Question about 2001 Lincoln LS

1 Answer

What type of epoxy could i use to repair tiny cracks in my coolant system? 2001 linoln ls v8

I just replaced my coolant inlet tube, n now i got a leak behind the motor near the driver door n small amounts of steam from the radiator..

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

I think abs

Posted on Mar 16, 2015

  • Ryan Trobaugh Mar 16, 2015

    I think you can use abs epoxy if it's on the plastic.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2002 LS: aHow do I fill radiator in my V8 Lincoln LS...

First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
To Fill- Remove the front two plastic screw type buttons,from the engine cover
-Remove the cover
The radiator cap is on the front of engine,on top,it is plastic
Remove cap and that is your fill point
Run engine to warm and get thermostat open,as you would with any vehicle
Top off coolant,replace cap
VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
Fill-Degas Bottle,to full line,with coolant.
Check the next couple days on resevoir level ( Degas Bottle)

Posted on May 06, 2010

emissionwiz
  • 75744 Answers

SOURCE: lincoln ls v8 2001 im leaking coolant directly

from my past experience this car is going to need a new coolant tank the molding seam opens when hot and leaks.

Posted on Sep 08, 2009

carlsbiz
  • 1124 Answers

SOURCE: draining radiator coolant

IF it was really dirty before empying the old coolant - you should do a flush before re-fill with the new collant.. You can get it at any local parts store.. Follow the directions..
IF SO - I highly recomend Lucas prduct.. More money - but really good stuff.

If it was not too bad - yes - run some water therough it..

Allways do 50/50.. If you use too much coolant - you risk the cooant gelling..

Also - there should be a Lucus pruduct that is a coolent additive and is also a great lubricant for the system and water pump - to make it last longer..

Please dont forget to rate well ;o)

Posted on Aug 08, 2009

blueextc3221
  • 15935 Answers

SOURCE: what is the cylinder number 6 on firing order on a

The LS does not come with a V8 engine.
here is the v-6 3.9L diagram
cb83e3a.gif

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Posted on Jan 03, 2010

Testimonial: "Thank you, you were very helpful"

  • 4 Answers

SOURCE: Location: Coolant Temp Sensor 2001 Lincoln LS V6

It is on the Driver side of engine in between the COP's (Coil on plugs) simply unplug the wire use a 19 or 3/4 deep well socket and unscrew it and put it new one... The whole process should only take 10-15 minutes.

Posted on Aug 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 lincoln ls 3.9 v8 a/c not working is cuttin off when i on ac


Most likely a leak & low on refrigerant

Need a shop to leak check,evacuate,make repair,
and recharge

Mar 27, 2013 | 2001 Lincoln LS V8

1 Answer

WHAT TYPE OF ADHESIVE CAN i USE TO REPAIR A LEAKING COOLANT RESIVOUR


you can try a plastic weld type epoxy they make some for plastic gas tanks as well try that remember to clean and scuff the surface

Aug 12, 2012 | 2002 Lincoln LS

1 Answer

HOW DO YOU REPAIR A LEAKING RESIVOUR FOR COOLANT


Don't know what system is on a lincoln. If it has a pressure cap can be plastic welded. If itsonly an expansion tank epoxy resin should do. Hope this helps

Aug 12, 2012 | 2001 Lincoln LS

1 Answer

I have a 2000 lincoln ls v8. First the heat would only blow out cold air. Now the car overheats. I've changed the thermostat. The system coolant is full. I don't know what else it could be. Also how can I...


Water pumps go bad when they leak. If there is a lack of circulation, there could be a clog in the system. Is the heater core getting hot on both tubes at the firewall? If not, then the heater core is clogged up. Has anyone ever put too much sealant into the cooling system that would cause an overheat condition due to lack of circulation of coolant?

Good luck on this repair.

Dec 18, 2010 | 2001 Lincoln LS

2 Answers

Water is leaking out of my coolant container.car is overheating with less than 2 mins of driving


Need to seal the leak in the coolant container with epoxy or by replacing the coolant container.

Fill coolant system with 50/50 solution up to 2 gallons may be required to stop the overheating.

Don't drive an overheated engine.

Aug 11, 2010 | 1993 Saturn SL1

2 Answers

What is the cylinder number 6 on firing order on a linoln ls v8 2003


The LS does not come with a V8 engine.
here is the v-6 3.9L diagram
cb83e3a.gif

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Jan 03, 2010 | 2003 Lincoln LS

1 Answer

I have a leak problem with my car.


This is an easy repair. Find a time when you will not need to drive the vehicle for 24 hours. Remove the reservoir from the vehicle and give it a thorough cleaning inside and out. Wipe the crack area with alcohol. Purchase a tube of RTV silicone sealer. Read the instructions. Apply the RTV to the crack making sure you fill it completely. Let it set for 24 hours before reinstalling on the vehicle. Leaked repaired!

Sep 27, 2009 | 2000 Lincoln LS

1 Answer

Lincoln ls v8 2001 im leaking coolant directly below the coolant tank


from my past experience this car is going to need a new coolant tank the molding seam opens when hot and leaks.

Sep 08, 2009 | 2000 Lincoln LS

2 Answers

Overheat & Coolant Leak


OK YOU SAID THE CAR LICKS ANTIFREEZE WHERE THE TRANY IS IF IT IS COULDBE A BAD METAL SEAL

Jul 31, 2009 | 2003 Lincoln LS

Not finding what you are looking for?
2001 Lincoln LS Logo

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...