Question about 2005 Mitsubishi Colt 1.1

Open Question

Reset immobilizer Immob fault, according to scan tool. *P0513 Immob unit ecm comm error. How do I go about this situation in the best, quickest and cheapest way? Thanks. Rob 0417175645

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P1260 code detected on my 99 xj8 jag how do I fix


code p 1260 refers to vehicle immobil;izer invalid ignition key/immobilizer system fault
try using the scan tool to reset the ECM or talk with a dealer service center for the immobilizer problem
make sure that the battery in the key fob is fully charged if it just happened

May 12, 2017 | Cars & Trucks

1 Answer

2007 Chrysler Town & Country PO code PO531 need help on resetting


You gave two different codes.

P0531: A/C Refrigerant Pressure Sensor Circuit Range/Performance
http://www.autocodes.com/p0531_chrysler.html

P0513: Incorrect Immobilizer Key
P0513 Dodge Incorrect Immobilizer Key

Nov 03, 2016 | 2007 Chrysler Town and Country

2 Answers

I got a new battery and a new starter on my dodge grand caravan and my van gave me a code reading p0513 my key is not getting no signal and it's not starting my car I don't no what's the problem


The Internet, though, has a large number of web sites where
you can buy service manuals and schematics from bookstores,
publishers, and other collectors. Here is just a sampling of
what sites are out there:

Chilton Repair Manuals

http://www.chilton.cengage.com/

Haynes Publishing
Haynes auto manuals

http://www.haynes.com/

Factory Automanuals
http://www.factoryautomanuals.com/

Vintage Books
Vintage books com Rare used and out of print books

http://www.vintage-books.com/

AutoLit
http://www.autolit.com/home.htm

Jan 13, 2016 | Dodge Cars & Trucks

1 Answer

MY SCAN TOOL WILL NOT LINK TO ECM


Almost sounds like a security system/immobilizer issue. Did you recently disconnect or replace the battery? Is the security light on the dashboard blinking? You may need to have the security system reset.

Dec 23, 2014 | 2002 Pontiac Firebird

1 Answer

Ecm control switch


No switch just EFI relay to supply power to ECM. If your ECM seems like it's not activating other system like fuel pump relay, ignition coil,etc.etc. check that your immobilizer has been disabled. Some immobilizers will disable the ECU totally. Newer models have RFID type keys that needs programming if damaged. Best to scan your car and get the error codes before replacing anything.

Apr 17, 2014 | 2000 Kia Sportage

1 Answer

Immobiliser bypass


The motor can be replaced without touching the immobilizer system. There may be no problem with the immobilizer system as it only turns off power to the fuel pump or ignition spark.
better yet just re-seed the immobilizer ECM with the dealer

Apr 17, 2014 | 2006 Toyota Hilux 2.0

1 Answer

I have problems with my dodge grand caravan 2005 won,t start an show this code p0513


P0513 - Incorrect Immobilizer Code
Possible causes- Open or short immobilizer circuit
- Poor electrical connection for immobilizer circuit components
- Faulty immobilizer control unit
- Faulty immobilizer key
- Faulty immobilizer key antenna

Read more: http://engine-codes.com/p0513.html#ixzz24sUqroQI

Aug 28, 2012 | 2005 Dodge Caravan

1 Answer

HELP! I have a Daewoo Lanos(1998-99), ive got a


The fault code 53 is an ECM IMMOBILIZED ERROR.
The immobilizer anti-theft system thinks the key is invalid. If it detects an error, it will;
Disable the fuel injector circuit--- Disable the fuel pump circuit---Disable the ignition coil.

Code 53 will set when:
1- The Eectronic Control Module (ECM) does not receive the signal from the Immobilizer Control Unit (ICU) within 0.9 seconds when vehicle is stationary, or 1.8 seconds when vehicle is moving.
2- The ICU sends the ECM an incorrect release message more than 5 times.
3- The above conditions continue until the ignition is switched off.

I hope this helps.

Aug 24, 2011 | 1999 Daewoo Lanos

1 Answer

Where can i find my freelander immobilizer?


your immob is in three parts, engine ecu talks to central control unit behind fuse board that inturn talks to the alarm rfd unit under dash inthe middle. all can be reprogramed but only as a complete ie all three units can also de chiped to remove both alarm and immob, allowing other make security.there are a few companies here in uk that can offer that service and new fobs.

Jun 02, 2009 | 2002 Land Rover Freelander

Not finding what you are looking for?
2005 Mitsubishi Colt 1.1 Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...