Question about 1985 Chevrolet Chevy

1 Answer

Chevy k10 turn signal

My chevy k10 pickup 4x4 short bed i dont know if it has turn signal i the front there is a yellow bolt hangin but there is no were to asemble it and i need to know for the inpextion on light and brakes ?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 75,822 Answers

Without a diagram I have no idea

Posted on Mar 22, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: brake caliper removal

Sometimes they use a T-50 torx bit, and sometimes they use either a 15mm or 18mm bolt, however the caliper bracket is a 21mm bolt

Posted on Oct 06, 2008

  • 341 Answers

SOURCE: brake line for 94 Chevy S-10 pickup

thats a common placc for them to rust out you will need 10 feet of 1/4 in. brake line that will go front to back

Posted on Oct 21, 2008

dennymulford
  • 1055 Answers

SOURCE: rear brakes locked up. 1990 chevy c1500 2wd pickup

did you see if they need replaced?
and also the emergancy cable may be froze

Posted on Aug 12, 2009

  • 4 Answers

SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards

I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!

Posted on Oct 11, 2009

  • 1 Answer

SOURCE: 2007 chevy silverado brake lights dont work

I had the same problem! I used a piece of wood to keep the break pedal depressed and then started to remove one of the break lamps and to my surprise it came on! Same thing on the other side. So I did not seat (bottom out) the lamps in their sockets and both break light are now working properly. I had a similar issue last spring but that time only one light was out. I put in a new bulb and it still did not work so I messed around with it a little more and it started working. Never did figure it out until now. Hope this helps!

Posted on Mar 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove gas tank from 1991 chevy 1500 4x4 how to remove the straps


It is easier to take the bed loose and pick up the bed. there is 8 bolts and the gas filler neck too take loose.first you open up the gas door, and around the gas cap there will be 3 7mm screws then under the truck the 15mm bolts are on top half of the frame.these bolts are spaced from front to rear on bo th sides of the bed.then look at the rear of the truck, behind the bumper. you will find a plug that goes to the taillamps. unplug that connector .4 or 5 guys move can pick that bed up and just move it backwards,over the tires.if you dont have the manpower then take a big floor jack and position a 4x4 about 1/ 1/2 ft long. stand the 4x4on the jack saddle, and jack up the bed.pay close attention to the gas filler neck and other things, while going up. just go slow, up and down. you will need someone to watch the filler neck when you go back down

Oct 23, 2011 | Cars & Trucks

2 Answers

On an 81 through 87 chevy truck. my question is the only difference between the short wide truck and the long bed the lenght of the bed? i have a long bed and what to take the bed off and put a short bed...


No I don't believe it will as the frame/ wheel base is different. to check measure from the front of the bed to the bolts in the bed. This will let you know.

Feb 19, 2011 | 1985 Chevrolet Chevy

3 Answers

Where is my fuel pump located in a 1994 cheyenne chevy pick up 4x4 5.7 v8


Hello
The fuel pump is elelctic and it is located inside the fuel tank, the fuel tank must be removed to service the fuel pump.

Nov 11, 2010 | 1994 Chevrolet C2500

1 Answer

Chevy S10. When my running lights are on everything works (except turn signals), front lights, tail lights brake lights. When I turn on my headlights turn signals still dont work everything comes on fine...


Check the grounds on your wiring.
If you have a trailer harness, make sure there are no shorts, or crusty connections

Good Luck chasing the gremlins

Oct 13, 2010 | 1996 Chevrolet K1500

3 Answers

Where is the turn signal flasher located on a 1998 Chevy S10 Pickup?


take down the bottom panel below the steering column, which runs across the lower part of the dash, between the torx bolts and 7mm bolts it comes out and they are right below the radio area two silver flasher relays one is the hazards the other is the turn signals

Jul 04, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

85 Chevy k10 pickup: Working headlights, but no park/tail or turn/hazard lights.


one of your bulb is blown one bulb will shut the rest off check all your bulbs.

Jun 03, 2009 | 1985 Chevrolet Chevy

1 Answer

How to put a cd player in my 86 chevy k10 short bed 4x4


you will have to cut the dash if you want to update the stereo. I did it on my '85 silverado, not that big of a deal

May 10, 2009 | 1983 Chevrolet Silverado

1 Answer

Chevy k10 headlight/taillight problem


the fuses are located on the left side of the drivers foot well. these trucks have problems with rot and when they start to fall apart the beds move around and short out the taillights and youll usually lose the dash lights with the tails but the headlights are separate.

Jan 20, 2009 | 1984 Chevrolet Chevy

2 Answers

I need to know what the timing should be set at for a 1986 chevy 4.3 motor pickup truck half ton 2 wheel drive short bed


Timing at idle (degrees BTDC) 0 federal and 4 California (chapter 5, page 183, Haynes Chevy and Gmc pick-ups manual 1967 thru 1987) If you have any othe questions I have the manual, I have an 86 k10 4x4 w/350.

Jan 03, 2009 | 1988 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...