Question about 2010 Hyundai Santa Fe

Open Question

2011 Hyundai Santa Fe limited starter how to change

How do I locate and change 2011 limited front wheel drive 2.4l

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 566 Answers

SOURCE: front wheel alignment

thanks for your reply/update the reason for front tyres wearing as you describe would suggest the steering tracking is wrong and for some reason ?the tyre wear on inner isindication the track is toeing out too much ? this fault could be ? simple adjustment req'd however dependand on make of tyres has to be considered when tracking as to whether they toe in or out or straight ahead ? also front wheel drive ? there could be other factors b4 tracking is adjusted such as steering joints wear ? or damage ? also suspension ? as i mentioned best to visit a good tyre depot and let them investigate while you wait and give you a reportas to fault normally free in uk if it is simply tracking req's re adjust then they can do it and charge for the adjusting not expensive and they may also recommend switching wheels from rear to front providing tread are good ? hope this helps best wishes

Posted on Mar 31, 2009

Ad
  • 27 Answers

SOURCE: starter

starter is under neath opposite ur raidiator bolts to it are from tranny to starter

Posted on May 23, 2009

  • 87 Answers

SOURCE: 2002 hyundai santa fe front transmission leak

swap w/rear radiator rear doesn't require fluid.

Posted on Jul 28, 2009

cansmo
  • 2431 Answers

SOURCE: 2001 hyundai santa fe starts with one crank but won't go into drive or reverse, only goes into park and neutural what could be the problem? i have a 2001 hyundai santa fe 2.7 l v6 all wheel drive

You do have drive and reverse,if you have park and neutral.It just the transmission cant transfer that power a new or rebuilt is the solution

Posted on Mar 20, 2012

petebulka
  • 116 Answers

SOURCE: speedometer not working 2001 hyundai santa fe 2.7 auto.all wheel drive

Did you change the plastic gear that goes on the vehicle speed sensor when you changed the sensor? Those wear out as well.

Posted on Aug 02, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 Hyundai SantaFe AWD 3.5L 6cyl. getting a P0017 error code, indicating the Crankshaft position sensor. Where is this located? Im handy, but not a mechanic. Where is the sensor?


Generally on the santa fe it is located just behind the crankshaft pulley/harmonic balancer (the pully lowest in the engine compartment driven by the drive belt).

Feb 14, 2017 | 2011 Hyundai Santa Fe

2 Answers

What tools do I need to replace the starter on a 2006 Santa Fe Limited?


Made a video showing how I replaced the starter on my 2005 Hyundai Santa Fe. Should be the same.

May 08, 2015 | 2006 Hyundai Santa Fe

2 Answers

Hyundai santa fe starter were is it located


On the 3 different engines (4 cyl & both V6s) on LH side (radiator side) below the exhaust manifold. All have two14mm bolts mounting them to the engine.
ILLUSTRATION:


ghost45_24.jpg

ghost45_25.jpg

ghost45_26.jpg

Aug 27, 2011 | 2004 Hyundai Santa Fe

1 Answer

The Hyundai Santa Fe is 4X2 or 4X4????? Please.


Hello! the 2002 Santa Fe has optional All Wheel Drive (AWD)...Which is permanent (can not be turned off)...If the option is not on your vehicle then it is Front Wheel Drive (FWD) only...The VIN # will tell you if the option is on your vehicle...

Guru...Saailer

Feb 09, 2011 | 2002 Hyundai Santa Fe

1 Answer

2004 Hyundai Santa Fe 2.7 all wheel. Crank sensor


Hi

On the 2.7 engine it is located beside the starter. You will have to remove the starters heat shield to gain excess to the crank sensor.

Jan 25, 2010 | 2004 Hyundai Santa Fe

1 Answer

Electrical problem 2007 Hyundai Santa Fe 6 cyl All Wheel Drive Automatic 95000 miles Hyundai Sante Fe 2007 with 95,565 KM Cigarette lighter and power outlets dead All three outlets are gone dead 2 in the...


that can be 2 posibly..
1. check your batery still good or not
2. check your regulator (function is to recaharge batery when car is moving, if the regulator is not working replace it

Sep 10, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Starter


starter is under neath opposite ur raidiator bolts to it are from tranny to starter

May 22, 2009 | 2002 Hyundai Santa Fe

1 Answer

Location of oil filter on 2008 Santa Fe Limited


if it is a 3.3L it is a canister filter on top of the engine, the cover will need to be removed. make sure to change the o-rings. if it is a 2.7L, on bottom of engine near front of engine.

Apr 30, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Is it hard to change crank shaft position on hyundai santa fe 01


2.7 engine located above the starter. You need to remove the starter outherwise its fairly easy.
The 2.4 & 3.5 engine, its located in the front next to the timing belt, a little more complicated to to install.

Apr 14, 2009 | 2001 Hyundai Santa Fe

Not finding what you are looking for?
2010 Hyundai Santa Fe Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...