Alarm system service required

The alarm would cause the car not to crank, and the alarm horn would sound. You can try unlocking the car from the trunk lock to disarm the alarm. But crank and no start could be a bad ignition switch. Do the dashboard lights stay on or go out while the key is in the crank position? They should remain "on". Worn ignition switch could cause the car to crank but not start.

My vue wont start and the battery is good and my alarm system wont stop...

get your car fix right now

Aftermarket car alarms/remote start systems are difficult to install in newer cars since many of them already have alarm systems and immobilizers in place. The aftermarket manufacturer will specify additional modules that must be purchased and installed in order to successfully integrate their product into your vehicle without causing conflicts. Some of these modules are expensive and some even require you to have a spare key for the vehicle to install into the module for it to work. Without more details on your vehicle (Manufacturer/year/model) and the alarm manufacturer ( and model), all I can make is generalizations as to what your problem is....

although you can open the door with a key ,unless the alarm system senses a fob key signal it will assume that the door is being opened illegally and will set of the alarm
keys can be cut for all cars requiring a key fob unit but the alarm is not cancelled and the engine will not start
you may have to get another key fob and have it programmed to the ECM system

The person(s) who serviced your alarm should be able to tell you if you have siren or horn type.. We have NO idea what alarm system you have..Volvo has many alarm systems. Ti reset you service light you need an OBII scanner - You can have any good shop or auto parts store do it for you.

Try "cycling the key in the passenger door lock. Turn it all the way to the right and all the way to the left.

Try to remove the After Market alarm only. The other might be the FACTORY alarm. Might want to leave the factory one in the vehicle.

The message is trying telling you that the system has a fault and most likely the control module has disabled the system. After the problem is fixed the message will clear. You can have the system tested by Volvo to see what part of the system has a fault, most likely they will charge about 1 hour labor time.

Try this:
1.Get in the car
2. Closw the door
3. Disable the alarm sensor
4. Activate the alarm
5. Wait 30-35 sec
6. Get out of the car
7. Stop the alaram
8. Get in the car
9. Put the key on the position II, without starting the engine
10. Push the button READ

The alarm led must blink. Then you alarm is reset.
Sorry but my english is not very good, i'm from Romania, i hope you understand

ok this is what im going to have to say to this one and theres no way anyone can help over net in hooking wires this is a site on seen hands on serviceing for car alarms and it takes about 4 hours to install
i recommend spending the money and have a certified alarm tech install your system there are alot of wires and modules to install on the vehicle
im not trying to be mean or rude but this is a complicated alarm system that requires a techs touch so that your vehicle wont come out haveing problems afterwards
some vehicles wireing needs to be cut and this is not safe i have an area on fixya that i speak of proper wireing and who should do the work this you should consider