Question about Toyota Yaris

1 Answer

Changing headlight on toyota yaris nearside

How do i change the headlight bulb on the nearside of a toyota yaris 08

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 20,706 Answers

That is covered in the operators guide in the glove box.
lost that>?
rtm , read the manual, its here free every day.


Posted on Dec 02, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
AlmostBob
  • 550 Answers

SOURCE: how do i change the headlight bulb in a 2005 sebring convertable

Lift up the hood, the bulbs are changed from the engine compartment
behind the lamp are connectors, pull it off, and the retainer that holds the bulb in
replace bulb
replace retainer
replace wire
close hood
usually takes longer to type than to do

Posted on Jul 14, 2008

LEFTY64
  • 69 Answers

SOURCE: I need to replace the headlight on my 1994 Toyota Pickup

CAUTION Most headlight retaining rings and trim bezels have very sharp edges. Wear gloves. Never pry or push on a headlamp; it can shatter suddenly.

  1. Make sure the headlight switch is in the off position.
  2. Loosen the parking and side turn signal unit retaining screws. Then remove the units unplugging the connectors.



0900c15280061083.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: After removing the parking lamp screws, push on the grille clips to release the grille from the truck
  1. Next, open the hood to gain access to the grille clips. Using a flat-bladded tool, push on the clips to release them and the grille.



0900c15280061084.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: Remove the grille from the truck and set aside
  1. The sealed beam is held in place by a retainer and either 2 or 4 small screws. Identify these screws before applying any tools.DO NOT confuse the small retaining screws with the larger aiming screws. There will be two aiming screws or adjustors for each lamp. (One adjustor controls the up/down motion and the other controls the left/right motion.) Identify the adjustors and avoid them during removal. If they are not disturbed, the new headlamp will be in identical aim to the old one.



0900c15280061085.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 3: Remove the headlight bezel which is secured by screws
  1. Using a small screwdriver (preferably magnetic) and a pair of taper-nose pliers if necessary, remove the small screws in the headlamp retainer. DON'T drop the screws; they vanish into unknown locations.



0900c15280061086.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 4: Be careful when removing the headlight bezels, they can be sharp
A good kitchen or household magnet placed on the shank of the screwdriver will provide enough grip to hold the screw during removal.
  1. Remove the retainer and the headlamp may be gently pulled free from its mounts. Detach the connector from the back of the sealed beam unit and remove the unit from the car.



0900c15280061087.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 5: Pull the light out, then unplug the wiring harness from behind it

Posted on Apr 07, 2009

ourhowse
  • 2007 Answers

SOURCE: How do you change the headlight bulb (low beam) on

You should be able to access the buld holder from the rear of the headlight. It's a nylon bulb holder with a lock thing on it. You squeeze the lock part and turn it counterclock wise, and it should come out. Remove the old bulb and install the new one being careful not to touch the glass of the new bulb with bare fingers. The finger print you will leave can cause the bulb to prematurely die on you.

Posted on Jun 15, 2009

  • 347 Answers

SOURCE: change headlight bulb in Toyota Camry 2004

there is a bulb housing behind the lens. remove it and the bulb.

Posted on Sep 18, 2009

  • 5 Answers

SOURCE: how to change an indicator bulb on a vw crafter

You have push top of large mirror is asif you were adjusting it to its highest position, then slide the mirror glass up and off, this in turn allows you access to the screws that hold the whole light unit in place which with the aid of some torx bits which are inside mirror casing you can remove. hope this makes sense.

Posted on Jan 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my alarm In my 2010 Yaris stop working?


Check your fuses located behind the left headlight. Refer to the fuse diagram on the fuse box cover.

How to check and change fuses Toyota Yaris Year models 2006 2011

Feb 28, 2015 | 2010 Toyota Yaris

2 Answers

How to replace a front side marker bulb on a 2007 Toyota Yaris Sedan


You don't need a dealer for much of anything

All of todays vehicles require removing the lamp
assembly or housings,front or rear, of any vehicle,to
take out the lamps/bulbs

If you open the hood you will find screws that hold it in place

May not be an easy job, but that's the junk were sold

Sep 05, 2012 | 2007 Toyota Yaris

1 Answer

I cannot seem to change my headlight bulb on the passenger side of my 2007 yaris hatchback. In the owners manual it sayds to puul out the rubber boot. I disconnected the cord going into the headlight but I...


I am not familar with your specific car but as you say already have the boot and connector already off, look at it and see if there is not some sort of wire retainer holding the bulb in place. If so, release it. The other possibility is the bulb retainer twists in to openings to secure the bulb. attempt to twist the bulb. It is difficult to see down there so get a small mirror and angle it to see what you are dealing with. Good luck

Feb 20, 2010 | 2007 Toyota Yaris

1 Answer

2004 yaris how do you change headlight bulb passenger side as there is no room for your hands to get in


to change passenger side headlight bulb,on 04 plate yaris, remove bulb cover at rear of lamp,take off fuse box,although this only gives you slightly more room,and have someone with small hands,replace bulb,as it is nearly impossible if you have large hands.It is awkward but can be done,EVENTUALLY.

Feb 05, 2010 | 2007 Toyota Yaris

2 Answers

How to change brake lights on my 2007 toyota yaris


on either side of the boot interior, there are what look like air vents. these clip out from the top (with a flat screwdriver) you then unbolt the light unit, pull it out. the bulb holder then unclips easily.

Jul 13, 2009 | 2007 Toyota Yaris

1 Answer

Changing bulb in headlight


push one side of it down ,the opposite end to the screw

Jan 04, 2009 | 2007 Toyota Yaris

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...