Question about 1991 Audi 80

2 Answers

Starting problem can pull start the car no problem ,butwith the key the emngine just turns over

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Audi Master
  • 51,255 Answers

Have a load test done on the battery as there appears that there is insufficient current to start and supply to the ignition at the same time . Possible dead cell

Posted on Mar 21, 2014

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.


    An expert who has answered 20 questions.


    An expert that has over 10 points.

  • Contributor
  • 29 Answers

Check first your battery if in good condition. Check this site for more information on car problem diagnosis it might help.
All About Car Diagnosis

Posted on Mar 22, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Key wont turn to start car

try pulling on the steering wheel pretty hard. sometimes it locks and wont let the key turn.

Jan 09, 2016 | 1998 Buick LeSabre

1 Answer

Does the emobilizer and key have to be replaced if the wrong key was put in ignition and had to be pulled and wiggled pretty hard to remove now it wont start

When you turn the ignition switch to ON(II), the immobilizer system indicator should come on for a few seconds, then go out. If the indicator starts to blink, it means the system does not recognize the coding of the key. Turn the ignition switch to LOCK(0), remove the key, reinsert it, and turn the switch to ON(II) again.If the system repeatedly does not recognize the coding of your key will need a repair.

Dec 03, 2015 | 2000 Acura Integra

1 Answer

Pontiac grandam 2000 key will not turn to start car wheel unlocked

Pull the steering wheel hard to the left and try turning the key at the same time.

Feb 08, 2015 | Pontiac Cars & Trucks

1 Answer

Wont start

the clicking noise is usually 2 things, step on try jump starting car and if starts have battery tested as it is probably bad (free testing at most chain auto stores), the other usual problem is that the starter has gone bad, when whoever tried turning off car while driving might have put into start mode and burnt out the starter when it engaged at high speed.

Jun 09, 2012 | 1998 Ford Taurus

1 Answer

When i turn the ignition key over the 1994 gmc suburban will not start. then when i turn the ignition key over again the vehicle will start with no problem. i dont do anything between turning the key over....

Neutral Safety Switch ? located at the bottom of the steering column. Mine is tricky, have to pull the shift lever while turning over to get it started. happened after i replaced ignition switch & Neutral Safety Switch

Aug 20, 2011 | 1994 GMC Suburban

1 Answer

Can not turn key. pulled in driveway turned wheelswent to start car and the key will not turn. 2001 town car

to get the key to turn you will have to carry out some steps! if the steering lock is on you will need to rock the steering wheel while trying to turn the key, as your turning the key put some pressure on it to remove it at the same time, in other words your putting pressure on the key to turn to the on position and trying to free up the tumblers at the top of the barrel, by pulling it out, stick too it, it may take some work, when you get it to the on position and started, DONT PULL IT OUT UNTIL YOU GET IT FIXED disconnect the battery every day if you have to otherwise you'll have to do it again

Oct 04, 2010 | Lincoln Town Car Cars & Trucks

1 Answer

Car won't start. Turn the key on and all lights

Try boosting the car,if it always starts then you either need a battery or you need to clean your cable ends.If this does nothing for you then replace the starter relay.

Nov 05, 2009 | 2001 Oldsmobile Intrigue

2 Answers


This is a simple fix.  Either the key is worn and you need a new key cut, or your ignition switch is worn and you need to replace it. Personally, I would start with a new key.  Before spending any money, try pulling on the steering wheel a little in both directions while turning the key.  I have seen steering locks prevent the key from turning on older cars.

Dec 21, 2008 | 1992 Toyota Camry V6

Not finding what you are looking for?
1991 Audi 80 Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

80531 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14417 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides