Question about 1996 Toyota Camry

1 Answer

Fan relay camry

Odometer not working

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 220 Answers

First of all check fuse. then check relay and last check fan there maybe a cut cable or lose. check all

Posted on Mar 23, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does ecu switch look like for 2000 toyota camry


Check fans work [jump w/12volt] Check fan relay for power coming in from ecu. this is your computer

Oct 03, 2012 | 2000 Toyota Camry

1 Answer

AC and Cooling Fans Not Working


Try installing a jumper across the N/O terminal at the relay socket. Temp sensor in the radiator or in the thermostat housing supplies the signal for the relay the other relay signal is supplied by A/C in on position. both fans will run continuous with A/C on. One fan runs intermittent relative to water temp. Be careful not to blow a head gasket. If you leave the jumpers in place, the fans will stop when the ignition is turned off, save the engine until you isolate the relay signal problem. then simply remove jumpers and reinstall the relays

Feb 28, 2017 | 1989 Toyota Camry

1 Answer

Radiator fan not working on my 95 toyota camry


It could be:

- blown fuse (RDI -M fuse, 30A, in Relay block 5)
- failed relay (fan relay, same location)
- failed engine temp sensor (quite likely)
- broken wiring connector
- failed fan motor (not that likely)

Test procedures are here, after p261

http://www.turboninjas.com/camry/eg1.pdf

Dec 25, 2011 | 1995 Toyota Camry

1 Answer

Fans not working/Overheating


Probably the temperature sending unit...if not that the relays...they should be relatively cheap and easy to replace...

Mar 31, 2017 | 1989 Toyota Camry

1 Answer

Fans Not Working


Yes it COULD be a bad relay. But then again, it COULD be a malfunctioning A/C high pressure switch or a bad engine coolant temperature switch, or bad ground circuit, or any of the wiring in-between. If your Camry is equipped with the 2.5L engine, it could also be the radiator cooling fan control amplifier.The system must be properly diagnosed to locate the source of the fault.

Nov 26, 2011 | 1989 Toyota Camry

1 Answer

My odometer, speedometer, gas gauge, temperture gauge and rpm gauge do not work. I've checked the fuses but have not located a problem. What should I look at to evaluate this problem?


there should be a relay box under the hood on the right hand side it should say fuse/relay center under the lid is listed all the fuses and relays there should be one thats for the dash board

good luck!

Sep 06, 2011 | 2002 Toyota Camry

2 Answers

Fan


You have to check the main relay fan fuse relay and disconnect the fan and try it directly to make sure the fan motor is fine if all this is well into the cavity where the thermostat is a thermal switch that sends it relay the signal to the fan you can disconnect and the fan has to start working if this works the problem is you have the thermal switch. Thanks

May 10, 2010 | 1998 Toyota Camry

2 Answers

98 toyta camry with hermo fans staying on all the time


it may have a stuck coolant fan relay find and unplug the relay switch with a know good relay and if it works properly replace relay

Oct 19, 2009 | 1998 Toyota Camry

1 Answer

Instrument cluster does not work.


check the relays under the kick panel on drivers side...maybe switch them around and see if that works....sometimes corrolas will do the same thing.check the ones under the hood also.

Jul 25, 2009 | 2001 Toyota Camry

Not finding what you are looking for?
1996 Toyota Camry Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...