Question about 2004 Honda Accord
If you've replaced the MAF sensor recently (I assume you've checked part numbers match with your old one?) disconnect the plug and ensure the contacts are clean and no debris has found its way in.
Posted on Mar 30, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Honda Accord Map Light bulb
the cover is removed straight down, slowly working it with a thin tool or butter knife. WD40 to front and rear edge (there's nothing medial or lateral). The cover has 2 Y clips on each side, one about half way, and one that clips straight off of the hinge post. There are no "tabs". It will eventually unclip straight down. Then can replace with a DE3175 LED bulb (V-LEDs.com)
Posted on Oct 29, 2009
Low / uneven idle problem can cause by a lot of components.
Dirty air filter
Dirty injectors + o-rings
Vacuum leak at intake manifold and vacuum hose.
Bad Idle Air Control Motor (IAC)
Low compression (170 psi + is OK)
Start cleaning and repair these trouble spots and see is there any improvement.
For more advance DIY'er then you may try this.
Use a can of Berryman carburetor clean to locate the vacuum leak.
SEE SAMPLE PICTURE HERE
This is a 20-30 minutes job.
Vacuum leaks can occur in following locations.
Intake manifold AND/OR vacuum lines.
Intake manifold is not accessible unless the engine head if off.
You can still check the potential leak by spraying some Berryman near the intake manifold.
Listen for rpm increase after you introduce the Berryman (FUEL) at idle.
Do the same starting from the brake booster unit (the round unit) on the drive side fire all.
Carefully listen for increase of RPM right after to spray the Berryman to the potential vacuum spot.
Get a friend to HEAR the ROM increase or monitor for RPM on the tech.
DO NOT AIM the Berryman into any heat source.
PLEASE RATE my answer if it is useful to you.
Posted on Dec 14, 2009
my 92 honda accord check engine light comes on and the car dies and won't restart. need help/ changed the ignition swith.
Posted on Jan 12, 2011
Tips for a great answer:
Jan 02, 2016 | 1999 Honda Accord
Dec 28, 2015 | Honda Cars & Trucks
Apr 23, 2014 | 1999 Honda Accord
Jul 11, 2012 | 2004 Chrysler PT Cruiser
Nov 28, 2011 | 2004 Honda Accord
Aug 26, 2011 | Honda Civic Cars & Trucks
Oct 13, 2010 | 1989 Honda Accord 4 Door
Apr 27, 2009 | 1992 Honda Accord
93 people viewed this question
Usually answered in minutes!