Question about 2001 Dodge Ram 2500 Truck

1 Answer

Code p0122 truck will start and than shut off

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 88 Answers

Sounds like the throttle position sensor is bad. I would replace the TPS since it's a cheap insurance. It cost anywhere from $26-$57 at http://www.autopartswarehouse.com/shop_parts/throttle_position_sensor/dodge/ram_2500.html

Hope this fixes your problem.

Posted on Mar 24, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Part= po122 1997 chevy pu truck


https://www.obd-codes.com/p0122
Throttle position sensor maybe shorted , bring down the five volt reference circuit inside the PCM . The PCM supply's a few different sensors with a constant five volts .
How to check the 5v reference circuit for short to ground Cadillac
How to test throttle position sensor P0121 P0122 GM wiring integrity...

Sep 08, 2017 | Cars & Trucks

1 Answer

Reset code for a 2011_akia rio throttle position sensor


Throttle Position Sensor Replacement - YourMechanic

www.yourmechanic.com > Auto Repair and Maintenance Services
When the throttle position sensor is repaired or replaced, it will need to have the minimum idle speed reset to factory specs, and the trouble codes will need to be ...

P0122 Code - Throttle Position Sensor/Switch A Circuit Low ...

www.obd-codes.com/p0122
Also includes links to other forum threads discussing the code. ... P0122 Code -Throttle Position Sensor/Switch A Circuit Low Input ... I have 6 codes that stay the same. all the rest don't stay after reset. codes are P0106,P0107,P0108,P0122 ...

2002-2005 Kia Sedona Throttle Position Sensor ... - YouTube

? 1:51
https://www.youtube.com/watch?v=JRwUK2Iem9s
Jul 11, 2011 - Uploaded by Jerry Ferguson
Kinda important - Before removing the old throttle position sensor, snap a photo of its position with your phone ...

Dec 26, 2015 | Cars & Trucks

1 Answer

Vw golf 2.0 codes p0122 p0222 p1296 p0638


Hi, have there been any running issues. I have replaced a few acclerator pedal units due to the codes. p1296 is different and further diagnosis would be rquired as this is a general cooling system fault.

Mar 20, 2014 | 2001 Volkswagen Golf

1 Answer

1998 chrysler concorde code P1684 P0122


P01684 just says that the battery has been disconnected within the past 50 starts. If you have already replaced the TPS and still get the P0122 code, it could be a short in the wiring or a problem with your Powertrain Control Module. Other names for the PCM is ECM and ECU. Engine Control Module and Engine Control Unit

Mar 02, 2013 | 1999 Chrysler Concorde

1 Answer

Got ecu codes p1693,p0232,p0215,p1689,p0230,p1488,p0122,p0522,no start yet


P0232....Fuel Pump Secondary Circuit High


P0230....Fuel Pump Primary Circuit


P0215....Engine Shutoff Solenoid


P0122....Throttle/Pedal Position Sensor/Switch A Circuit Low Input


P0522....Engine Oil Pressure Sensor/Switch Low Voltage

Nov 01, 2010 | 2001 Dodge Ram 2500 Truck

2 Answers

P0122 and po700


HI. Lets start with the P0122 Code.

This code is in reference to the TPS(Throttle Position Sensor). A P0122 code essentially means that the the vehicles computer has detected that the TPS is reporting a low voltage condition. On some vehicles, the lower limit is 0.17 - 0.20 volts, respectively. This can occur if the TPS was not recently installed correctly or mis adjusted. If you have not installed it recently, than the most likely actions are to replace it, asap. Here are the most common symptoms listed below:

1. Rough idle
2. stalling during acceleration or stumbling at a red/stop light.
3. poor acceleration

If you are not experiencing those symptoms, it will most likely be intermittent and clearing the code may resolve the problem for a short time. If this should be the case, i would check the wires for rubbing against the housing or grounding faults. Again, make sure it is adjusted properly if recently installed.


The next code will be the P0700.

This is a serious transmission control unit code. You will need to take this vehicle to the dealership for the correct scan tool. You will need to extract the special codes to actual repair, correctly. Usually, the entire module will need to be replaced. A regular scanner will not pick up the TCU codes. This is a dealership code. Most Kia's are covered with a 10 year/100,000 warranty, so this should be covered.

Aug 24, 2010 | Kia Sorento Cars & Trucks

1 Answer

What is Codes PO122 & PO303?


P0122 = TPS (throttle position sensor) voltage reports too low. This means that you could have a problem with the TPS, the wires to the TPS or the computer, if you have not replaced the TPS or do not want to do this work, I would take it in to a shop for this to be done. The TPS may require adjusting after replacement.
P0303= Cylinder Number 3 Missfire Detected, this means that the number 3 cylinder has miss fired, probably set this code as a result of the P0122 code. I would repair code P0122 and clear both codes. Hope this helps, let me know.

Aug 04, 2010 | Ford Ranger Cars & Trucks

2 Answers

Check engine light came on trouble shooting code is P 0122


Code P0122 is a TPS (Throttle Position Sensor) sensor out of range.

The operating range of the TPS is about .5 to 4.8 volts. .5 at idle 2.5 at half throttle and 4.8 at full throttle.

This can be checked easily with a scanner. But can be checked with a multi-meter.
P0122 Tjrottle Position Sensor low voltage

You can try replacing it for a start and see what happens
(location image)...

f1c255f.gif

Hope this help.

Mar 29, 2010 | 2005 Kia Sedona

Not finding what you are looking for?
Cars & Trucks Logo

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...