Question about Suzuki XL7

1 Answer

I have a 2003 suzuki xl7. The battery terminal was shot, so I got it replaced. Then I got a full service oil change. Now (3 weeks later) I was driving fine all day and then all of a sudden it slowly c

They also said that it seems like the fuel isn't connecting.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 20,706 Answers

Slowly whats?
post symptoms and avoid guess, engine power needs about 5 things.
12vdc electric power at all time to the EFI system.
you cured that with new terminals.

  1. Good fuel, Gasoline, (ill assume its not a diesel?)
  2. good engine. (it must be good, that is have good compression and pump air like new. or its bad. (you never stated which engine )
  3. good spark and timed correctly
  4. good fueling, (too much floods, tool little it starves)

there are simple tests fore each case
do you want to guess or test? it's your decision.
ever check all fuse:
or scan the PCM for ERRORS< (if not that is missing the boat)

and last but is really first ever consider that 60k mile tuneup.?
every 60k, dont skip those or it will fail..... i promise.

Posted on Mar 24, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: the engine will turn over but will not crank.

check your ecm/ign fuse in the fuse panel inside the car

Posted on Sep 01, 2008

  • 2187 Answers

SOURCE: Just replaced the battery on

To check if it is the fuel pump check at the end of the fuel lines at the engine bay if fuel comes out when cranking. You can take out the hose from the end that goes to the filter and see if fuel comes out. While cranking the EFI should be sending power to the pump to run. If there is none, then see if you can have the fuel ump directly connected to the battery. If it runs then you may have an issue with the relay found under the passenger side of the dashboard or the wirings.
If the fuel that comes out is weak, the fuel pump may also need replacing.

Posted on Jul 26, 2009

  • 7353 Answers

SOURCE: 93 gmc sierra 5.7 liter engine, injection carb,

you say you replaced the fuse, but does the fuse have power? the gray wire at pump should have power when cranking, or for 2 seconds when turning key on. At fuel pump relay, put power onto gray wire, the pump should run if the wiring is good. if it doenst run then ck for power at fuse while power is on gray wire.

Posted on Oct 19, 2009

RonPark
  • 855 Answers

SOURCE: While driving to school today, my car died while

First you need to see if you have a fuel or ignition problem. Also check and make sure the timing belt didn't break. Chek and make sure you are getting spark. Check the timing belt first. You need to know if the crank and cam are both turning. The v=crank is if the motor is turning over, so you have to check the cam, look for an access hole or a place to see if the cam is turning. If it shut off going down the road this is a possibility. Try checking it out if you have a problem leave a comment and I'll get back to you.

Posted on Oct 31, 2009

wireguy212
  • 1627 Answers

SOURCE: the replace of the fuel cap on the gas tank did

The next thing for you to try is the vent tube coming out of the gas tank fill spout,also get the codes read because many other things can put the light on and reading the codes will point you closer to your problem.

Posted on Dec 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiring diagram wipers 2003 Suzuki xl7


in what country?
you left off the dash, XL7 is not a XL-7 but 2003 is best clue.
usa
$4 see the real book, not fake, official

https://suzukipitstopplus.com/Products/10057-2003-grand-vitaragrand-vitara-xl-7-service-manual.aspx

Mar 05, 2017 | 2003 Suzuki XL-7

2 Answers

I have a 2007 Suzuki XL7 is it true that after disconnecting battery over a week, you have to reset computer


Usually, disconnecting the battery for more than half an hour will reset almost all computers. It will then have to go through a "re-learn" cycle. You'll use more gas until it does that and it may not run quite right.

Jan 25, 2017 | 2007 Suzuki XL-7

1 Answer

Change front. Axle in Suzuki xl7. 2003


try to be specific.
no bad part was named, or job or anything.
what's yah do'n mista? anon.?
so are you replacing the whole AXLE total.
or just one part of and axle, , 4WD setup.
touch the part, and say what you are doing,first.
then ask for help.
no matter, you could have read at alldata.com , its there.
and at, omg suzuki,.

what if the axle does not want to change>? LOL.

Sep 19, 2014 | 2003 Suzuki XL-7

1 Answer

My change oil light soon light won't go off. My oil and filter were changed 2 weeks ago and my husband forgot to reset it in our 2007 Suzuki XL7. We just bought this car a month ago and the oil li


it wont go away because their is a mechanical problem and or problem with oil change [ not enough oil wrong filter etc ] will need to have vehicle scanned for the fault code to determine the problem most auto stores offer this service for free

May 17, 2017 | 2007 Suzuki XL7 AWD

1 Answer

Drive belts replacement procedure for suzuki xl7 2003


follow the routing diagram under the hood loosen the belt tensioner it only takes about 20 minutes to change your belt.

Aug 29, 2009 | 2003 Suzuki XL-7

1 Answer

I need a maual for a 2003 Suzuki Limited Edition XL-7


You might be mistaken about the check engine light. I have done all the oil changes on my wife's 2003 XL7 and never once have I had to reset anything. If you mean the SERVICE ENGINE SOON lamp, that means the computer detected a problem with the emission control (or someone didn't put the gas cap back on correctly during the last trip to the gas station). Check the gas cap 1st, just take it off and put it back on, making sure to give it a few "clicks" past the stop. If after a few days the light doesn't go out head over to a suzuki dealership and have your ECS checked out.

Mar 28, 2009 | 2003 Suzuki XL-7

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...