Question about 2012 Buick Verano

1 Answer

P018b code problem occurs same time as p069e code - how to fix & will this make the car stall or quit?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Buick Master
  • 354 Answers

They are both fuel related codes. You should worry more about the repair than if you drive unless you want to drive it to get it repaired. The car will drive or will stall out. There is no definitive answer. Those are the only codes you get? Do you have any history codes?

Posted on Mar 24, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I was driveing a 2008 chevy tahoe ,it cut off, code p069e code come up, i buy a fuel pump, from pit boys, change the pump, drive the vehicle and it cut off again, cod p025A come up what cause it ?


Suspect a faulty fuel pump control module or wiring to it. This module is located back by the tank usually near the spare tire area. It is prone to corrosion

Sep 19, 2015 | Cars & Trucks

2 Answers

Codes P0191,P069E


P0191 is injector pressure sensor system performance. Nothing on the other code with the letter mixed in. I would erase it and see if it comes back.

Apr 14, 2015 | 2007 Chevrolet Chevrolet Silverado 1500

2 Answers

No check engine, stalls cold start, dies after warm


If you haven't done it already you might have them run it for codes to see if it is showing any. Autozone does it for free too.

Dec 23, 2013 | Hyundai Santa Fe Cars & Trucks

5 Answers

2009 Hyunda Santa Fe stalls while driving


I had a similar problem with my Santa Fe. It occurred intermittently but after I turned the steering wheel to the left. After much screwing around by the dealer and trying to baffle me with BS we heard about a strange solution. I am not a mechanic but the problem somehow related to a spring in the Airbag on the steering wheel. Changed the spring and "Stone the flame'n crows" problem solved. Never had a problem since.

Jul 27, 2012 | 2003 Hyundai Santa Fe

1 Answer

1989 olds ciera 3.3 A/T have had intermittent stalling problem no SEL light and when it stalls it always cranks right back up and will stall again does not matter hot or cold it will just start stalli


The overdrive solenoid in the transmission locks the torque converter, and at low speeds, if it activates or hasn't released from a high enough speed, it will cause stalling. If that is what's happening, it could be the solenoid, or the signal line to it from the ECM, or the ECM itself not working properly.

Jul 05, 2017 | Oldsmobile Cutlass Ciera Cars & Trucks

1 Answer

My PT Cruiser (2002) runs for 5 min., then stalls....5min. later it starts then quits again. P1391 code comes up.


P1391(M) Intermittent Loss of CMP or CKP Loss of the Cam Position Sensor or Crank Position sensor has occurredi know that you may not want to take this to a good mechanic, but it may be something simple, or it could be bad.

Mar 07, 2011 | 2002 Chrysler PT Cruiser

1 Answer

I have a 2008 sububrban that will not start and two codes p023f and p069e. The truck has the 6.0l engine, where do I start


It's either the fuel pump or the fuel pressure control module.
I have the same condition on an 08 suburban 1500.
I am going to replace both. The fuel pressure control module needs to be reprogrammed at the dealer after install from what I have read.
I'll let you know the outcome.

Nov 30, 2010 | 2008 Chevrolet Suburban

1 Answer

I think there should be a recall on Chevy Colorado engines, I've done some research and quit a few people has had the same problem....my 05 shuts off or tries to stall when coming to a stop, the engine...


Unfortunatley recalls are only put on vehicles when safety is concerned.

The stalling may be corrected by something as simple as cleaning out the throttle body. Electronic throttles are very sensative and need to be cleaned out every 20k miles.

The "service engine soon" light could be contributing or could be the cause for the stalling. You will need to find out what the code is.

What timing components are going out? Usually timing components dont "start to go out". So please clarify.

Condensation on the dipstick is normal. How is the water in the oil being determined?

Taking your vehicle to the dealer for service will keep you informed of what is going on with your vehicle. They will let you know of maintenance items, problems they have inspected, and potential problems that may occur.

Jan 28, 2010 | 2005 Chevrolet Colorado

1 Answer

Per diagnostic codes i have replaced CTS and MAF on 1993 Mazda 626 2.5 6cyl, now it stalls and quits at a stop, does this have to do with clearing the codes after the work is done, does the computer need...


u followed the pin point tests for these codes you had? did you disconnect the battery after you installed new parts? sounds like u have not fixed the problem, you do have a repair manual correct? did you check the intake air hose for cracks on the bottom which will cause a stall? did you clean the idle speed control valve and the throttle valve, they can also cause this stall, never adjust the the hard stop screw, it will chnage nothing and cause all kinds of other problems, it is not the problem, most likely the intake is sludged up clean it and then disconnect battery for 5 minuter, driv about 50 miles and problem should clear up, if it doesn't you have other issues, recheck for codes.

Oct 19, 2009 | 1993 Mazda 626

Not finding what you are looking for?
2012 Buick Verano Logo

Related Topics:

542 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...