Question about 2004 Chevrolet Blazer
Replaced motor and switch
On the driver door where the door bend there is a boot remove it wires are probably cut pull wire one by one
hope it helps
Posted on Mar 27, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I had the same problem to the T. I look online for all the same solutions and I can only tell you what worked for me. Actually what I think worked, HAHA! I went out to my truck and unplugged both battery terminals from battery and placed them together to supposedly reset the electrical system, "so I was told." After this for about 20 min or so, I went back out and in this order; re-installed positive terminal followed by negative terminal to battery. After this I checked locks and windows and surprise they worked. I've seen a lot of people say that all they did was wait and they worked later, so maybe it was that and not what I did, but who cares, they work now. Give it a shot and if it works for you, GREAT let me know, I HATE CHEVY CAUSE OF THIS......they wanted me to pay for a stupid diagnostic before they would help me........well screw you I fixed myself. LATER
Posted on Mar 06, 2009
Tap on the motor while pushing the switch. if this does not work take the motor apart and clean the small brushes that contact the motor shaft 2 total they will have a copper wire attached to them good luck
Posted on May 11, 2009
I believe there is a relay that needs to be reset after you replace the motor. Get a tester and make sure the wire is getting electricity to it too and that it's not just a fuse that's the problem. Hope it helps!
Posted on Jul 19, 2009
SOURCE: 2004 Cavalier Wiper Motor
hi, im not sure if they would have a separate motor each because most vehicles have a linkage bar that connects the two wipers to keep them in time with each other. without the wipers on, try manually rotating the paasenger side wiper (be gentle) if that moves easily and the drivers side does not even flinch, then it could be a broken linkage. hope i helped!
Posted on Jan 28, 2010
Tips for a great answer:
Dec 18, 2017 | 2004 Chevrolet Silverado 3500
Aug 29, 2011 | 2001 Buick Regal
Jul 24, 2011 | 2004 Chevrolet Venture Passanger
Mar 18, 2011 | 2003 Chevrolet Impala
Jan 10, 2011 | 2004 Chevrolet Venture Passanger
Sep 28, 2010 | 2004 Kia Spectra
Feb 02, 2010 | 2004 Infiniti G35 Sport Coupe
Jan 28, 2010 | 2004 Chevrolet Cavalier
May 11, 2009 | Chevrolet Blazer Cars & Trucks
Jan 14, 2009 | 2004 Chevrolet Suburban
17 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: