Question about 2007 Dodge Ram 2500 Mega Cab Laramie

1 Answer

2007.5 AC CLUTCH WILL NOT ENGAGE

NO POWER TO AC CLUTCH

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 14,585 Answers

Several things can cause this. On the inside. The controller could be bad. The wires could be shorted. a blown fuse. Under the hood. Wires could be bad. high and low sensors could be bad. LOW on refrigerant. Engine control module(ECM) could be bad. All of these will cause NO power to the clutch.

Posted on Nov 12, 2014

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3600 Answers

SOURCE: freon level full but clutch wont engage

find the reciever dryer you will see a two wire device connected to it, pull it off and install a paper clip in it with enginge off then start and see if the ac cools, if it does replace the switch it just unscrews and is called the low pressure switch.

Posted on Jun 20, 2009

  • 25 Answers

SOURCE: On my 2007 Dodge 2500

there is no relay in that box that is called the tipm or totally integrated power module. that module is controlled by a computer and should be checked with a scanner to see if you have a code for the a/c. i m having the same problem i have been told it could be low freon but can not get the clutch to engage to check the high and low pressure. Also read where it may be the diode in the clutch on the ac compressor if you have a multimeter probe the compressor a good compressor will read somewhere between 3.5 and 4.0 anything else and clutch needs to be replaced. other possibilities may be the high or low pressure switch on the line. on myh 2006 2500 diesel it is located near the plug for the compressor on bottom side of motor. hope this helps.

Posted on Feb 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2007 Nissan Altima with AC clutch doesn't engage.


FIRST SEE IF POWER IS GOING TO THE RELAY. IF 'YES' YOU NEED TO CHANGE THE RELAY.

Jun 15, 2015 | 2007 Nissan Altima 2.5

2 Answers

Why won't my 2007 expedition ac clutch engage


Is the system full of freon ? Is the clutch getting power from the relay ??

Aug 05, 2014 | 2007 Ford Expedition

2 Answers

Ac location relay


If the Freon is low then the a/c clutch will not cut on.There should be a fuse box under the hood and the relay will be in it.

Apr 01, 2014 | 2007 Mercury Milan V6 AWD Sedan

1 Answer

97 chevy suburban AC clutch won't engage pressures


Looks like the low pressure switch gets power from a 10amp ac fuse. Power then goes to the ac relay which is powered on by the ac heat controller on the dash. Power then goes thru the high pressure switch to the compressor. The ac relay is grounded to the body. Do you have power on the lite and dark green wires going into the relay and is it grounded ?

Jul 26, 2013 | Cars & Trucks

1 Answer

My 2007 honda crv a/c clutch won't engage


Could be the ac relay or the clutch itself might be shot

May 20, 2012 | Cars & Trucks

1 Answer

2007 Dodge 2500 5.9 diesel. When you turn on AC you can see clutch try and engauge and after 3-4 tries it stops. No AC. If drive around for a while AC starts to work after engine heats up?


Working same problem today on my 2006 Mega Cab Diesel. 2 possibilities. Either the compressor clutch coil is going bad ( totally integrated power module tries to engage it a couple of times, senses the coil resistance is wrong and shuts down) or the TIPM (Total Integrated Power Module) is bad. I'm leaning toward clutch on compressor but still have testing to do to isolate. Could be both, but I doubt it. New TIPM is about $900 it appears from what I read. New compressor is cheaper. May be able to replace just the clutch coil for even less but reading mixed results. Good luck.

Aug 05, 2011 | 2006 Dodge Ram 2500

1 Answer

On my 2007 Dodge 2500 diesal the AC clutch will not engage. I found the fuse box under the hood and there is only one 10 amp fuse that says hvac. so where is the clutch relay or fuse? Which big fuse...


there is no relay in that box that is called the tipm or totally integrated power module. that module is controlled by a computer and should be checked with a scanner to see if you have a code for the a/c. i m having the same problem i have been told it could be low freon but can not get the clutch to engage to check the high and low pressure. Also read where it may be the diode in the clutch on the ac compressor if you have a multimeter probe the compressor a good compressor will read somewhere between 3.5 and 4.0 anything else and clutch needs to be replaced. other possibilities may be the high or low pressure switch on the line. on myh 2006 2500 diesel it is located near the plug for the compressor on bottom side of motor. hope this helps.

Aug 22, 2010 | 2006 Dodge Ram 2500

2 Answers

A/c has full freon but the compressor clutch wont engage. i have found that the plug going into the compressor is not getting any power. what could be the problem?


On the low pressure line of the ac you have a pressure switch which allows the compressor to come on once a certain pressure is reached, and it will cut the compressor off if the pressure is too high or too low. Look at your ac hose and find the switch *you will see wires connected to it* you may need to replace this switch. You can use a test light to see if you are getting power to the switch. You should check you fuses, and the ac relay witch is usually in a black plastic box under the hood.

Aug 10, 2010 | 1997 Ford Crown Victoria

1 Answer

Should the AC compressor clutch engage when the


yes. the ac removes moisture from the cabin of your car. if it is not engaging that is why your windows are fogging up. you need to have the ac pressure checked. you may just need a recharge.

Jan 02, 2010 | 2002 Ford Taurus

1 Answer

Freon level full but clutch wont engage on a 3500 2007 dodge pickup . It is a diesel. power to clutch .46000 miles on pick up.


find the reciever dryer you will see a two wire device connected to it, pull it off and install a paper clip in it with enginge off then start and see if the ac cools, if it does replace the switch it just unscrews and is called the low pressure switch.

Jun 20, 2009 | 1988 Dodge D-Series Pickups

Not finding what you are looking for?
2007 Dodge Ram 2500 Mega Cab Laramie Logo

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...