Question about 1996 Jeep Cherokee Sport

1 Answer

My 1996 Jeep Cherokee Sport dies or will not start when hot.

My 1996 Jeep Cherokee Sport 2WD dies or will not start after hot. I replaced the camshaft position sensor, crankshaft position sensor, distributor cap, rotor, plugs, wires, fuel pump and filter. Any ideas? Thanks.

Posted by on

  • Mike Lawson
    Mike Lawson Apr 13, 2014

    Try replacing the exhaust-gas recirculation (EGR) valve. My '88 Comanche wouldn't run until I changed it.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Sounds like the ignition coil is getting bad.

Posted on Jan 16, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 96 jeep cherokee set up 5 yrs; it starts but dies


Checked the fuel pressure ? Does it have a fuel filter you can replace?

Dec 06, 2012 | 1996 Jeep Cherokee Sport

1 Answer

My 1996 jeep cherokee sport keeps hesitating and if i let up on the gas it just dies i have replaced the iac any sugestions?


did you clean out the throttle body? a dirty throttle body can cause hesitation and stalling at idle at times.

Jan 27, 2012 | 1996 Jeep Grand Cherokee

1 Answer

Why does my 1996 jeep cherokee sport 4L bonnet get so hot and what can i do about it


check make sure proper antifreeze levels flush radiator when engine is cold is your cooling fans kicking on when temp gauge reachs half way change thermostat does the vehicle over heat

Dec 01, 2010 | 1996 Jeep Cherokee Sport

1 Answer

Where is the camshaft position sensor located on a 1996 jeep cherokee 4.0


the camshaft position sensor is inside the distributor, the crank sensor is at rear of engine in bell housing above starter. see pic of sensor below


4912fd8.jpg

Jul 01, 2010 | 1996 Jeep Cherokee Sport

1 Answer

1996 Jeep Cherokee Sport 2WD St8 6. 250,000 mi, leaking power steering, transmission, and has been having a slow oil leak for a couple years.The power steering and transmission are problems. Recently put a...


replace the power steering pump, the hoses are an odd size and you have to buy a wrench for it, the transmission you can change the gasket and filter and replace the fluids,, probably the engine is dripping from the rear main bearing seal, this is best left to someone who knows what they are doing.

Jun 29, 2010 | 1996 Jeep Cherokee Sport

1 Answer

First starting in the morning the 1996 jeep cherokee classic fires right up, backs out of the driveway, is able to go into forward and go down the block, at the stop sign there, it dies, and, until it...


Check out your cold start choke. It is designed to cause your fuel mixture to run "rich" until it warms up. It is basically a heat sensitive coil that reacts to heat from the exhaust manifold.

Apr 24, 2010 | 1996 Jeep Cherokee Sport

1 Answer

1996 jeep cherokee sport. How to replace the


On a 96 model,the heater fan motor comes out through the engine bay.Take off the batt. leads.Undo the bolts and then remove the fan power lead.The fan has 3 bolts.It then comes out.Hope this helps

Jan 14, 2010 | 1996 Jeep Grand Cherokee

1 Answer

I have a 1996 Jeep Cherokee 2wd automatic. I was driving at about 65 mph and the transmission suddenly went to free spin like it is was neutral and oil started blowing out of the dipstick. Park works but...


i have worked on many of jeeps in my time lol. wow i sound old now. this has happened to a couple of them. the only way to make sure the trans is in "fit" condition. is to rifill the trans with fluid, doing so with the engine hot. allow to idle for about 30 min to help heat the trans up and fill. if the prob still cont, then you will have to have the trans serviced. an electrical problem would not cause it to blow fluid, only a mech prob would. if you have further questions email me at mega_muzik@yahoo.com
Thanks

Nov 28, 2009 | 1996 Jeep Cherokee Sport

1 Answer

In my 1996 jeep cherokee sprot i have a problem with starting my car after i have been driving it i dont know what it could be the cam positioning sensor? getting to hot and sometime it will just die


The crankshaft position sensor located @ 11:00 on the rim of the bell housing from the driver position. seems to be a very common problem on the Cherokee. They cost between $70 and $80. or $250 installed.

Mar 28, 2009 | 1996 Jeep Cherokee Sport

4 Answers

Car dies at random moments


But, you did not change the crank sensor (on the drivers side of the bellhousing, just where it's a real pain to get to)

Jan 12, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

636 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...