Back bolts on chysler 300m how do I find them I have open the trunk up and still don't see them
SOURCE: how do you remove the rear seat in a chrysler 300M
Grab the bottom seat cushion at the front of one side and pull it straight up then do the same on the other side. (you will have to pull up very hard) The bottom of the seat clips in. once you have the bottom out take the 2 bolts out of the seat belt fasteners that holds the bottom of the top seat cushion. Then pull straight up on the seat cushion to slide it off two tabs that hold the top.
SOURCE: My trunk lock and release is no longer working in
In my '04 corolla I can unlatch the left passenger seat back by reaching behind the left seat back and sticking my finger up into the second of 3 quarter sized holes. my arm is about 15" stuck in and reaching up into the trunk about 6" back. Feel around for the holes. You can pull the latch at that point, but...you have to be flexible.
SOURCE: took all botls off oil
Every single bolt that holds that pan to the block flange must be removed, so yes the ones in the front and rear. Then you will need to carefully using a putty knife break the seal of the old oil pan gasket, do not damage the pan by prying with a lot of force, take your time and work around the pan flange until it is loose. Once the pan is loose you must have the engine disconnected from the engine mounts and raised as high as you can to clear the oil pump pickup tube inside the oil pan. The pan does not just drop off, you have to work it around to get it off.
SOURCE: THE TRUNK ON MY 1999
MUST REMOVE SEAT BASE BEFORE UNBOLTING SEAT BACK
BASE USUALLY PUSH BACK AND LIFT UPWARDS
SOURCE: sturts
You must remove the rear seat back and package tray to access the bolts at the top of the strut assembly. The rest is done with the vehicle in the raised position. You will need a jack for all systems and may need some special service tools if you have the electronic modulated suspension.
96 views
Usually answered in minutes!
×