Question about 2004 Ford Freestar

1 Answer

Low heat even after a half hour warm up it still has low heater output. are these freestars notorious for low heat ?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 79,865 Answers

No they are not noted for this type of problem. You may have a sticking air temperature control bleed door and/or a defective blend door actuator stepper motor

Posted on Mar 21, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

455ranger husqvara,i run it till it needs gas,it wont restart till an hour, sometimes it wont restart till next day. Do you know why?


Sounds like just too low compression. This will keep it from starting. Do a compression test and wright down the reading. Remember, when it's warmed up, the heat has made the cylinder expand a bit so the compression is going to be down. If the rings are warn out, that will drop the compression even more when it's warm. Fence the no start when warm.

Oct 28, 2017 | Cars & Trucks

1 Answer

No immediate heat


Check the fluid level in your radiator reservoir. Mine was doing the same thing and I found mine was very low. Filled it up and the heat came on through.

Dec 28, 2012 | 2005 Nissan Frontier

2 Answers

2005 Freestar, squeal noise and sometime van goes dead.


Replace your cam positioning syncronizer head same problem squealing was coming from around alternator water pump area which is exactly where the cam positioning sensor is located not hard to do I did mine in a garage and it took about four hours

Mar 07, 2012 | 2005 Ford Freestar

1 Answer

1999 expedition- After driving for a half hour or so the engine smells like a faint burning smell but the temp. gauge inside reads normal. I also can not get any hot air to come out with the heater on even...


No heat usually means low water level in radiator. Check your plastic surge tank to see if is at the proper level. When engine is cool check actual level in radiator.

For smell check to see if any oil is weeping from top engine gasket and dripping onto exhaust manifold, You should be able to check with flashlight while engine is idling.

Nov 23, 2010 | 1999 Ford Expedition

1 Answer

At high speed engine temperature is Ok, at low speed or idle it warms up to over half way and the coolant level warning light comes on. There is plenty of coolant, an new water pump and a new thermostat....


is cooling fan coming on?? the coolant level light pertains to a sensor that is in radiator side tank that is notorious for going bad you may have two seperate problems normal temp at high speed tells me the wind passing across radiator is keeping cool when stopped or in traffic as temp increases pcm commands fan to come on if it does,nt you will heat up

Mar 19, 2010 | 2000 Oldsmobile Silhouette

1 Answer

Hi, My 2001 A6 has a problem blowing hot air through the blower. it starts to some what warm up after the gauge shows the engine temp at half but if i speed off on the high way for a little bit or even...


your thermostat is stuck open ive changed a few of them and it is very labor intensive the part is like 20 bucks but the front of the car has to be removed to change it the fastest i can do it is 4 hours the first one i changed took 7 hours. thats why the dealership wants so much they do already know whats wrong its a common problem.

Feb 08, 2010 | 1996 Audi A4

1 Answer

No heat


The 3400 is notorious of the head gaskets blowing. this may not be in your case. Check the level of the coolant. Their may be air in the heater core. bring it up to operating temp then check the level.

Hope it is just air in the system not the heads!

Dec 29, 2008 | 1999 Pontiac Grand Am GT

1 Answer

1991 Toyota 4x4, 4 cyl. engine. Surges when coolant level is low, even though it has not yet heated up.


your carb has a coolant heated choke system if i am correct as car warms up the coolant warms the choke spring. keep full of coolant to keep from other damage

Aug 20, 2008 | 2004 Toyota Corolla

Not finding what you are looking for?
2004 Ford Freestar Logo

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...