Question about 2005 Chevrolet Equinox

1 Answer

Sunroof open will not close 2005 chevrolet equinox

Sunroof open in vent position will not close replaced fuse already

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 173 Answers

Need check your swich

Posted on Mar 22, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2005 chevrolet equinox

its a real pain spend the $ and get a mechanic to do it i have one and no fun

Posted on Jun 29, 2008

  • 399 Answers

SOURCE: 1998 Chevrolet Cavalier sunroof will not open

if the roof is stucked up pull at the rubber lining around the inside of the sunroof (the one that seems like its just for looks) near the control button. then pull down on the inner roof cover and you'll see the back of the control button. there is an electrical connection there. see if it has come apart,. also check out if the motor of the roof control is spinning.if it is not spinning then replace the motor to make it work.

Posted on Dec 06, 2008

  • 72 Answers

SOURCE: 2006 Chevrolet Equinox Driver's door will not open the door

Sounds like the release rod came off of either the main latch or the inside release handle. My guess would be the latch since I don't see many problems with the inner handles. To check you have to remove the door panel. Follow the rod to the latch area. There should be a plastic type of clip that the rod came off of in the general area of the end of the rod. The rod may just push back into place.

Posted on Dec 18, 2008

  • 1596 Answers

SOURCE: P0404B Code for Equinox 2005

If there was A Problem With EGR Valve stuck Open You WOULD KNOW IT as it would have a Performance Problem. I Think its a Falce Code and I Recomend CLEARING CODES and Starting over With a Clean slate. you Should Be Able to Disconnect the POS Batery cable for 30 Seconds to Clear it . try this Before Going to Dealership or Any Shop.
Please Dont forget to RATE ME PLEASE, Many do Forget, Thank You and Good Luck !!

Posted on Mar 27, 2009

  • 12104 Answers

SOURCE: fuse for fuel pump on a 2005 chevrolet equinox

no could b a bad relay or the connection at the fuel pump r other if u have to volt meter /ohms meter check relay to see if good

Posted on Sep 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sunroof does not open. Fuse is ok and the shade operates normally.


Do you know how to do automotive electrical testing ?????? How to read a wiring diagrams ???? http://www.bbbind.com/free_tsb.html .Videos on youtube Ohms Law Tech Tip from L1 with Dave Hobbs Copy of Voltage Drop Essentials TST Motor Age The only way to find the problem , testing !

Sunroof Description and Operation (One Connector System)
Sunroof
This diagnostic procedure is to be used for the 1 connector Sunroof System that combines the sunroof control module with the sunroof motor/actuator.
The Sunroof System consists of the following components:
• BATT MAIN 2 Fuse 50 A
• Body control module (BCM)
• RAP relay
• S/Roof Fuse 20 A
• Sunroof module (includes sunroof motor/actuator)
• Sunroof switch
The Sunroof System is controlled by the sunroof switch and the sunroof motor/actuator assembly.
When the ignition is turned to RUN or ACCESSORY, or when the retained accessory power (RAP) system is active, the body control module (BCM) applies a ground to the RAP relay in the instrument panel (I/P) fuse block. This activates the RAP relay and allows battery positive voltage to be applied through the SUNROOF Fuse to the sunroof module. Ground for the sunroof module is supplied from G302.
The sunroof can be placed in 3 preset positions:
• Open
• Vent
• Closed
When the sunroof switch is placed in the OPEN position, a ground is applied from the sunroof switch low reference circuit , through the sunroof switch and to the sunroof switch open signal circuit. The sunroof motor/actuator then applies voltage to the sunroof motor open control circuit and applies a ground to the sunroof motor close circuit. The sunroof motor then opens the sunroof to the full open position.
When the sunroof switch is placed in the VENT position, a ground is applied from the sunroof switch low reference circuit , through the sunroof switch and to the sunroof switch open signal circuit. The sunroof module then applies voltage to the sunroof motor open control circuit and applies a ground to the sunroof motor close circuit. The sunroof motor then opens the sunroof to the VENT position.
When the sunroof switch is placed and held in the CLOSED position, a ground is applied from the sunroof switch low reference circuit , through the sunroof switch and to the sunroof switch close signal circuit. The sunroof module then applies voltage to the sunroof motor close control circuit and applies a ground to the sunroof motor open circuit. The sunroof motor then closes the sunroof.
The sunroof can be placed in any preferred open position when:
• The sunroof is in the fully opened position by pressing and holding the sunroof switch in the CLOSE position until the panel has reached the desired position then release the CLOSE switch in order to stop the sunroof
• The sunroof is opening, it can be stopped by momentarily pressing either side of the switch.
The sunroof control module, sun roof actuator, and the sunroof motor are integral parts of the sunroof module assembly and are not service separately.

Your best bet , take it to a qualified repair shop or buick dealer .

Feb 10, 2017 | 2010 Buick LaCrosse CXS

1 Answer

2005 chef Equinox brake light wiring diagram


http://bbbind.com/free_tsb.html free wiring diagrams !
Stop Lamps
The 15A BRAKE fuse located in the fuse block - underhood, supplies battery positive voltage to the normally open stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both left and right stop lamp assemblies, the center high mounted stop lamp (CHMSL), the powertrain control module (PCM), and the throttle actuator control (TAC) module. The stop lamps are grounded at G401 and G403. The CHMSL is grounded at G301.

