Question about 1988 Toyota Cressida

Open Question

Toyota cressida problems

Only power on central locking and light lights up around ignition.But electronic dash doesn't light up and no power on motor

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1989 tOYOTA CRESSIDA sAPRK PLUGS WELLS. OIL IN THE SPARK WELL

The 7MGE has 2 separate valve covers/gaskets with 8 screws holding each cover that will loosen over time.
Find the phillips screws holding on the covers and retighten snugly by hand do not overtighten!
Pull plug boots/wires by the boot not the wire and use paper towels or rags on a long screwdriver etc to absorb the oil from the wells.
Carefully clean plug boots with spray brake cleaner (avoid spraying anything but the boot) and let dry.
Apply 100% silicone grease to inner boot before reinstalling to allow future removal without damage.
If your engine is particularly dirty you may need to remove the covers first and clean all mating surfaces then reinstall.

Posted on Apr 23, 2009

  • 1861 Answers

SOURCE: 2003 Toyota Camry - Both Brake lights not working

Lok in the trunk on the left side, behind the carpet for a small plastic box with a bunch of wires going to it. Look to see if there is brake light powe coming in with the pedal depressed. If so, and no power is coming out, you need to order and replace the "taillamp failure sensor".

Posted on Jul 16, 2009

  • 43 Answers

SOURCE: central locking not being activated by remote

somehow the car when on valet mode, go to a alarm shop , they should be able to re arm your car without to much damage to your pocket, or read your cars manual, it might inform you on how to fix the problem.

Posted on Sep 23, 2009

  • 1 Answer

SOURCE: 98 toyota corolla radio, dome light, and power locks don't work

2005 toyota corolla radio,dome light,alarm and power locks dont work.

Posted on Nov 20, 2009

  • 75 Answers

SOURCE: 1991 Toyota Camry, tail lights and dash lights don't work

Have you looked under the hood? There are more fuses under the hood. Is your dimmer turned down on your dash lights?

Posted on Jan 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 Cressida How do i know if my alternator is bad?


if the alternator is not charging , there will be a red battery light on the dash
reasons for engine stopping are
broken timing belt/chain, cam/crank position sensor failure
immobilizer activation
ignition control module failure
run the fault codes as some engine lights only light up for urgent problems that require you to stop the engine

Oct 08, 2016 | 1991 Toyota Cressida

1 Answer

Why my car rpm jumps


Many things cause rpms to fluxuate. I.e. dead miss due to faulty or failing spark plug or plug wires. Or any of the ignition components is the ck engine light on dash flashing when rpms "jump"? This will tell you wether or not the problem is a miss

Feb 12, 2015 | 1989 Toyota Cressida

1 Answer

2000 Corolla won't start.


See, the starter gets power from the battery it also gets power from the ignition switch. When you turn the key the solenoid closes and supplies power to the starter motor. So if you are hearing a click the solenoid is getting getting a signal from the ignition switch. Check for power from the solenoid to the starter motor. If it lights up that means power is being transferred to the motor and the motor is either bad if it doesn't turn the engine or the engine is locked up.

Jun 17, 2012 | 1982 Toyota Toyota Cressida

1 Answer

1989 Toyota Cressida ,won't start. Battery is


Check starter, spark and fuel pressure.

Apr 13, 2012 | 1989 Toyota Cressida

2 Answers

I have a toyota cressida gli 6 1989 ,has spark and fuel,motor swings but just wont start


Where had you checked spark first? Is the distributor turning? This can be checked by removing the distributor cap and making sure the shaft is turning as the engine cranks. Have you checked that there is spark at the plugs? The ignition coil could be weak and still produce some spark but not enough to start the engine. Be cautious of all rotating belts and pulleys around the engine while working under the hood.

May 19, 2011 | 1989 Toyota Cressida

1 Answer

When I turn the ignition key in my '90 Cressida


Do the dash lights come on with key on?Try starting it in neutral.Turn key on,and foot on brake,and shift the gear shift into drive,and back into park,kind of hard,Now try to start it.Let me know right what happens,we will go from there.

Aug 29, 2009 | 1990 Toyota Cressida

1 Answer

1987 cressida missing


Start with testing the injectors for pulse. Get a NOID light they sell the at almost any auto parts store remove in get plug from injector and plug the noid light into plug look for constant steady (pulse)lighting of noid light. Check all six injector on your strait 6. If all is good remove parke plug wire on at a time from cap and look for increased shaking and less when it replaced(Make sure to use wire puller with rubber insulation to avoid being zapped by spark from coil) Note cylinder with no difference or change when wire is removed. Those would be the problem cylinders. Then get a compression guage and check all cylinders for compression by removing spark plugs and attaching guage to each cylinders, make a not of each cylinder's reading. NOTE THEY SHOULD NOT BE MORE THAN 10 PSI difference in cylinders. Make note of low compression cylinders if any. If compression is good all around spark plugs are good, good ignition wires and you have good pulse pattern from you noid light. The only other problem is BAD INJECTORS and those would be the ones that didn't change when you took off the wires. I have work on these old cressida alot my self. Good Luck contact me if you need more help and if I solve your problem leave me a FIX-YA comment.

Dec 17, 2008 | 1987 Toyota Cressida

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...