Question about 2008 Dodge Nitro

Open Question

How do you remove driver airbag on nitro

How I remove driver airbag on nitro 208

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Airbag ligth dodge grand caravan 2007


You cannot remove it unless you replace the airbag. I have the same thing on my drivers airbag. You will still pass inspection with the drivers airbag not working. To get the airbag replace, you are looking at about 3 grand, I just put a dark sticker over my airbag deployed light because I got tired of looking at it The airbag will not cause other problems for you. Just cover up the light and forget about it.

Oct 16, 2017 | Dodge Cars & Trucks

1 Answer

How do i replace airbag control module on 2010 dodge nitro


Remove the center console. It is under it. Better make sure that is the problem though. Could be wiring. Lots of things to check before replacing any part of it. This is the most common reason cars are totaled, Air bags. Even if they weren't deployed.

Jul 07, 2016 | 2010 Dodge Nitro

2 Answers

How to turn off a airbag light on a dodge nitro


I suggest having it professionally repaired. Working on an airbag is like working on an armed explosive device. On the other hand, you don't want to ignore the fault; if you get in a wreck and the airbag doesn't work properly, somebody's going to be in a lot of hurt. If the fault is in a passenger airbag, you could have personal liability issues to add to your troubles.

Jul 03, 2015 | Dodge Cars & Trucks

1 Answer

Remove airbag on drivers seat


you have to remove your drivers seat, get a knife, very kind remove a fittings of your airbag, then go to your dealer buy a brand new airbag, get a niddle fit it all, and make all the procedure with airbag replacement. thats all

May 07, 2014 | 2007 Skoda Superb 2.0

1 Answer

My Dodge Nitro's airbag light keeps popping up on dash, why and how to remove it ??


should be a fuse for the air bag u can just pull it out bit it might control other things to there is a sensor for the airbags and on my mustang its by where the lights hookup but im not sure where it would be your car

Jan 18, 2013 | Cars & Trucks

1 Answer

I want to replace the right hand speed control for the cruise control on my 2008 Chrysler Aspen - any ideas? Anyone!


11_18_2011_12_24_34_am.gif
REPLACING CRUISE CONTROL SWITCH

1.
Disconnect and isolate negative battery cable from battery.

2. Remove airbag module (See AIRBAG REMOVAL below).

3. Remove speed control switch mounting screw and remove switch from steering wheel.

4. Reverse procedure to install.
AIRBAG REMOVAL
1. Disconnect and isolate negative battery cable from battery.

2. From the underside of the steering wheel, remove the two screws that secure the driver airbag to the steering wheel armature.
CAUTION: The horn switch and the clockspring pigtails connected to the back of the airbag module are fragile. Do not pull on these wires to disengage them. These must be handled carefully to prevent damage to the horn switch and/or the clockspring assembly.
3. Pull the driver airbag away from the steering wheel enough to access the three electrical connections on the back of the airbag housing.

4. Disconnect the steering wheel wire harness connector for the horn switch from the horn switch feed pigtail wire connector, which is located on the back of the driver airbag housing.

5. The clockspring driver airbag pigtail wire connectors are secured by integral latches to the airbag inflator connector receptacles, which are located on the back of the driver airbag housing. Depress the latches on each side of the connector insulator and pull the insulators straight out from the airbag inflator to disconnect them from the receptacles.

6. Remove the driver airbag from the steering wheel.

7. Reverse procedure to install.

Nov 17, 2011 | Cars & Trucks

2 Answers

Where is the oil filter on a 2007 dodge nitro v6


You can access the oil filter easily from underneath next to the front, driver-side wheel at the front of the engine. There is clear access to the filter there.

For more info on Dodge Nitro, visit the forum at
http://www.dodge-nitro.com/dodge-nitro/

Aug 08, 2009 | 2008 Dodge Nitro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...