Question about 2001 Mazda MPV

1 Answer

2001 mazda mpv problems

Drivers side wind will go down with no problums but when I go to bring it up it won't go up. I do here the motor moving like it should. Any help would be great.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mazda Master
  • 35,672 Answers

Cleaning the track could eliminate binding of the glass.

Posted on Mar 23, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 840 Answers

SOURCE: power windows on 2001 mazda mpv won't go up?

if you do not here the motor then its the regulator or motor that needs to be replaced/ cif you hear the motor check the control switch on the trim panle coould be just a five dollar part to replace/ Please rate my response thank you very much

Posted on Jan 31, 2009

shop510
  • 90 Answers

SOURCE: replace driver side power window motor

Once you have removed the inner door panel you unbolt the motor and regulator (They should come togther) and install.

Posted on Sep 28, 2009

  • 1986 Answers

SOURCE: Drivers side window has slipped off track 2006 mazda mpv

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics.

Posted on Sep 29, 2009

  • 2 Answers

SOURCE: Mazda 323f: Rain water leak into cabin on drivers side, low down.

I am fixing a similar problem on my daughter's 2002 323 Hatchback (Australian BJ model, RH drive) at the moment. Rainwater comes in from above the clutch pedal.

If you look down thru the vents in front of the windshield near the wipers, you will see a spot-welded body seam running across the bottom of that recess. This is where hers is leaking. I originally sealed it with a RTV silicone sealant which fixed the problem but after approximately 6 months it has started leaking again. I am going to remove the silicone and seal over the seam with a brushable bitumen -type sealer.

Remove windscreen wipers and the vent panel for easy access to the area.

Posted on Dec 10, 2009

lindsay836
  • 677 Answers

SOURCE: I repair the motor of my mazda mpv 2002 and it doent started

You need timimg marks, There are the internal marks for installing timing chain, you follow the marks on the crank and cam and line them up, for the Ignition timing you follow the marks on the crankshaft harmonic balance, and the marks on the timimg chain cover for top dead center ect..

Posted on Feb 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a mazda mpv 2001 where is the fuse box located


When you're sitting in the drivers seat it's right down there by your left foot on the side panel.

Dec 16, 2016 | Mazda Cars & Trucks

1 Answer

I have a mazda mpv 2001 i need to know where the fuse box is located as changed fog lamps and still not working


Sitting in the drivers seat it's right down there by your left foot on the side panel. Pull off that plastic cover. There it is.

Dec 16, 2016 | Mazda Cars & Trucks

1 Answer

Mazda MPV 2001, code P1518 , and P1512, what is the problem?


After extensive searching and trial and error I found that the cause for the code 1518 on my mazda mpv was caused by the plastic clip that holds the linkage for the intake manifold runner had broke on the fire wall side and the linkage fell out causing the runner to stay open. It is very difficult to see. It is on the front( drivers side) of the engine below the upper intake manifold. Remove the air cleaner box and use a mirror and you can see it. Only about 6 inches long. Replace both clips while you are in there because it is a bear to get to. Check this first before you go through the other items like the egr. Inexpensive repair and my code 1518 and the one for randon miss fire went away never to return. Lots of power again. Good luck. Jim

Aug 30, 2010 | 2001 Mazda MPV

2 Answers

Where is the starter on a 2001 mazda mpv, and is there anything special you have to do to take it off


It's on the side near the bottom of the engine. Follow the positive wire (red) from the battery as it goes straight to the starter.

Aug 18, 2010 | 2001 Mazda MPV

3 Answers

HOW TO REPLACE 2001 MAZDA MPV SPARKPLUGS? PLEASE


If its a 6 cylinder they should be on the sides of the motor when you stand in front of it in the outside of the heads.

Jul 28, 2010 | 2001 Mazda MPV

1 Answer

I have a Mazda MPV 2001 van that two of the automatic windows have stopped working. Is this something that I can fix myself?


On my MPV the problem was actually the Switch not the motor. Check the switches. You can access them by just pulling the door panel off. If you need some instructions for door panel removal let us know.

Hope this helps...

Oct 16, 2009 | 2001 Mazda MPV

1 Answer

Four win stuck up for Mazda 2001. fuse is working


I have a 2000 Mazda MPV where the same thing just happened. Unfortunately it came back for a second, and my wife pushed one down. I took it to a glass shop, and found that the driver side power window switch was bad. It runs about $178.00 at the dealership. It takes about 2-3 days to order. Unfortunately not even the import places carry it. I did find a few used on Ebay for about $50-$70.

Aug 30, 2009 | 2000 Mazda MPV

1 Answer

Replacing drivers side power window motor


NO not really just make sure you have the window is all the ways up and hold it with duct take to keep it from coming down.Remove the motor and unplug the harness.Install the new one and plug it in .Its that easy

May 23, 2009 | 2003 Mazda MPV

1 Answer

Power windows on 2001 mazda mpv won't go up?


if you do not here the motor then its the regulator or motor that needs to be replaced/ cif you hear the motor check the control switch on the trim panle coould be just a five dollar part to replace/ Please rate my response thank you very much

Jan 31, 2009 | 2001 Mazda MPV

Not finding what you are looking for?
2001 Mazda MPV Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...