Question about 1999 Hyundai Accent
Plastic valve cover 70-90 inch lbs metal or cast 10 ft lbs. criss cross working your way outward in small increments to slowly draw the cover down. CLEAN bolts and bolt holes for a more positive retention. I spray the holes out with brake cleaner.
Posted on Mar 23, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Valve cover bolts are in most cases reusable unless rounded off or striped. If the bolts are m6 89in/lbs should be good m8 105 in/lbs.
Posted on Feb 18, 2013
Tips for a great answer:
Nov 06, 2015 | Cars & Trucks
Nov 15, 2014 | Cars & Trucks
Mar 01, 2014 | 1987 Ford Ranger
Aug 28, 2013 | 1996 Jeep Grand Cherokee
Jun 27, 2012 | 2001 Chrysler PT Cruiser
Oct 25, 2011 | 2004 Infiniti I35
Oct 09, 2011 | 1988 Toyota Camry
Disconnect the negative battery cable. Remove the accessory drive belt. Using a 9/16mm wrench, loosen the power steering pump bolts, then slide the pump forward. Do not remove the power steering pump. Remove the power steering pump braces.
Disconnect the spark plug wires. Using a 9/16 mm wrench, remove the valve cover bolts. Lift the valve cover to remove it. Using a flathead screwdriver, gently nudge and remove the old valve cover gasket.
Clean the gasket seating area using automotive engine cleaner and a clean cloth rag. Make sure that all debris is removed. Place the new gasket into place. Apply gasket sealant and place the valve cover back into place.
Tighten the bolts securing the cover into place using a torque wrench. Reconnect the spark plug wires. Reinstall the power steering pump braces. Place the power steering pump back into position. Using a 9/16 mm wrench tighten the bolts that secured it into place. Reinstall the accessory drive belt.
Ensure that the negative battery cable is disconnected. Locate and remove the accessory drive belt. Using a 9/16 mm wrench, disconnect the bolt attaching the alternator to the brace.
Remove the brace to gain access to the additional parts that will be removed. Disconnect and remove the spark plug wire harness. Using a 9/16 mm wrench, remove the bolts securing the valve cover. Lift up and remove the valve cover.
Use a flathead screwdriver to gently nudge the old valve cover gasket to remove it. Do not scratch the gasket seating area when removing the valve cover gasket. Make sure that all debris and particles are removed from the gasket seating area.
Place the new gasket in the gasket seating area. Using a torque wrench tighten the valve cover gasket bolts. Reinstall the spark plug wire harness. Put the alternator brace back into position and tighten the bolt that secures it into place.
Reinstall the accessory drive belt. Reconnect the negative battery cable. Add oil to the car and start the engine. Allow the engine to run idle for 10 to 15 minutes. Drive the car a short distance to check for leaks.
Mar 16, 2011 | 1999 Oldsmobile Silhouette
64 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: