Cars & Trucks Logo

Related Topics:

j
joey clark Posted on Mar 22, 2014

Blower does not blow in slk200

Hedgehog replaced last year, worked fine after, heat comes through when driving

5 Related Answers

Anonymous

  • 3533 Answers
  • Posted on Feb 01, 2009

SOURCE: 2002 lincoln town cae blower problem

if you have checked the fuse and they are good and there is power going to the blower replace the blower you should be able to pick one up at a good salvage yard at half the cost.

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 08, 2009

SOURCE: 2000 Chrysler Town & Country , no heat, blower fan working fine

Probably one of two things. First make sure that your coolant level is full. If the coolant is not flowing properly you won't get heat. If you begin to get heat while driving, but only when you are excelerating, this is your problem. If that is not it you may need to change the thermostat. This is noot hard as long as it is easy to get to and it should be easy.

Jonah Oneal

  • 14092 Answers
  • Posted on Sep 02, 2009

SOURCE: 2000 Wrangler blower won't work

HOT WIRE BLOWER MOTOR IF IT WORKS PROBLEM IN THE BLOWER RELAY AND RESISTOR.IF BLOWER DONT WORK REPLACE IT.

Anonymous

  • 175 Answers
  • Posted on Dec 08, 2009

SOURCE: Blower on heater works sometimes, sometimes it

Sounds like the blower resistor. It will either be located in the engine compartment outside the motor or inside the vehicle inside the blower motor cover. It could also as well be selector switch

Anonymous

  • 2 Answers
  • Posted on Dec 30, 2009

SOURCE: heater not working right in 1999 silverado

First check the coolant level if the engine is hot check the reserve jug on the firewall--if cold before start up remove the radiator cap and check coolant level add as needed. If the thermostat has been removed it needs to re-installed. It is possible that the heater hose(s) is stopped up. After letting it run for a period of time both heater hoses should be hot to the touch if they aren't something is restricting the flow of coolant the system needs to be drained and flushed. I have also see some vehicles form an air lock in the coolant system causing the same thing. It then needs to be (burped). This can be checked/done by removing the radiator cap while the vehicle is idleing and watching the water level in the radiator squeeze the upper radiator hose to see if the water/coolant level rises in the radiator. When you release the hose you may need to add some coolant this forces out the air. Hope one of these things. These are some of the cheapest fixes and if they don't work/help then you need to start looking at the heat control selector.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

2004 explorer, blower motor runs on 1 & 4 ONLY. Replaced resistor but still have the same problem, HELP!!!

You will need to replace the blower motor itself. I had the same problem last year. This year I have no heat at all but the fan blows at all speeds :)
0helpful
1answer

My 1999 alero fan will not work.I have replaced the blower motor and checked fuses and still nothing.The heat and air are working fine just not blowing.

Its either a bad connection on the blower motor resistor or a faulty blower motor resistor.These are known for over heating.
0helpful
1answer

I got a 94 chevy cavalier. it was blowing heat just fine last night but when i went to start it this morning i noticed it wasn't blowing. its been cold and vary snowy the last couple of days if that helps.

if the fan is blowing and you have no heat and the car runs at the normal temp range then it would be your heater core needs to be replaced,if you have heat and its not blowing it would be the blower motor needs to be replaced ,or the switch is faulty.
0helpful
1answer

A/C works fine, the blower's fine, replaced thermostat, no heat.

If you don't hear a thud or noise of a flap opening or closing when switching between hot and cold then a lever is probably broken.
4helpful
2answers

1999 town car blower motor resistor.....maybe?

The Blower Motor Resistor is a common problem in your car but not for the problem you describe. When the Heat/AC won't blow on all speeds, the blower motor resistor is at fault. When air won't blow out of vents, bi-level, or floor the problem is the blend door actuator. This is vacuum driven and diverts the air to where you select. When air will only blow from one place (usually the defrost) then the blend door actuator is the problem. This can sometimes be corrected if there's a vacuum leak (usually under the hood in front of the passenger you'll find the vacuum line and can trace it backward to find a leak). If no leak can be found, the blend door actuator itself is defective and needs replacement.
0helpful
1answer

Blower motor problems/ac problems

List of possibilities :
blower motor
resistors
switch(On/OFF)
0helpful
1answer

2002 lincoln town cae blower problem

if you have checked the fuse and they are good and there is power going to the blower replace the blower you should be able to pick one up at a good salvage yard at half the cost.
0helpful
1answer

Heater/ a/c blower

There is a 30 amp fuse for the blower. The blower motor resistor could be bad.
Not finding what you are looking for?

103 views

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...