Question about 1995 Jeep Grand Cherokee

1 Answer

Power windows will not work gauges speedo and tach all read o when drivers door is closed when opened all work properly on a 1999 jeep grand cherokee

Posted by on

  • gundylan Jun 23, 2009

    Thaks for the advice now I have found as soon as I disconnected power window wiring harness from door panel the gauges started working also no power going to wiring harness but I cannot locate fuse to check.Could a bad motor on one of the windows be causing this problem? Thanks again.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Check the dash for proper grounding and also check the door harness where it passes through the boot for breaks or shorting. The door may be completing the body ground through the latch.

Posted on Jun 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drivers door is closed & the door open warning was showing that it was open, now windows will not close


sounds like the ground wire in the door failed
killing the door switch and windows.
all else ok, car drivers ok , all other doors , and locks windows all work?
head lights not dim/?
starter dont sound weak?

Apr 02, 2016 | 1999 Jeep Grand Cherokee

1 Answer

My 2004 jeep grand cherokee has issues with windows rolling down and the automatic door locks.. Neither will work on any door. The sunroof will roll back however.


Had a similar problem... the wiring harness that goes inside the drivers door had a broken wire, hence no power would go to the door locks or the power windows. Check the area where the harness flexes when the door opens and closes.

Oct 12, 2010 | 2004 Jeep Grand Cherokee

1 Answer

My sensor reads driver door open when its not and the interior light remains on sometime. Also my doors and windows partially works.


well you have sensors on the side of the car when the door closes it pushes in and shuts the light off.......so just see if you can try to mess with it or just bring it to a mechanic

Jan 28, 2010 | 1999 Jeep Grand Cherokee

1 Answer

1999 Jeep Cherokee Sport How do you


I WOULD CHECK THE WIRING BETWEEN THE DRIVER'S DOOR AND THE POST..YOU WILL SEE A RUBBER BOOT BETWEEN DOOR POST AND DOOR..HAVE SEEN PARTIALLY BROKEN WIRES CAUSE ALL SORTS OF PROBLEMS HERE

Sep 03, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Power windows and doors not working from driver's side buttons


you have a broken wire in the loom between drivers door and body repair this and all doors and windows will operate ok again

May 30, 2009 | 1999 Jeep Grand Cherokee

2 Answers

Dome light stays on, power windows don't work... 1999 Jeep


Check for a broken 12V+ or broken ground wire in the rubber boot that goes from the drivers door to the hinge pillar. Had this problem on mine and found both wires broken from years of flexing when door opened and closed. Don't try to splice the break, as the wire is too short and is also brittle. Run new (same guage) wire through the boot and splice inside the door and under the left side kick panel.

Nov 11, 2008 | 1999 Jeep Grand Cherokee

3 Answers

1999 Jeep Grand cherokee


Check the wiring between the drivers door and the A pillar(the body of the car). Sometimes the harness breaks from opening and closing the door.

Nov 07, 2008 | 1999 Jeep Grand Cherokee

5 Answers

2003 Jeep Cherokee Door Panel Electrical Issue


hi
i had the same priblem myself, its an easy fix if your any way handy.
the problem is the main power wire to the drivers door is broke or almost broke (due to switches working when door is closed) between the body off the car and the door you will find a rubber boot,slide the boot back from the car body side and you will find that the thick wire is broke due to the door opening and closing all the time. just add a small piece off cable the same gauge about 2inches (to allow movment in rubber boot) and solder both ends to join. that will solve your problem. ive fixed at least 5 off the jeeps with same problem. try it to see.

mark

Sep 15, 2008 | 2003 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...