Question about 2005 Dodge Caravan

1 Answer

Drivers side airbag light stays on

Airbag light comes on when ignition is turned on,engine statrs light goes out momenterally then comes back on an remains on.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 129 Answers

It might be a defective clockspring in the steering column. This also may cause the cruise control to not work at all or intermittently.

Posted on Dec 17, 2014

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ajkill
  • 2035 Answers

SOURCE: cannot get starter to turn engine over with ignition switch,pulled relay out and ran a hot wire to starter side of relay and starter engaged.

Then check the key switch may be defective or the fuse might have blow out...............

Posted on May 30, 2008

  • 1 Answer

SOURCE: 1997 Dodge Caravan Horn and Airbag light

It's the " clock spring " . Dodge has a lifetime recall / replacement on this part. Somehow it controls the air bag and is tied into the horn and cruise control .

Posted on Mar 08, 2009

  • 31 Answers

SOURCE: Guage cluster goes out reading 0 on everything,

sounds like a faulty gauge cluster or a loose connector on the back of the gauge cluster

Posted on Nov 14, 2009

  • 57 Answers

SOURCE: I have a 2002 Dodge

This is a very common problem with these vans and it is caused by a faulty front control module. The front control module is the silver box attached to the front side of the underhood fuse box and it will need replacing. It's just held in place with screws.

Posted on Oct 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The drivers side airbag light comes and stays on my 2006 Toyota Rav4 until the car is warm. What's wrong?


you need to get in touch with toyota they had a recall on your vehicle due to airbag.THE STEERING COLUMN ASSEMBLY CONTAINS ELECTRICAL CONNECTIONS TO THE DRIVER'S AIRBAG MODULE HOUSED IN A SPIRAL CABLE ASSEMBLY, WHICH INCLUDES A FLEXIBLE FLAT CABLE (FFC). DUE TO THE SHAPE AND LOCATION OF THE FFC'S RETAINER, THE FFC COULD BECOME DAMAGED WHEN THE STEERING WHEEL IS TURNED.
Consequence: IF THE FFC IS DAMAGED, CONNECTIVITY TO THE DRIVER'S AIR BAG MODULE COULD BE LOST AND THE AIR BAG DEACTIVATED. THE FAILURE OF THE DRIVER'S AIR BAG TO DEPLOY IN THE EVENT OF A CRASH THAT TYPICALLY NECESSITATES DEPLOYMENT INCREASES THE RISK OF INJURY TO THE DRIVER.

Mar 31, 2016 | 2006 Toyota RAV4

Tip

How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe


Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. <br /> The flashing light on your car is telling there is a problem. <br /> <br /> <b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b> <br /> Ignition Key Method: <br /> <ul> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 2 seconds.</li> <li>START Car (the light may be blinking slower than before).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 3 seconds.</li> <li>START Car.</li></ul> <br /> <b>This is a little easier</b> To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away

on Dec 07, 2010 | Infiniti G35 Cars & Trucks

1 Answer

B1801 Ford Escape 2002. The air bag light comes on the instrument panel in my vehicle and will stay on for a while then go away. I had someone test it for me and told me it was code B1801. It was at a...


Did you disconnect the battery recently...did you operate the horn.both questions related to what may originally cause the airbag warning light to stay on.if it was the battery being changed reconnected then you have to reset the airbag light.this is quite simple on Fords.
with the engine off ....ignition key into the lock open the drivers door and keep it open ....locate the button at the bottom of door for courtesy light....hold your finger on it...turn the ignition on so that only the lights on dash come on...do not start car....now press the door button 6 times within ten seconds and on the last count of six hold it in whilst turning off the ignition.then close the drivers door and start.the airbag light usually flashes for several seconds then it should clear.on some model fords the button press count is 5 or 7 so you may need to repeat ....on mine I discovered I had to open the passenger door after the procedure before turning ignition back on.a word about the horn.on older model fords the springs that sit in the horn housing also affect the sensor of the airbag in some models .the springs gets rusty or bunged up and operating it will cause the airbag sensor fault.never attempt to remove the cover of the horn assembly as you may fire off the airbag.just remember to reset the warning light... And get a mechanic to look at the horn if it continues to play up.Please remember if the airbag warning light is flashing it may mean the airbag will be disabled and will not deploy in the event of an accident, this also means the seatbelts may not lock on impact either.please vote if helpful thanks.

Feb 27, 2015 | Ford Cars & Trucks

1 Answer

Fix airbag warning light which stays on


Airbag Service Reset Tools

Find the fuse panel cover in the foot well on the driver's side of the vehicle. Pull down on it to open it.
Find a yellow connector inside the fuse panel. Pull out this connector. This is the airbag power connector, also called the SRS power connector.
Insert one end of the paperclip into one terminal of the SRS power connector and insert the other end of the paperclip into the other terminal.
Put the key into the ignition and turn on the vehicle, making sure you don't start the engine. The paperclip shorts out the SRS light, thus resetting and turning it off. Plug the SRS power connector back into the fuse panel. Put the cover back on the fuse panel and shut off the vehicle.
Wait a couple of minutes, then turn the engine on. Look on the instrument panel to ensure that the SRS light has turned off. Turn off the engine and remove the keys from the vehicle.

Oct 10, 2014 | Cars & Trucks

1 Answer

Airbag fault light staying on octavia 4 years old


check under drivers seat for a yellow plug with ignition off unclip the plug and make sure the contacts are clean put plug back together again check to see if light goes out, if it doesn't slide back the rubber boot between the drivers door and the car body could be a broken wire from the airbag door sensor (usually a brown wire and a yellow wire if i remember correctly) if broken solder back together and insulate, (you could try for the door wire first probably easier)

Dec 30, 2012 | 2005 Skoda Octavia 1.4

1 Answer

The airbag light in dash staying on in my 2004


Under driver and passenger seats are wires that go to seat belt anchors.These are tensioner wires.Unplug the wires from the plug under the seat.clean and replace.Doing this while the ignition is turned off.Then turn ignition back on.In 90% of the time this is your problem.Constant movement of seat causes this or rear passengers kicking plugs off.Good luck phil.

Jul 10, 2009 | 2002 Kia Optima

1 Answer

My 2006 kia optima airbag indicator light stays on


my advise to you is not to attempt a repair to the airbag system yourself. The airbag module can be set off by static electricty & goes off with the force of a shotgun blast

Jul 03, 2009 | 2006 Kia Optima

1 Answer

Airbag light stays on, fuses ok.


The airbag light will come on and stay on as long as there is an active code in the system. It will go off when the code goes to stored. Active means, something is malfunctioning right now so we will turn the light on. Stored means, something malfunctioned but is working now so we'll store the code in memory and turn the light back off. You really need to have the codes checked for an accurate diagnosis.

May 03, 2009 | 2002 Jeep Grand Cherokee

2 Answers

The airbag light came on and stayed on for no reason.


I have the same issue (which comes and goes often).
It is caused by a loose wire connection, used for the drivers side airbag located in the seat.. The connector for mine is located under the front drivers seat. There are a couple of connectors that are connected to a bar under the front of the seat. I don't recall which one is used for the Airbag sensor.

Feb 15, 2009 | 2000 Chevrolet Impala

Not finding what you are looking for?
2005 Dodge Caravan Logo

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...