Question about 1996 Mazda Protege

1 Answer

Does anyone have a exploded view of a 96 protege iac?

Auto trans, took it apart to clean it, now it wont go back together

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 103 Answers

Should be very simple, but an exploded view is hard to find. Used ones on e-bay are cheap enoug.

Posted on Mar 21, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 96 Mazda protege starts but won't stay running unless I press the gas pedal and it's really cold outside

Clean the throttle body, IAC motor and replace the air filter. This will help.

Feb 01, 2015 | 1996 Mazda Protege

1 Answer

Transmission will not spin

Could be a clog in valve body where the shift solenoids are located. Be careful, it contains metal balls that have to go into the right spot.

Jun 26, 2014 | 1997 Mercury Tracer

1 Answer

High and sporadic idle speed. I just cleaned the IAC valve, put everything back together and now my idle is wack? Any ideas what it might be?

Hello my name is autoteck21 sounds like you dealing with one of two things. #1 Either you have a vacuum leak in one of your hoses or your vacuum box at the worst case one of your vacuum control solenoid. #2 Your idle air control module (under your throttle body.)
To test #1 take a can of brake clean or carb/choke cleaner and in small 2-3in areas spray little spots while engine is running listen too your idle for any changes (you will here the differences) if so there's your leak.
To test #2 find the little connector (2 wire) under your throttle body (when standing in front of your car lower front side under intake pipe hose clamp)

Jan 05, 2012 | 1996 Mazda Protege

2 Answers

96 Ford Explorer is studdering (misfiring) when going up hills

I have the same exact problem that just started immediately AFTER I got a tranny service where they changed the Trans Fluid, Trans Filter, Fuel Filter. Took it back and they say nothing is wrong with it. Took it to the dealer thinking I could get some REAL answers... they just told me to replace spark plugs, wiring & coil, for $900. Only studders when quickly accelerating above 40mph. I've check other forums, they say to clean the Mass Air Flow sensor. Haven't tried it yet. This seems the easiest before replacing spark plugs. Any other suggestions anyone?? Please.....

Oct 23, 2009 | 1996 Ford Explorer

3 Answers

I need a diagram to put rear shoes back on.

Go to register yourself and your vehicle then look around the site until you locate repair guide section, follow the instructions. I'd advise printing every page of instruction and read it first.
One piece of advice - if it's your first time for anything on the vehicle and there's another identicle assembly, take only one (1) apart so you have a sample (hopefully correctly assembled) to refer to.
Good luck
P.S. Let us know how you make out.

Aug 30, 2009 | 2003 Dodge Caravan

1 Answer

96 dodge intrepid auto transmission wont shift up from low .

Iv'e ran across this before, Try this.. unhook the postive Battery terminal for a few minutes then replace. I had the same problem with my intrepid years ago and it took care of it and never had a problem with again! Hope this works for You!

Feb 16, 2009 | 1996 Dodge Intrepid

1 Answer

Trans. problems

when you let off the gas peddle does vehicle roll or slows quickly?

Feb 10, 2009 | 1999 Chevrolet Blazer

1 Answer

Remove and Replace Cylinder Head

If you took pictures of the brackets in question I could assist you better. Also there is always chiltons manuals.

Sep 29, 2008 | 2000 Chevrolet S-10

Not finding what you are looking for?
1996 Mazda Protege Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides