Question about Cars & Trucks

1 Answer

Grinding noise when cornering

A grinding noise when turning left all brake componants and bushes look ok started after some hard driving on country roads

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 354 Answers

If your vehicle has front wheel drive you have to inspect the outer CV boots on the drive axles. If they are ripped then they are probably the culprit for the noise. Check the side that sounds like the noise is cominf from.

Posted on Mar 23, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Rear Axle Bearing

i know for a fact that the bearing comes with the hub., and if the old bearing is badly damage you may need to heat it to remove it from the axel...so this may be a rather big job if your not equipt
with torch or other ...

Posted on May 31, 2008

  • 1 Answer

SOURCE: SHAKING AND KNOCKING NOISE

it could be tht the exhaust pipe is loose and therefor makes shaking and kinda banging noise. hope i helped! ;-)

Posted on Jul 30, 2008

  • 1 Answer

SOURCE: Grinding noise in front end

Hi
Had the exact same problem, on a used 2003 Protege ES with 82,000 miles that I purchased.
Started with the loud "road noise" I thought well maybe thats just the sound that it makes.
And then noticed that it varies when turning.
This will continue to get worse and then your abs light will come on when it gets bad enough to trigger the sensor..
It turned out to be a bad wheel bearing.
Take it to a shop and have an experienced mechanic check it out. Its repairable.

Posted on Apr 30, 2009

  • 583 Answers

SOURCE: Front drive noise when turning left/right

the C V JOINTS have hadit.that is the constant velocity jointsare badly worn and need replacing youdoit

Posted on Jul 27, 2009

  • 117 Answers

SOURCE: Vibration/Humming/Grinding noises when stopping or turning left.

when turning left vehicle distributes weight to right front wheel bearing causing load. since u describe a noise in right front while driving straight i would suspect failed right front wheel bearing. see if your noise changes/goes away while turning right that should tell u 4 sure

Posted on Nov 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have an intermittant grinding on the front of my 2000 Kia when I go over bumps. the wheel bearings were already replaced because of this, but the grinding continues.


It seems as though you have changed everything.

A grinding noise is associated with something turning or rubbing against something. The only other thing that springs to mind are the drive shafts, which have splined ends. The link below will show you generic images of driveshafts
kia drive joints Google Search

Each end of the drive shaft is splined. One end fits into the gearbox and the other end attaches to the road hub of the road wheel.

It's usually the hub (universal joint that allows the wheel to turn)/ wheel end of the drive shaft that wears. It may be that the grinding noise has been more pronounced when turning? And the grinding noise is coming from just one side?

A new drive shaft isn't cheap although second hand ones are readily available. replacing a driveshaft isn't a particularly difficult job.

However, it may be an idea to get somebody to remove the brake calliper/rotor/ driveshaft hub and inspect the hub/splined end of the drivehaft. What you're looking for is worn, broken or chipped splines. If all seems okay try cleaning and repacking with driveshaft grease. It's probably the hub - the bit that allows the wheel to turn - as opposed to the splines -there's bearings inside that hub (also known as a universal joint). There's no real way of examining that hub other than replacing the driveshaft

Mar 02, 2016 | Kia Cars & Trucks

2 Answers

Why do I hear grinding noises while driving?


Hit in the rear axle may have damaged bearings or brake parts. Jack up the side you hear noise from, put on stand, then have helper rotate wheel while you look underneath and listen to see where noise is coming from. Use length of old fuel or heater hose, one end in ear, to locate exactly where noise comes from.

