Question about 2005 Mitsubishi Outlander

Open Question

After a sudden overheating episode on 2005 mitsubishi outlander where the engine quit have replace the radiator, headgasket, timing belts now engine wont start

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

deathraider
  • 64 Answers

SOURCE: Mitsubishi outlander overheating for

more than likely the thermostat is bad (not opening ) need more info ..... only when idling ? do the fans kick on ?

Posted on Dec 04, 2008

  • 337 Answers

SOURCE: Cam Belt

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528019079d

Posted on Dec 08, 2008

Mike258
  • 1498 Answers

SOURCE: serpentine belt replacement

Hi Paul,

The routing diagram is under the hood.

  • Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar.
  • Get the belt around all the pulleys except the A/C compressor or Alternator.
  • The tensioner pulley is near the Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley.
  • Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley.
  • Slowly release the tension.
  • You're done
Mike

Posted on Dec 14, 2008

ewashmidas
  • 362 Answers

SOURCE: Cam Belt on Outlander 2.4 litre Petrol - 2004

The vehicle has a belt and should be changed every 60,000 miles.

Posted on Jan 31, 2009

ftw1952
  • 10319 Answers

SOURCE: At what mileage should I change the timing belt on

It is suggested by any mechcanic to perform this maintenace every 80,000 miles if you properbly maintain your vehicle. That mean going by the owners manual suggestions. Also I would highly recomend changing the water pum as well for it runs off this belt and water pumps only last as long as the belt will also. If a new belt is installed without a new water pump it may fail in no time. I seen it happen more than a dozen times in the past ten years

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 mitsubishi outlander waterpump/timing belt issue.


If you know about timing belt driven water pumps.. you know that you have to reset your timing on the engine. If you think you can. Tear it down.. replace the pump. And go onto the internet and find that engine and ask for timing marks.. reset them.. and all will be fine.. hope this helps.

Apr 22, 2017 | 2004 Mitsubishi Outlander

1 Answer

Overheating


bendu
check the valve,crank and injection pump timing well
change engine thermostart, check the turbo unit ,
. viscos and belt tension

Jun 25, 2012 | 2005 Toyota LandCruiser Prado

1 Answer

Following timing belt replacement on 2.4 liter engine there is excessive engine noise/ vibration when accelerating. What might be the cause?


it sounds like your balance shaft is out of position. its timing may have been disturbed during the timing belt installation.

Aug 01, 2011 | 2005 Mitsubishi Outlander

1 Answer

WOULD U HAVE A DIAGRAM FOR 08 OUTLANDER DRIVE BELT


SHOULD BE ON STICKER UNDER HOOD OR ON RADIATOR COVER

Mar 30, 2011 | 2005 Mitsubishi Outlander

2 Answers

How important is it to change the timing belt on a 2003 Mitsubishi Outlander every 100 000KM ?


it is very important, if the belt fails it will severly damage the engines valves and this repair will cost $1000's

Jul 30, 2010 | 2003 Mitsubishi Outlander

1 Answer

Mitsubishi Challenger overheating


Save yourself a big headache and get a new radiator!!

Jan 12, 2010 | 2003 Mitsubishi Outlander

1 Answer

1992 Honda Civic over heating replace theormostat - still overheating air bubbles in overflow jug and in radiator when running with cap off...


here is a check list for common overheating issues low coolant? Any leaks? A headgasket leak? To test that use a coolant mix tester. Do the cooling fans run with the engine hot? Is the rad cap holding pressure? This can be tested usually its easier to swap it with a working one or buy new. Lastly the waterpump and timing belt. If the timing belt if old/high mileage or the tensioner faulty it can cause overheating. The common practice is to replace the timing belt every 100,000miles along with the waterpump and the belt tensioner

Dec 28, 2008 | 1991 Honda Civic

2 Answers

Mitsubishi outlander overheating for no reason


more than likely the thermostat is bad (not opening ) need more info ..... only when idling ? do the fans kick on ?

Dec 04, 2008 | Mitsubishi Outlander Cars & Trucks

Not finding what you are looking for?
2005 Mitsubishi Outlander Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...