Question about 2006 Ford Mustang

1 Answer

ABS lite on

ABS lite is on and TCS will not engage

Posted by on

  • bob maine
    bob maine Mar 23, 2014

    Fault code C1155 Front Left Wheel speed sensor, went to remove while waiting for replacement found a squirrel or mouse had chewed wires.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 27 Answers

Your antilock brake system is malfunctioning due to low fluid or excessive brake wear. When this system is malfunctioning, your traction control system is prevented from operating by the master control module. Take your car down and have your brake system checked. This is not for the typical do it yourself mechanic at home. The most important thing on your car is it's ability to stop before causing something or someone some real problems.

Posted on Dec 13, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i reset my traction control


Is your trac light lit ? If so it has a problem an till it is fixed , you can't reset it. Need to have it checked for DTC'S - diagnostic trouble codes .
If the ABS control module detects a malfunction, it will disable TCS and will command the BCM to turn the TRAC LED Off. The driver can also disable TCS, if desired, by depressing the TRAC switch. When the driver depresses the TRAC switch, the ABS control module will disable TCS and will command the BCM to turn the TRAC LED Off.
DTC C0276 TCM Traction Control Not Allowed
DTC C0275 or C0276
The TCM sends a serial data message to the electronic brake control module (EBCM) indicating that torque reduction is temporarily not allowed.
DTC C0550
DTC C0896
The electronic brake control module (EBCM) is required to operate within a specified range of voltage to function properly. During antilock brake system (ABS) and traction control system (TCS) operation, there are current requirements that will cause the voltage to drop. Because of this, voltage is monitored out of ABS/TCS control to indicate a good charging system condition, and also during ABS/TCS control when voltage may drop significantly. The EBCM also monitors for high voltage conditions which could damage the EBCM.

Oct 16, 2015 | 2004 Saturn VUE

1 Answer

ABS light come on when i am towing


the tcs system is detecting the weight and sway of the trailer because the load on the hitch is too much- that's the simple answer.

The ABS and TCS work together - the ABS system is what detects wheel spin and tell the TCS which diverts and/or control power.

Oct 08, 2014 | 2008 Mazda MAZDA6

1 Answer

Light abs traction control stays 1998 buick park avenue


PRE-DIAGNOSTIC INSPECTIONBefore diagnosing ABS/TCS, perform a comprehensive visual inspection of system as follows.Check ABS/TCS wiring harness connectors for looseness. Check harness routing; pay particular attention to wheel speed sensor wiring harness routing. Check fuses No. 1D, 5B and 6B in instrument panel fuse block. Check fuses No. 1 and 2 in underhood fuse block. Check brake fluid level in master cylinder reservoir. Check brake fluid level in Pressure Modulator Valve (PMV) assembly reservoir. Ensure parking brake is fully released. Ensure parking brake switch is functioning properly. Always perform ABS/TCS system functional check before using DIAGNOSTIC CODE CHARTSThe EBCM/EBTCM has self-diagnostic capability, which can detect system failures. Fault codes stored by EBCM/EBTCM can be displayed using Tech 1 scan tester. There are no provisions for flash code diagnostics.Begin ABS/TCS diagnosis with PRE-DIAGNOSTIC INSPECTION procedure. If failures are found during pre-diagnostic inspection, perform necessary repairs, and proceed with ABS/TCS FUNCTIONAL CHECK. See Fig. 5 .If no failures are found during pre-diagnostic inspection, go to ABS/TCS FUNCTIONAL CHECK. See Fig. 5 . The ABS/TCS FUNCTIONAL CHECK will either indicate ABS/TCS is functioning properly or direct technician to various diagnostic procedures such as diagnostic charts, symptom diagnosis or BRAKE warning light diagnosis.CHART D - TRACTION OFF WARNING LIGHT ON CONTINUOUSLY & NO DTC SET (BUICK WITH UH8 OR U2A INSTRUMENT CLUSTER)Circuit DescriptionWhen ignition switch is first turned to RUN position, EBTCM goes through a self-test, which lasts 2-4 seconds. During self-test, EBTCM commands TRACTION OFF indicator warning light on. Powertrain Control Module (PCM) can also command EBTCM to set a Code 75 which will illuminate TRACTION OFF indicator.Traction control switch is located either on instrument panel center trim plate or driver's front door trim panel. Switch allows driver to select traction control mode (on/off). When traction control system is turned off, TRACTION OFF warning light comes on.EBTCM monitors transaxle temperature through

Jul 12, 2014 | 1998 Buick Park Avenue

1 Answer

The tcs and abs lites are on when I turn my car on. why?


Both systems use the sensor units at the wheels . I would be looking for a loose wire or a faulty sensor at the wheel units.

Oct 28, 2013 | Cars & Trucks

1 Answer

2006 vw touareg esp engaging when not necessary 2006 VW Touareg stability control engaging when driving normally on road, making a loud mechanical noise


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 16, 2012 | Cars & Trucks

1 Answer

Abs & TCS-off dash lights both stay on. Pushing the TCS off switch does not help. "seem" to stop fine. Emergency brake seems to be fully off, not dragging. My wife encountered a patch of ice...


Hello: If there is a problem in the ABS it will bring on the tcs light as well. To determine what is causing the problem you need to have the ABS checked with a scanner to get the code. Then trouble shoot the components that the code leads you to. Normal braking is available with the light on but TCS is not as it relies on ABS for functioning the TCS.

Mar 04, 2011 | 2008 Saturn VUE

2 Answers

What is the TCS


TCS is used to control wheel spin by utilizing the ABS system. When a wheel is detected to be spinning more than it should, the TCS triggers the abs system to activate to slow down the spinning wheel. The TCS should only trigger at speeds under 20mph

Oct 19, 2009 | 1999 Acura TL

1 Answer

My chevrolet express 2500 has a problem . the ABS/TCS


This could be a little hard for the average person to fix. C0055 is the reason the ABS lite is on and it has to do with the speed sensor circuit. PO502 is also related as it has to do with the VSS circuit and will require some specialized equipment to correctly diagnose and repair, Sorry.
PO753, Locate the fuse block on the IP. Now locate the "IGNITION 0" fuse and replace it because it is blown.This will correct the P0753 code and correct the transmission shift inhibit problem.

May 18, 2009 | 2003 Chevrolet Express

2 Answers

2002 honda accord tcs light comes on and will not go off


I assume tht is traction control. Check fuses ,eeven abs fuses ,traction control is part of abs. If fuses ok will need scan tool to find cause of lite going on. Most common are abs sensors and broken abs wires. And if abs tone ring is part of axle shaft some rock may have damaged teeth of ring .

Apr 23, 2009 | 2002 Honda Accord

Not finding what you are looking for?
2006 Ford Mustang Logo

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...