May 27, 2015 | 1996 Jeep Cherokee Country

2 Answers

Got hit from the left side but theright frontwheel was the one tilted towards insideof the wheel well can it be the stable lizers


it can be any part of the front suspension or brake system including drive train damage jack up right side and with wheel still on place hands at top and bottom of wheel and push and pull in and out if movement usually a ball joint but ball joints dont give off a grinding noise ===now grab tire at the 9 and 3 position front and back -push and pull if loose possible tie rod damage or steering component damaged this also doesnt give off a grinding noise unless bent into a turning part =====turn wheel and listen and look at cv axle and around brake area if noise remove wheel and now inspect brake caliper ,brakes ,hub and axle for noise these components can give you your grinding noise repair or replace damaged components the other tests performed were for possible damaged parts since wheel was bent inward

Apr 09, 2014 | 2005 Ford Taurus

1 Answer

Transmission


Your problem is a bad CV axle and outer carrier bearing failure. The grinding is coming from brake rotor on that side due to the bearing failure. the brake rotor and bearing is causing the lock down. Do not attempt to drive or further damage will occur. Transmission is probably OK. Replace both sides (CV axels and Carrier bearings, 150,000 is time) Check brake components for damage and replace pads while you are there.

May 20, 2017 | Hyundai XG350 Cars & Trucks

1 Answer

Montero rear right side grinding noise.checked the brake pads,brake shoes,drive shaft,shocker,suspension arms,brake discs,caliper and caliper pins.found ok,but still grinding noise on rough road


This is one of them questions and need i say more ,as without looking myself and having a drive then i could tell you straight away iam sure ,because without hearing the noise i cannot even summise where or what it is because a grinding noise is -well -difficult to denominate exacty what one defines as a grinding noise ,myself i would define it as a rythmic noise with the road speed but someone else would call it that noise for a trailing arm bush loose or worn but one thing to check is are the pads hitting a part of the brake disk thats corroded like on the edge of the brake disk ,sorry to be absolutely no help at all but i hope you appreciate how difficult it is to diagnose something with hearing it and from afar ,but if you only hear the noise when on a rough road could it be the tyres like a deformed tyre or them town and country tyres with big chunky treads .

Mar 03, 2012 | Mitsubishi Cars & Trucks

1 Answer

X type 2.2d 2007 Noises when turning left. Have experimented a bit since I first heard the noise and if I turn the steering hard left then accelerate slowly until I am going round in circles fairly fast...


you seem to have a sheering hub bearing. ..the car will have to be raised and to checked but this is usually the issue with that car...I have seen it on xj and x type and some s types also...the noise will get worse as you drive it, but if the sound is a low humming sounds usually thats it,but if its a grinding sound and the car leaning in the rear to the side that has the noise then it is usually a carrier bearing...get her on a stand and keep me posted.

Sep 13, 2011 | 2003 Jaguar X-Type

1 Answer

I have a grinding noise in my front left and the vehicle pulls really bad to the left


you most likely need to have your front brakes replace post haste. the grinding noise,does it get worse when you apply the brakes? the grinding noise will be a bad brake rotor and will also make you car pull hard one way or other depending on which brake is worse. recommend highly that you have those brakes looked at. the more you drive it, the worse the problem will be.thank you for choosing fixya.com and please rate my solution thank you!

Dec 30, 2010 | 2004 Ford Explorer

1 Answer

Vibration/Humming/Grinding noises when stopping or turning left.


when turning left vehicle distributes weight to right front wheel bearing causing load. since u describe a noise in right front while driving straight i would suspect failed right front wheel bearing. see if your noise changes/goes away while turning right that should tell u 4 sure

Nov 15, 2009 | 2004 Chrysler Town & Country

1 Answer

Brake noise from rear drivers disk brake when turning


sounds like the front brakes need replacing, that what the squeal is. They are made to do that so you know when to replace them

Apr 27, 2009 | 2002 Chevrolet Camaro

1 Answer

I have a 2004 toyota rav4. when i turn corners or hit my brakes, i hear a grinding noise and squealing in my rear right wheel.


well most likely problem is the rubber bushings on the track bars or mounting bushing for the struts are worn and dry rotted they will cause the squeaking when cornerring and when braking because of the momentum of the body moving back and forth. with so many miles on the vehicle i would have them replaced... please rate this thanks

Sep 28, 2008 | Toyota RAV4 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...