the car is sitting. That way, there is fuel close to the motor when it's time to start. The temp senor was not a bad shot, they were thinking it was bad sensor not telling the cold start injector to run. Obviously not the case. However, the injector itself may be faulty in some way. As long as the car always starts, it's one of these problems, assuming the ignition system and engine mechanicals are in running order.  good luck. JK

Jul 05, 2008 | 1991 Audi 80

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14333 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...