Question about 1988 Chevrolet S-10

1 Answer

White wire from coil not connected to anything, where does it go?

White wire from coil not connected to anything, goes towards stearing colum, can not find anything to connect wire to. please help

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 280 Answers

Is this white wire one of 3 wires coming from the coil? If so, it is probably for a tachometer (which your S10 does not have) so it does not go anywhere.

Posted on Jun 14, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Cruise control not working 1990 k1500 4x4 cruise control not working were are all the parts located and what to look for

take the cover off the cruise control actuator located on the firewall in engine compartment remove the cover and see if the ribbon is broken that actuates the cable to the throttle,then ck the brake switch adjustment,if all is ok the switch on steering colum is bad to replace this you grasp the whole handle firmly and rotate it toward front of veh while pushing in toward colum,the wires go through the colum and are attatched under dash,attatch a fine stiff wire at connector and pull out then attatch thin wier to new switch wire and pull back through colum

Sep 22, 2014 | 1990 Chevrolet K1500

1 Answer

I have a 89 sierra with a 5.7 there is a white wire off the coil not connected to anything. Not sure where it goes. Truck runs but not well

Did the does not run well just happen? Did you work around the coil? Could be a tach wire whether the vehicle has a tach or not.

Jul 13, 2014 | Cars & Trucks

1 Answer

10 amp haz fuse blows from park to neutral?

i had trouble in my ford pickup the wireing in the stearing colum shorted what caused it was the slack in the tilt ajustment got worn when i put my hands on the steering wheel it pulled down and streached the wires. try ajusting the steering wheel up 1 notch and you may have to replace the wireing in the steering colum

Apr 29, 2014 | Cars & Trucks

1 Answer

Connection location for Park Avenue multipurpose switch

You will find it behind the stearing colum. You can get to it by taking out 2 screws to the stearing colum. They will be right there when you get the cover off.

Nov 25, 2012 | 1999 Buick Park Avenue

1 Answer

94 chevy g20 wire diagram colum 12 v hot

Power from battery is the Red wire, both are to battery one usually to Bat 2 and the other to Bat 3 on connector

Tan/white is ground
Dk Blue/White is ground for cluster without gauges
Orange goes to ignition 3
Yellow goes to solenoid
pink ignition 1
Brown is accessory

Feb 12, 2012 | Chevrolet G20 Cars & Trucks

2 Answers

Stearing wheel horn assembly wire to th stearing colum is disconnected

The wire on the steering wheel should have a plastic peg on it. The column where the wire goes should have a notch for the peg to turn into. If one of these is broke they will not stay together.

Sep 22, 2010 | 1993 Chevrolet S-10 Blazer

2 Answers

I have a 84 Chevy Celebrity stationwagon and the turn signal quit flashing but still comes on, Is there more than one relay under the dash for this. I already replaced the one I found and no change.

it could be the flashing signal switch, the electrical wires in the stearing colum sometime brake, try that. hope it helps you. in order to remove it you need to take cover of stearing colum and usually one plug and two bolts hold it in place. good luck

Mar 18, 2010 | 1984 Chevrolet Celebrity

1 Answer

Shifter on colum goes up and dn freely will not go

cable or linkage has problly come unhooked
its an easy fix!!

Aug 31, 2009 | 2001 Ford Explorer Sport Trac

1 Answer

Brake lights and turn signal not working

replace the turn signal switch in the steering column.. very common problem.

Jun 12, 2009 | 1998 Chevrolet Lumina

1 Answer

New stearing colum a request in the vehicle help board and the members will get them for you.

Mar 25, 2009 | 1986 Dodge Ramcharger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides