Question about 1986 Mercury Sable

Open Question

Low idle How do I turn up the idle

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you adjust high and low on carburettor


not sure what you mean, idle? High idle usualy bend a rod to position the cam in the right place when engine is cold or with the choke plate held about 1/8" open and low idle is turn the idle screw with the engine warm. The screw rests high on the cam when cold and low on the cam when engine has warmed. you may find an index marking on the cam.

Apr 16, 2015 | Cars & Trucks

3 Answers

Stalling at low idle


I don't know this specific car. But, if it has one, check your Idle Air Valve. This can cause the engine to stall. If you can hold the gas pedal and the engine will continue to run until you let off the gas, it is likely the IAV. It will not necessarily cause the engine to run rough. That could be a number of things like spark plugs, wires or dirty injectors. It could also be a compression problem. Is the check engine light on?

Mar 04, 2014 | 1995 Dodge Intrepid

2 Answers

Oil gauge drops low at idle


Low oil pressure at idle can be caused by an engine with worn rod or main bearings due to (usually) high mileage . This however does not mean the engine is still not serviceable as long as the oil pressure is low only at idle. The pressure should at minimum get into the normal range at anything above idle speed.Not much oil pressure is really necessary at LOW speed. At low speed, as long as there is oil getting to the bearings, even at low pressure, you are OK. In a high mileage engine the oil pressure is often low at idle simply because the oil pump is turning slowly and cannot maintain higher pressure between the larger than normal crankshaft and bearing clearances. As speed increases the pump turns faster and supplies more oil and the pressure should go higher. Low pressure as long as it is only at idle is not a problem. However at higher speeds the pressure should be in the normal range. Such a worn engine can benefit from higher viscosity (thicker) oil such as 20W-50 in above freezing weather and 10W-40 in winter. That will increase idle pressure and the thicker oil film maintains a better film between the worn parts

Apr 08, 2012 | 2002 Jeep Grand Cherokee

2 Answers

My 1989 cadillac idiles low but once I turn the wheel it cuts off


remove and clean the IAC idle air control it is probably sticking and giving a low idle. or replace it if need be. it should idle at about 7-800 rpms, i think thats why it quits when you turn the wheel. it is putting more stress on the pump and the engine. check idle. Good-day !

Aug 25, 2011 | Cadillac Brougham Cars & Trucks

1 Answer

LOW IDLE


idle is factory set on the computer (UNDER NO LOAD)SO IF YOU TURN ON THE A/C IT WILL IDLE LOW,BUT WONT VIBRATE BADLY.NO ADJUSTMENT IS AVAILABLE.

Jun 25, 2010 | 2006 Chevrolet Trailblazer

1 Answer

ENgine idles too low and sometimes turns off?


If it has'nt been tuned up lately ----check tune and basically sounds like the throttle body idle circuit is plugged up with carbon----try spraying with a carburator cleaner.

Dec 20, 2009 | Toyota Camry Cars & Trucks

1 Answer

I have a Mistubishi eclipse GS 2.4 four cylinder the car idles extremely low and sometimes dies when i am sitting at stop lights out of gear or when i come to a stop and have it in nuetral. But when i turn...


your idle speed too low.take it to a dealer.they have to reset idle.it should be 600-800 rpms.when you turn on air conditioner.the computer steps up idling to keep engine from stalling .your curb idle too low.

Jun 22, 2009 | 2001 Mitsubishi Eclipse

1 Answer

2001 nissian maxima se low idle


adjust the idling, if too low then it can't sustain the power needed to keep the engine running when it engages.

Apr 20, 2009 | 1995 Nissan Altima

2 Answers

Engine on idle runs high and low, high and low...


Had same problem. Turned out that antifreeze was low causing insufficient water pressure. Could also be a bad sensor. I would check both.

Dec 29, 2008 | 1993 Honda Prelude

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

fordexpert

Level 3 Expert

5467 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...