Question about Cars & Trucks

1 Answer

Chrysler lhs 2001 turning switch

My signals or emerg lights wont come on i was wondering if its my flasher or switch how do i figure out? interior light do come on, outside lights do come on i did notice one burnt light bulb in my back window, however my turning lights wont come on or show up on my dash as on please help a single mom that cant waste money ,thx

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 354 Answers

Dear single Mom can't waste money. The relay that governs both the turn signal and the hazard lights is located behind the steering wheel in the steering column. If the lights do not blink, this could be bad or it may be the switch itself.

This repair can be done easily with a little mechanical knowledge. The top plastic of the steering column has to be remove. There is a relay, about 1inch cube on the back of the signal switch. It is usually black but could be gray or any other color. I do not think it comes in pink though! (Haha)! That is the first thing you change. It just pulls out. When you replace the new one, make sure the orientation of the pins are correct. It will only go in one way.

I hope this helps but please be careful if you are going to do it yourself or have someone with no mechanical ability try to do it!

Posted on Mar 23, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2001 tp cruiser turn signals wont flash

check the flasher relays in the fuse box. these are what causes the lights to flash.

Feb 11, 2014 | Chrysler Cars & Trucks

1 Answer

1997 chrysler LHS owners manual

You might find a used manual on Ebay. The turn signals and hazards are on two different circuits, so different fuses and flashers.

Aug 28, 2012 | 1997 Chrysler LHS

1 Answer

No turn signals

Does anything light up? Have you checked fuses? Have you checked the flasher? Let me know if you have any questions and I'll do my best to answer them. Thank you for using!

Feb 19, 2012 | 1995 Chrysler LHS

1 Answer

The turn signals have stopped working. The fuses are ok, what could be the cause?

Your flasher unit could be bad if even your hazards or emergency lights don't work.

Check that and if that is not it, you could have gotten a short circuit in the system and burnt all bulbs which is less feasible but still possible.


Feb 12, 2011 | 1996 Chrysler LHS

2 Answers

Turning signals not working all the time

Sounds like the blinker relay. Is the emergency flasher switch on the dash above the radio ? If it is the blinkers relay is the same as the emergency relay. If the blinkers stop working pound on the emergency lights switch and if they start working then replace the emergency lights relay switch cause the blinkers is on the same relay as the emergency lights. My 2001 Grand Am does the same and I just hit the emergency lights switch and they start working again.

May 27, 2010 | 2001 Pontiac Sunfire

1 Answer

Turn signals/hazards not working on my chrysler lhs 1999 I changed fuses and flasher still no luck not even lightning up on the dash

if you have power when key is on for turn signals on both sides of the fuse,you will probably need to replace the multi function switch

Dec 03, 2009 | 1999 Chrysler LHS

1 Answer

Turn signals in96 LHS chrysler won't work

did you replace flasher solenoid, see if the emergency flashers work all around vehicle, if not then replace bulb that does not flash

Jul 30, 2009 | 1995 Chrysler LHS

2 Answers

Audi tt quattro turn light is not Blinking-stays on

The signal flasher is within the emergency flasher. It will usually make a lot of clicking noise when faulty though. Check all the bulbs on the car for proper operation. Good luck!

May 26, 2009 | 2001 Audi TT

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides