Question about 2002 Jaguar S-Type

1 Answer

Throttle body code

Cannot clear throddle body cod

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Jaguar Expert
  • 196 Answers

Try a hard reset by unplugging the the battery for a few hours...Also make sure your scanner has the capacity to clear the code ...not all scanner can clear certain codes...

Posted on Apr 15, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2008 trailblazer is acting like it wants to die when it is idling. When I am driving its rpms run high and it starts spuddering.


Sounds like the TPS(Throttle Positioning Sensor) or the IAC(Idle Air Control) is malfunctioning. Sometimes these sensors malfunction because of a dirty throttle body. You should clean the throttle body out with throttle body cleaner first. After cleaning the throttle body out, start the vehicle. It will be slow starting and when it does start it will run rough but after a minute or two it will settle down. You will need to clear the trouble codes. Most major auto parts stores will do this for little or no charge. After clearing the trouble codes drive the vehicle. If the vehicle runs properly, no more is needed. If the vehicle still runs the same as before then continue to drive vehicle until the engine light comes back on. Read the codes and replace the defective sensor.

Mar 05, 2015 | 2008 Chevrolet Trailblazer

1 Answer

Throddle body code


you could have a frayed tbs wire, make sure the connection wire or the two pins that connect tbs connection are in tact.....which code is showing?

Mar 21, 2014 | 2002 Jaguar S-Type

1 Answer

Car won't accelerate


On your dash it says REDUCED ENGINE POWER. Clean your throttle body and reset codes. If codes clear you should be fine if not wiggle and pull on wires at connector for throttle body. The grey one is known to break in the pigtail. Resolder and reset light. A dirty throttle body causes lots of problems

Nov 16, 2013 | 2003 GMC Envoy

3 Answers

87 chevy 350 tbi will only start if if pour gas in the throddle body then keep it running by pumping the peddle. It seems to starve at higher rpms, and when it does idle the rpm's swing from hig


Sounds like the fuel pump is going bad(or in this case,has gone bad). I suggest that you change the fuel pump and use a fuel cleaner in your gas tank as dirty gas may have caused the problem to begin with.

Nov 27, 2012 | Chevrolet Cars & Trucks

1 Answer

Engine stalls under acceleration, shows code P1580, changed throttle body with new one but problem persists


I would worry or be concerned about the code.
The code is about the throttle sensor or actuator. If the sensor is faulty or the computer is not getting a good signal from the sensor it does not know what the throttle position is.
You might try resetting the throttle position - clear the code, key on but don't start, hold pedal to the floor, key off.

Aug 25, 2012 | Cars & Trucks

1 Answer

P1130 code kia serento will not clear using 3 diff scans


P1130 - A "CO Potentiometer" error points to the throttle idle feedback control mounted on the throttle body which would cause all kinds of "idling problems" You can not clear this code and have it go away for good. You will need to clean out the Throttle body and airflow sensors.

Check here for instructions and support. (Kia Forum)

May 23, 2011 | Kia Sorento LX Cars & Trucks

1 Answer

2003 GMC Yukon XL- We have the codes of P0174 and P0171 coming up. We have cleaned the fuel injectors, cleaned the throddle body. Had a new fuel pump put on a year and half ago. When you turn it on, it...


One of the things to look for is a vacuum leak, especially around the throttle body area. Make sure the throttle body gasket is not rolled and is seated properly. also check the PVC hose for leaks.

Sep 13, 2010 | 2003 GMC Yukon XL

1 Answer

Throddle body sticking, bought cleaner for it, where is it located


From your air filter follow that black intake hose to its end, there is a clamp at the end. That's where your throttle body is located, its like a trap door/flap/butterfly. Make sure you are using intake cleaner and a clean rag to spray and wipe clean Open flap can be done by pressing on gas pedal(may need help with this) keep open and spray into throttle body , when this is sticking most of the time the flap/butterfly is very very dirty fully of a black greasy gummy substance. when clean it should return to its original color of metal. Good Luck contact if you need more help

Dec 28, 2008 | 2002 Cadillac Deville

Not finding what you are looking for?
2002 Jaguar S-Type Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...