Jul 23, 2016 | 2005 Chevrolet Equinox LT

1 Answer

My Pontiac G6 Sunroof is stuck in the vent position.


might try spraying white lithium grease on the slides and open and close few times my g6 did the same thing grease it and open and closed a few times then it work

Feb 28, 2015 | 2006 Pontiac G6 GTP

1 Answer

2001 yukon xl which fuse is the sunroof fuse


In the under hood junction box , fuse CTSY LP 15 amp . Instrument fuse panel PWR WDO CB 25amp .
Sunroof Motor Synchronization
Synchronization will be necessary anytime the sunroof module battery positive voltage circuit is interrupted. The sunroof module will be synchronized when the controller learns the full vent position. The sunroof system will ignore any open request until the system has been synchronized.
To synchronize the sunroof:
  1. Turn ON the ignition, with the engine OFF.
  2. Using the close/tilt up portion of the sunroof switch, operate the sunroof glass until it reaches the full vent position.
  3. Verify that the system operates normally.
Once the sunroof glass reaches the full vent position, the actual position is stored in the memory of the sunroof module. The sunroof module will stop the motor one motor revolution before the defined actual positions
Hope this help ! good luck !

Dec 24, 2014 | 2001 GMC Yukon XL

1 Answer

How to manually close my 2005 chevy equinox sunroof


there is no access to do this. only way to close it would be to disengage the sunroof from the tracks and motor very difficult to
do best to bring it to experienced tech

Dec 03, 2014 | 2005 Chevrolet Equinox

2 Answers

2005 Chevy Equinox sunroof problems


Some customers may comment that the sunroof will no longer respond to the control switch while in a vented, partially opened, or fully opened position.
Cause A software issue with the sunroof control module may cause the sunroof control module to incorrectly indicate a "closed" position, which may result in no power to the sunroof motor.
Correction Verify the customer concern. If a condition is present, replace the sunroof control module with a new sunroof control module, P/N 15847643. Refer to the Service Procedure in this bulletin.
Service Procedure
  1. Verify the customer concern by opening and closing the sunroof. • If the sunroof will not open , check the power windows. - If the power windows are also inoperative, check the fuse. If the fuse has opened, refer to Corporate Bulletin Number 05-08-64-004 to install 30A circuit breaker. - If the power windows are fully functional, refer to "Power Sunroof Inoperative" diagnostics (SI Document ID# 1392967) in the Body section of the 2005 Chevrolet Equinox or Saturn VUE Service Manual. • If the sunroof will open (or is already open), but will not close , proceed to Step 2.
  2. Replace the sunroof control module. Refer to "Sunroof Control Module Replacement" procedure in the Body section of the 2005 Chevrolet Equinox Service Manual (SI Document ID# 1196049) or Saturn VUE Service Manual (SI Document ID# 1710479).
  3. Open and close the sunroof in order to confirm that the customer concern has been resolved.
Parts Information Part Number
Description
Qty
15847643
Sunroof Control Module
1

Jun 20, 2009 | 2005 Chevrolet Equinox

2 Answers

Sun roof does not work


Dear cz50001: there are only a few things that you, a weekend warrior can do to diagnose and/or fix the problem on your car.
Unfortunately the newer cars get, the more complex they get.
Unfortunately, your car is one which falls in the more complex category. Your car is designed with a "BODY CONTROL MODULE". This little gem gets input from nearly every electrical component in the car including the sunroof. In terms of what you can do to check it out: The fuse box inside the car has roughly 24 fuses positioned vertically 12x12. The fuse located at the lower left side of the box is a 10A "red in color" is for the sunroof. Remove it and look through it to see if it has been burned through the center. If it has, replace it and try the sun roof. If the fuse blows again, you have a short and it would be best left to a professional.
There is another set of circumstances which can occur that will render the sunroof inoperable. If the battery is disconnected or if the sunroof motor had been disconnected, the sunroof will stop operating. To reset the sunroof memory, with the key in the on position, push and hold the sunroof tilt switch in the forward (up) position until the sunroof is fully vented (tilted up) position. It should at that point operate normally. Should those two suggestions not solve your problem, it requires either a dealership with a specialized tool called CONSULT-11 to communicate with the BCM. There are some specialty shops such as mine equipped to deal with your car as well. However, most can not address this type of problem without this diagnostic tool. Good luck.

Apr 05, 2009 | 2005 Nissan Altima

1 Answer

2002 Oldsmobile Alero Sunroof Stuck in the Vent position


The sunroof continues to open and close normally from front to back, but the vent stays open.

Apr 01, 2009 | 2001 Oldsmobile Alero

1 Answer

Chevy Tahoe Sunroof is stuck open moves slightly forward and back


It sounds like it just needs to be reinitialized. Turn your key to the on position with motor off and hold the up/full vent button down for at least 30 seconds or until your sunroof either clicks or goes to the full vent position. That should fix your problem.

Mar 07, 2009 | 2004 Chevrolet Tahoe

Not finding what you are looking for?
2005 Chevrolet Equinox Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...