- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
DTC C1221 LF Wheel Speed Sensor Input Signal is 0
C1222 RF Wheel Speed Sensor Input Signal is 0
DTC C1226 RF Excessive Wheel Speed Variation
DTC C1232 LF Wheel Speed Circuit Open or Shorted
DTC C1233 RF Wheel Speed Circuit Open or Shorted
DTC C1291 Open Brake Lamp Switch Contacts During Deceleration
DTC C1291 detects an open brake switch. The EBCM looks for deceleration rates that may indicate braking action. The EBCM verifies braking action by repeating the method for finding deceleration rates that indicate braking action several times. In each case, the ABS will not be available because the EBCM does not see the brake switch input.
DTC P1106 Manifold Absolute Pressure (MAP) Sensor Circuit Intermittent High Voltage
DTC P1887 TCC Release Switch Circuit (3.4L)
DTC P1887 TCC Release Switch Circuit (2.4L)
The torque converter clutch (TCC) release switch is part of the automatic transmission fluid pressure (TFP) manual valve position switch. The TFP manual valve position switch is mounted to the transmission valve body. The TCC release switch is normally-closed.
The switch signals the PCM that the TCC is released. This is accomplished by torque converter release fluid pressure acting on the switch contact, thus opening the switch. When the voltage is high on the circuit, the PCM recognizes that the TCC is no longer engaged.
When the PCM determines that the TCC release switch is open (indicating that the TCC is not applied) and the TCC slip speed indicates that the TCC is applied, then DTC P1887 sets. DTC P1887 is a type B DTC.
You have all kind of problems , I suggest you take this to a qualified ASE certified repair shop that has the diagnostic tools to trouble shoot an repair the vehicle . Electrical testing is a must with open circuits an shorts ,plus hooking up a scan tool that reads sensor data .Not just a code reader like at the parts store . This video he has a Chrysler vehicle ,doesn't matter . Test is the same for all make an models !
If you found blackened transmission fluid in an automatic transmission - I'd say you found your problem! I'd be willing to bet the discoloration is material from internal clutches that has been worn off and caused overheating. Sorry, but this will likely require rebuilding or replacing.
Have a look here for add'l info on tranny oil color:
P0452 evap control pressure low, P0 446 evap vent contol circuit. Becuase you have P0452 you are dealing with a eletrical issue whether you have positive tank pressure or negative pressure, The tool for this is a volt meter.452 happens when you positive pressure and the FTP reads less than 0.1 volts.You need to jump the signal and the reference and monitor the take parameter on a scan data you should read reference voltage.Now if you dont have a scan data tool. inspect the wire for any breaks or shorting 2 thing of concern broken wire to the FTP or a ECM is needed.