Question about 2006 Audi A6

1 Answer

2006 Audi A6 won't start and can't shift into neutral to have towed ..help

Battery seems to be charged but can't start the car to put it in neutral

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Audi Master
  • 733 Answers

NO LIGHTS COME ON AT CLUSTER??WHAT ARE THE SYMPTOMS EXACTLY??READ MANUAL TO GET THE CAR OUT OF PARK POSITION.

Posted on Mar 22, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

leorcid
  • 281 Answers

SOURCE: Audi A6 Y. 2006

First push the setup button on the MMI control, and push the MMI button that corresponds to the word "settings" on the screen, and pick "time," push the master control to enter that mode, then turn the knob to change the time. Be sure to back out of the sequence properly or the clock reverts to the previous setting.

Posted on Nov 03, 2008

  • 1 Answer

SOURCE: HI , Where is the fuse box on a 2006 Audi A6 ?

In the 2006 A6 (Quattro) model it is in the trunk behind a panel on the right side

Posted on Apr 21, 2009

  • 57 Answers

SOURCE: How To Change Rear Brake Pads on Audi A6 2006

Remove the tires, Remove the calaper bolts, (small heads on them 12mm or so) Remove calaper, Pads are setting in a holder. Lube new pads with litheum grease and place in holder. (look at old pads, one or both may have small metel tab on one end) If the new pads have the tab, put that pad where the old pad with the tab was. (ie. tab to the inside) Press pistion in with a 'C' clamp. If it won't go in easly, it may screw in. If the parking brake cable is hooked to the calaper, it probly screws in. Use large pliers to screw in calaper piston. Place calaper over pads and install bolts (lube bolts) Rember to pump brakes befor driving . to get a solid peddle.

Posted on May 20, 2009

  • 33 Answers

SOURCE: i need a wiring diagram for an audi a6 towbar electrics, can anyone help? please email cantcatchme@btinternet.com

The best solution is to use a Vehicle Specific Wiring Kit, as these cars have complex electronics that do not like being overloaded, Also the car has towing specific safety systems (such at Trailer Stability Program) which only work if it knows it is towing. The car will need to be coded to recognise the towbar wiring and work the saftey systems properly after the kit has been installed. It's not cheap however, Expect to pay around £200-£250 for the whole job.

Posted on Jul 21, 2009

  • 1 Answer

SOURCE: Unmute Speakers on 2006 Audi A6

b0z84p2...

I've been having this problem also. I took it to the dealer and they had to load a new update for the mmi system. Luckily mine is covered under warranty.

The other solution is to turn the car off and disconect the car battery for 10 minutes-and then the mmi will reset itself. The problem, however, is that the issue will probably happen again.

Posted on Jul 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Audi 2003 A6 is stuck in neutral starts but don't move.


Is it a manual transmission or an automatic? If it's a manual (clutch pedal), then you've got a problem for the shop. If an automatic, it should shift into a forward gear or reverse whenever you depress the brake.

Jun 04, 2016 | 2003 Audi A6

1 Answer

2006 murcury mountaineed has a dead battery and won't shift into neutral


Not until you install a new or fully charged
good battery

Mar 05, 2013 | 2006 Ford Explorer

3 Answers

I CAN NOT SHIFT THR TRANS INTO NUTRAL SO I CAN TOW IT BEHIND MY MOTOR HOME. IT WILL SHIFT INTO 2H, 4H, 4L


Shifting to NEUTRAL
To shift the transfer case to NEUTRAL, first make sure
the vehicle is parked so that it will not roll:
1. Set the parking brake.
2. Start the vehicle.
3. Connect the vehicle to the towing vehicle.
4. Put the transmission in NEUTRAL (N) or have
the clutch pedal pressed for vehicles with
manual transmission.
5. Shift the transfer case to 2HI.
6. Simultaneously press and hold the 2HI and
4LO buttons for 10 seconds. The red NEUTRAL
light will come on when the transfer case shift to
NEUTRAL is complete.
7. Shift the transmission to REVERSE (R) for one
second, then shift the transmission to DRIVE (D)
for one second or FIRST (1) for vehicles with
manual transmission.
8. Turn the ignition to OFF.
9. Place the transmission shift lever in PARK (P) or
FIRST (1) for vehicles with manual transmission.
10. Release the parking brake prior to towing.

************************

Shifting Out of NEUTRAL
To shift out of NEUTRAL:
1. Set the parking brake and apply the regular
brake pedal.
2. Start the vehicle with the transmission in PARK (P)
or FIRST (1) for vehicles with manual transmission.
3. Press the button for the desired transfer case position
(2HI, 4HI, AUTO 4WD or 4LO).
4. Put the transmission in NEUTRAL (N) or press the
clutch pedal for vehicles with manual transmission.
5. Shift the transmission lever to the desired position.
After the transfer case has shifted out of NEUTRAL,
the red light will go out.
6. A re-engagement sound is normal when shifting out
of NEUTRAL.

Jan 22, 2010 | 2000 GMC Jimmy

1 Answer

Audi a6 quattro 1.8t It says press clutch pedal to start engine on dash, but its automatic/tiptronic.


The shift needs to be in park or neutral to start. to shift from neutral with the engine running, you have to touch the brakes. Can't explain the label on the dash, unless it has been replaced.

Dec 02, 2009 | 2001 Audi A4

1 Answer

Audi A6 2006 problem with battery


Yes
First thing is to test the battery and this is how Turn on head lights, if dull leave on to see how long the stay on for. Next turn lights off put battery on charge for 6 hrs .Turn on lights again if still dull either battery or charger no good
If lights bright try to start and when starter trys to turn engine over the lights go dim THEN battery is no good.
Then get a jump start from another battery and put pos term on both batterys first, then earth lead(BLACK) on last then start if starts ok remove the BLACK lead and turn on head lights if goes bright ALTERNATORs ok so replace battery ....

Sep 22, 2009 | 2006 Audi A6

2 Answers

A6 2006 model stuck in park


Since it is electronically programmed, it is best to
call your nearest Audi dealer service center to have it checked. Normally, replacement parts for
this kind of defect, is sold by them.

Sep 21, 2009 | 2005 Audi A6

Not finding what you are looking for?
2006 Audi A6 Logo

Related Topics:

201 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14200 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...